Recent progress in high-bit-rate applications of four-wave-mixing in SOAs

Non-linearities in semiconductor optical amplifiers have been used to demonstrate a wide range of functions applicable to future optical networks such as wavelength conversion and optical switching. Four-wave-mixing effects in SOAs have been studied extensively in many laboratories with respect to the underlying physical processes and system applications. At BT Labs an optimization of SOAs for FWM has been achieved by altering the device active layer composition and by increasing the device length. We will review recent progress at BT Labs in dispersion compensation, wavelength conversion and demultiplexing at bit-rates of 40 Gbit/s using these devices.

The effect of an upstream turbine on a low-aspect ratio vane

The interaction between a high-pressure rotor and a downstream vane is dominated by vortex-blade interaction. Each rotor blade passing period two co-rotating vortex pairs, the tip-leakage and upper passage vortex and the lower passage and trailing shed vortex, impinge on, and are cut by, the vane leading edge. In addition to the streamwise vortex the tip-leakage flow also contains a large velocity deficit. This causes the interaction of the tip-leakage flow with a downstream vane to differ from typical vortex blade interaction. This paper investigates the effect these interaction mechanisms have on a downstream vane. The test geometry considered was a low aspect ratio second stage vane located within a S-shaped diffuser with large radius change mounted downstream of a shroudless high-pressure turbine stage. Experimental measurements were conducted at engine-representative Mach and Reynolds numbers, and data was acquired using a fast-response aerodynamic probe upstream and downstream of the vane. Time-resolved numerical simulations were undertaken with and without a rotor tip gap in order to investigate the relative magnitude of the interaction mechanisms. The presence of the upstream stage is shown to significantly change the structure of the secondary flow in the vane and to cause a small drop in its performance.

Recent progress in high-bit-rate applications of four-wave-mixing in SOAs

Non-linearities in semiconductor optical amplifiers have been used to demonstrate a wide range of functions applicable to future optical networks such as wavelength conversion and optical switching. Four-wave-mixing effects in SOAs have been studied extensively in many laboratories with respect to the underlying physical processes and system applications. At BT Labs an optimisation of SOAs for FWM has been achieved by altering the device active layer composition and by increasing the device length. We will review recent progress at BT Labs in dispersion compensation, wavelength conversion and demultiplexing at bit-rates of 40Gbit/s using these devices.

Unsteady ejectors: The effect of driver jet mark-space ratio

mark Unsteady ejectors can be driven by a wide range of driver jets. These vary from pulse detonation engines, which typically have a long gap between each slug of fluid exiting the detonation tube (mark-space ratios in the range 0.1-0.2) to the exit of a pulsejet where the mean mass flow rate leads to a much shorter gap between slugs (mark-space ratios in the range 2-3). The aim of this paper is to investigate the effect of mark-space ratio on the thrust augmentation of an unsteady ejector. Experimental testing was undertaken using a driver jet with a sinusoidal exit velocity profile. The mean value, amplitude and frequency of the velocity profile could be changed allowing the length to diameter ratio of the fluid slugs L/D and the mark-space ratio (the ratio of slug length to the spacing between slugs) L/S to be varied. The setup allowed L/S of the jet to vary from 0.8 to 2.3, while the L/D ratio of the slugs could take any values between 3.5 and 7.5. This paper shows that as the mark-space ratio of the driver jet is increased the thrust augmentation drops. Across the range of mark-space ratios tested, there is shown to be a drop in thrust augmentation of 0.1. The physical cause of this reduction in thrust augmentation is shown to be a decrease in the percentage time over which the ejector entrains ambient fluid. This is the direct result ofthe space between consecutive slugs in the driver jet decreasing. The one dimensional model reported in Heffer et al. [1] is extended to include the effect of varying L/S and is shown to accurately capture the experimentally measured behavior ofthe ejector. Copyright © 2010 by the American Institute of Aeronautics and Astronautics, Inc.