In situ Lithium and Boron isotope determinations in mica, pyroxene, and serpentine by LA-MC-ICP-MS

Boron and Li are light, incompatible elements that preferentially partition into the liquid phase, whether melt or aqueous fluid, and thus are useful for tracking fluid-related processes in rocks. Most of the Li isotopic data presently available on subduction-related rocks are from whole-rock analyses; and the B isotopic analyses of subduction material have been carried out either on whole-rocks or in-situ on an accessory phase, such as tourmaline. The new method presented here couples an ESI New Wave UP-193-FX ArF* (193 nm) excimer laser-ablation microscope with a Neptune Plus (Thermo Scientific) MC-ICP-MS aiming to measure both Li and B isotopes in situ with good spatial resolution (metamorphic minerals are commonly chemically zoned, and whole-rock analyses lose this detail). The data thus obtained are compared with SIMS analyses on the same mineral samples for B, and with MC-ICP-MS analyses on whole-rock or mineral separates from the same sample for Li. Additionally, data acquired on tourmaline standards were compared to SIMS values. The results show that for B concentrations above 5 μg/g, the data obtained by LA-MC-ICP-MS and by SIMS are identical within error, for mica (phengitic muscovite), pyroxene (jadeite), serpentine (antigorite), and tourmaline. For Li concentrations above 10 μg/g, the data obtained by LA-MC-ICP-MS and by MC-ICP-MS are also identical, within error, for mica (phengitic muscovite), and pyroxene (jadeite). However, analyses of tourmaline standards have shown significant differences with reference values, so LA-MC-ICP-MS does not yet appear to be an appropriate method to analyze Li isotopes in tourmalines. Thus, LA-MC-ICP-MS is a suitable method to measure Li and B isotopes with good spatial resolution in major rock-forming silicates from subduction-related rocks where concentrations exceed 10 μg/g and 5 μg/g, respectively, with an error on individual measurements equal to or less than previously used methods, but obtainable in a significantly shorter amount of time. The external reproducibility is ± 2.88 to 3.31 ‰ for B and ± 1.50 to 1.75 for Li, which is lower than or equal to the variations encountered within a given chemically zoned sample (up to 10 ‰ of variation within a given natural sample).

Intraplate versus ridge volcanism on the Pacific-Antarctic Ridge near 37°S -111°W

Exploration of the Foundation Volcanic Chain (33 degrees S-131 degrees W; 37 degrees S-111 degrees W) revealed the existence of different magmatic provinces with relation to their geological settings. (1) The Pacific-Antarctic Ridge (PAR) is made up of several en echelon segments where both glassy midocean ridge basalts (MORBs) with low incompatible elements (K2O<200 ppm, Zr<120 ppm and Ce <20 ppm) as well as andesites and dacites have erupted, (2) Oblique Ridges located up to 300 lan from the PAR axis are topped with seamounts made up essentially of transitional (T) and enriched (E) MORBs with intermediate incompatible elements (K2O=0.11-0.40 %, Zr=70-140 ppm and Ce=15-30 ppm), (3) the Foundation Seamounts (FS) consisting essentially of isolated volcanoes which have erupted alkalic lavas (alkali basalt, trachybasalt and trachyandesite) with high incompatible elements (K2O (0.50-1.1 %, Zr (>150 ppm) and Ce (>48 ppm)) at about 306-1300 km from the PAR axis, (4) The Old Pacific Seamounts built on a crust older than 23 m. y. located west of longitude 124 degrees W (> 1300 km from the PAR axis) consist of T and EMORB. On the PAR axis, extensive crystal fractionation (>65%) produced the silicic lavas. On the basis of Pacific plate reconstruction using a half spreading rate of about 50 mm/yr and integrating the observed compositional changes with respect to the structural settings, it is inferred that the last volcanic events giving rise to the FS took place at about 110 km from the PAR axis about 5 m. y. ago. The Oblique Ridges built between 5 m. y. and <1 m. y. are believed to represent ancient leaky transforms and/or large discontinuities between accreting ridge segments filled by volcanic cones during the interaction (mixing) of the enriched plume components of the FS with PAR depleted (MORB type) magmatism. The Old Pacific Seamounts built on ancient crust (>23 m. y.) with MORB volcanics comparable to those of the the Oblique Ridge-PAR provinces, could also have been formed by an interaction between the Foundation Seamount (dredge site 28) hotspot magmatism and that of an ancient accreting ridge magmatism precursor of the PAR.