Development of a torque meter for fishing vessels

The paper describes the development of an electronic instrument to measure the torque developed on the propeller shaft of fishing vessels at various speeds of the propeller. By measuring the torque, it is possible to determine the actual power transmitted from the engine gear-box unit to the propeller so that propeller efficiency can be evaluated and the optimum size of the propeller for a specific engine and vessel can be determined.

Leistungsmessung an Bord von Fischereifahrzeugen zur Kontrolle der 300-PS-Begrenzung in der Schollenbox

For monitoring of the engine power of fishing vessels permitted for fishery in the plaice box with engine power of 300 HP or less at sea three different portable power measurement systems are developed and tested. A system measuring the twist of the propeller shaft by two divisible gearwheels mounted on the shaft worked well at shafts with roller bearing at both sides of the measured interval of 100–300 mm length. Only at a very few fishing vessels this system is applicable and therefore for monitoring purposes not suitable. The application of a commercial available system measuring the stress at the surface of the shaft was simplified for application by non experts. The torque is measured by strain gauges. The calibration of the system, measuring and recording of the power is done by a PC automatically. A small polished facet on the shaft protected against oxidation is needed for easy and quick application. In this case the system can be used by technical personnel of supervision boats for monitoring of the engine power at sea in a short time. A third power measurement system determinates the torque by measuring the displacement of two supports clamped on the shaft at a distance of 100 mm. The displacement is measured by a micrometer gauge mounted on one of the supports. Readout of the rotating gauge display is possible taking advantage of stroboscopic effect. The system needs no conditioning of the shaft and can be used by non technicians. The development is not finished until now and some additional investigations and tests are required. Additional measures for monitoring of the power on fishing vessels by self recording power measurement systems and sealed fuel racks with limited injection are reported and discussed.

Cypermethrin use in forestry and its impact on Welsh streams: An evaluation of the impact of cypermethrin use in forestry on Welsh streams

This is the Evaluation of the impact of cypermethrin use in forestry on Welsh streams from the University of Plymouth, published on September 2010 by the Environment Agency South West. The report focuses attention on Cypermethrin, a highly active synthetic pyrethroid insecticide effective against a wide range of pests in agriculture, public health, and animal husbandry. It is also used in forestry to control the pine weevil, Hylobius abietis. Cypermethrin is very toxic to aquatic invertebrates and fish at nanogram per litre concentrations. This project checks the effectiveness of current best practice measures in minimising the risk of pollution associated with the use of cypermethrin in forestry in Wales. Chemical results from the intensive studies show that cypermethrin entered minor watercourses draining treated areas at two of the eight sites. In one of these cases the level was well in excess of the short-term Predicted No Effect Concentration. The absence of a buffer area at the other site resulted in the cypermethrin reaching a main drain. However dilution appeared to be sufficient to prevent any impact on water quality or on the invertebrate community in the main stream. Invertebrate and chemical data from the extensive survey showed little evidence of pollution due to wider use of cypermethrin in Welsh forestry. Finally, a number of recommendations are made for further tightening controls on forestry practice to minimise the risk of cypermethrin entering the aquatic environment.