Nutrient fluxes on an intertidal mudflat in Marennes-Oleron Bay, and influence of the emersion period

Fluxes of nutrients (NH sub(4) super(+), NO sub(3) super(-), PO sub(4) super(3-) and Si(OH) sub(4)) were studied on an intertidal mudflat in Marennes-Oleron Bay, France, at two different seasons and at different times of the emersion period. Fluxes through the sediment-water interface were both calculated from vertical profiles of nutrient concentration in pore-water (diffusive fluxes, JD) and measured in light and dark benthic mini-chambers (measured fluxes, J sub(0)). Results indicate that ammonia was mainly released in summer while nitrate was mainly taken up in late winter. This uptake from the overlying water was probably due to the coupling of nitrification-denitrification within the sediment. The J sub(0) /J sub(D) ratio further indicates that bioturbation likely enhanced ammonia release in summer. Concerning phosphate, the comparison of diffusive and measured fluxes suggests that PO sub(4) super(3-) could be assimilated by the biofilm in winter while it was released in summer at a high rate due to both bioturbation and desorption because of the relative summer anoxic conditions. Silica was always released by the sediment, but at a higher rate in summer. Statistically significant differences in measured fluxes were detected in dark chambers at different times of low tide, thus suggesting a short-term variability of fluxes. Microphytobenthos preferred ammonia to nitrate, but assimilated nitrate when ammonia was not available. It also turned out that benthic cells could be limited in nitrogen during low tide in late winter. In summer, ammonia was not limiting and microphytobenthic activity significantly decreased the measured flux of NH sub(4) super(+) in the middle of low tide when its photosynthetic capacity was highest.

CATARINA 2012-Leg 1 - CTD-O2 Data report

The CATARINA Leg1 cruise was carried out from June 22 to July 24 2012 on board the B/O Sarmiento de Gamboa, under the scientific supervision of Aida Rios (CSIC-IIM). It included the occurrence of the OVIDE hydrological section that was performed in June 2002, 2004, 2006, 2008 and 2010, as part of the CLIVAR program (name A25) ), and under the supervision of Herlé Mercier (CNRSLPO). This section begins near Lisbon (Portugal), runs through the West European Basin and the Iceland Basin, crosses the Reykjanes Ridge (300 miles north of Charlie-Gibbs Fracture Zone, and ends at Cape Hoppe (southeast tip of Greenland). The objective of this repeated hydrological section is to monitor the variability of water mass properties and main current transports in the basin, complementing the international observation array relevant for climate studies. In addition, the Labrador Sea was partly sampled (stations 101-108) between Greenland and Newfoundland, but heavy weather conditions prevented the achievement of the section south of 53°40’N. The quality of CTD data is essential to reach the first objective of the CATARINA project, i.e. to quantify the Meridional Overturning Circulation and water mass ventilation changes and their effect on the changes in the anthropogenic carbon ocean uptake and storage capacity. The CATARINA project was mainly funded by the Spanish Ministry of Sciences and Innovation and co-funded by the Fondo Europeo de Desarrollo Regional. The hydrological OVIDE section includes 95 surface-bottom stations from coast to coast, collecting profiles of temperature, salinity, oxygen and currents, spaced by 2 to 25 Nm depending on the steepness of the topography. The position of the stations closely follows that of OVIDE 2002. In addition, 8 stations were carried out in the Labrador Sea. From the 24 bottles closed at various depth at each stations, samples of sea water are used for salinity and oxygen calibration, and for measurements of biogeochemical components that are not reported here. The data were acquired with a Seabird CTD (SBE911+) and an SBE43 for the dissolved oxygen, belonging to the Spanish UTM group. The software SBE data processing was used after decoding and cleaning the raw data. Then, the LPO matlab toolbox was used to calibrate and bin the data as it was done for the previous OVIDE cruises, using on the one hand pre and post-cruise calibration results for the pressure and temperature sensors (done at Ifremer) and on the other hand the water samples of the 24 bottles of the rosette at each station for the salinity and dissolved oxygen data. A final accuracy of 0.002°C, 0.002 psu and 0.04 ml/l (2.3 umol/kg) was obtained on final profiles of temperature, salinity and dissolved oxygen, compatible with international requirements issued from the WOCE program.