Macro-geographical differences influenced by family-based expression on cultured pearl grade, shape and colour in the black-lip "pearl oyster" Pinctada margaritifera: a preliminary bi-local case study in French Polynesia

In French Polynesia, the aquaculture of P. margaritifera is carried out in numerous grow-out sites, located over three archipelagos (Gambier, Society and Tuamotu). To evaluate the impact of macro-geographical effects of these growing sites on pearl quality traits, five hatcheries produced families were used as homogeneous donor oysters in an experimental graft. The molluscs were then reared in two commercial locations: Tahaa island (Society) and Rangiroa atoll (Tuamotu). At harvest, eight pearl quality traits were recorded and compared: surface defects, lustre, grade, circles, shape categories, darkness level, body and secondary colour and visual colour categories. Overall inter-site comparison revealed that: 1) all traits were affected by grow-out location except for lustre and round shape, and 2) a higher mean rate of valuable pearls was produced in Rangiroa. Indeed, for pearl grade, Rangiroa showed twice as many A-B and less reject samples than Tahaa. This was related to the number of surface defects (grade component): in Rangiroa, twice as many pearls had no defects and less pearls had up to 10 defects. Concerning pearl shape, more circled and baroque pearls were found in Tahaa (+10%). For colour variation, 10% more pearls have an attractive green overtone in Rangiroa than in Tahaa, where more grey bodycolor were harvested. Lustre does not seem to be affected by these two culture site (except at a family scale). This is the first time P. margaritifera donor family have been shown to vary in the quality of pearls they produce depending on their grow-out location.

Swath bathymetry using phase difference: Theoretical analysis of acoustical measurement precision

The phase difference principle is widely applied nowadays to sonar systems used for sea floor bathymetry, The apparent angle of a target point is obtained from the phase difference measured between two close receiving arrays. Here we study the influence of the phase difference estimation errors caused by the physical structure of the backscattered signals. It is shown that, under certain current conditions, beyond the commonly considered effects of additive external noise and baseline decorrelation, the processing may be affected by the shifting footprint effect: this is due to the fact that the two interferometer receivers get simultaneous echo contributions coming from slightly shifted seabed parts, which results in a degradation of the signal coherence and, hence, of the phase difference measurement. This geometrical effect is described analytically and checked with numerical simulations, both for square- and sine-shaped signal envelopes. Its relative influence depends on the geometrical configuration and receiver spacing; it may be prevalent in practical cases associated with bathymetric sonars. The cases of square and smooth signal envelopes are both considered. The measurements close to nadir, which are known to be especially difficult with interferometry systems, are addressed in particular.

Tidal Energy ”Round Robin” Tests Comparisons between towing tank and circulating tank results

One key step of the industrial development of a tidal energy device is the testing of scale prototype devices within a controlled laboratory environment. At present, there is no available experimental protocol which addresses in a quantitative manner the differences which can be expected between results obtained from the different types of facilities currently employed for this type of testing. As a consequence, where differences between results are found it has been difficult to confirm the extent to which these differences relate to the device performance or to the test facility type. In the present study, a comparative ”Round Robin” testing programme has been conducted as part of the EC FP VII MaRINET program in order to evaluate the impact of different experimental facilities on the test results. The aim of the trials was to test the same model tidal turbine in four different test facilities to explore the sensitivity of the results to the choice of facility. The facilities comprised two towing tanks, of very different size, and two circulating water channels. Performance assessments in terms of torque, drag and inflow speed showed very similar results in all facilities. However, expected differences between the different tank types (circulating and towing) were observed in the fluctuations of torque and drag measurements. The main facility parameters which can influence the behaviour of the turbine were identified; in particular the effect of blockage was shown to be significant in cases yielding for high thrust coefficients, even at relatively small blockage ratios.