Experimente über die Wirkung von UV-B auf pelagische Fischembryonen in einem Sonnenscheinsimulator

One of the supposed effects of the observed ozone depletion is the increase of solar UV-B irradiation at the seasurface. This will cause an impact on certain compartments of marine ecosystems. Especially, sensitive developmental stages of pelagic fish embryos might be affected. Embryos of dab (Limanda limanda) and plaice (Pleuronectes plalessa) were experimentally exposed 10 different amounts of UVB irradiation in a sunshine simulator. This programmable device allows the dosage of realistic solar irradiation in quality and guantity. Experiments were carried out in March 1995 and February 1996. Either artificially inserninated and reared emhryos of dab and plaice or embryos caught in the German Bight were exposed to simulated solar irradiation. The 1995 experiments served to identify the effective irradiation dosages. For the 1996 experiments irradiation applied was much lower, being dose to realistic valucs expected over the North Sea as a consequence of ozone depletion. The following end points were studied: 1. Mortality, 2. sublethal morphological effects (malformations), 3. DNA damage, 4. changes in buoyancy of embryos measured as changes in osmolarity of the perivitelline fluid. Conditions for the simulation of daylight were a c1oudless sky with a solar zenith distance of 34 % (air mass 1.2). The adopted ozone depletion was 40 % corresponding to 180 DU (Dobson Units) instead of 300 DU. In the 1995 experiments time and dosage dependent influenccs on mortality and buoyancy of embryos of dab and plaice were found. Even in those embryos which were protected from the UV-B spectral range a loss of buoyancy was registered after 12 hours in the simulator. No diffcrences in DNA integrity as determined by DNA unwinding of exposed and control embryos were found. Also with lower amounts of irradiation in the 1996 experiments dosage dependent acute mortality, malformations, and impact on the buoyancy of the emhryos was registered. Sublethal effects occurred as well in embryos protected against UV-B in the exposure chambers, but were not found in the dark controls. The impact of low dosages of UV-B on the buoyancy of pelagic fish embryos might indicate an important ecological threat and deserves further studies.

Sperm cryopreservation of Indian major carp, Labeo rohita: cryodiluents, sperm: cryodiluent dilution ratio and cryoprotectan t concentration

Cryogenic preservation trials of spermatozoa of Labeo rohita were carried out. Twenty four cryodiluents (extender + cryoprotectant), with the combination of six extenders such as egg-yolk citrate, urea-egg-yolk, 0.9% NaCl, Kurokura-2, Ma and Mb and four cryoprotectants viz. DMSO, glycerol, methanol and ethanol, were used to screen out the suitable cryodiluents. Sperm was preserved in 0.25ml plastic straw in programmable freezer. Two step freezing method was followed. Sperm preserved with egg-yolk citrate and urea-egg-yolk containing 10% DMSO showed best post-thaw motility (80%) followed by 0.9% NaCl (60%) and Kurokura-2(30%) solutions. Sperm with the extenders M" and Mb clotted at the time of equilibration and also after few days of preservation. Egg-yolk citrate mixed with ethanol and methanol also showed good percentage of motility (80%) but egg-yolk citrate with glycerol showed less sperm motility (>60%). To determine suitable dilution ratio of milt and cryodiluent two best extender eggyolk citrate and urea-egg-yolk with four cryoprotectants such as DMSO, glycerol, methanol and ethanol at different ratio viz 1:2,1:4,1:7,1:10,1:15 and 1:20 were used. Highest post-thaw motility (>80%) was observed when milt was preserved with egg-yolk citrate containing 10% DMSO at 1:2, 1:4, 1:7 and 1:10 dilutions. Meanwhile using glycerol as cryoprotectants provided less post thaw motility at lower dilution ratio but with the increase of its dilution showed good sperm motility compared with other cryoprotectants. Finally, evaluation on the effect of cryoprotectant concentration on post-thaw sperm motility was conducted. Egg-yolk citrate and four cryoprotectant i.e. DMSO, glycerol, methanol and ethanol with six different concentrations namely 5%,7%, 10%, 15%, 20% and 30%.were evaluated. Among the cryoprotectants DMSO, methanol and ethanol showed highest post-thaw motility (about 80%) at 7% and 10% concentrations. Although glycerol was not suitable at low concentration but its 20% and 30% concentration levels provided best post-thaw motility. No post-thaw motility was obtained with DMSO at 30% concentration. The overall analysis on cryoprotectant concentration indicated that below 5% and above 20% cryoprotectant concentrations could not be suitable for effective cryopreservation of spermatozoa.

Design and construction of a two dimensional duct equipped with a wave generator and a variable coastal slope and an ocean wave energy conversion system (OWC)

The aims of this thesis were evaluation the type of wave channel, wave current, and effect of some parameters on them and identification and comparison between types of wave maker in laboratory situations. In this study, designing and making of two dimension channels (flume) and wave maker for experiment son the marine buoy, marine building and energy conversion systems were also investigated. In current research, the physical relation between pump and pumpage and the designing of current making in flume were evaluated. The related calculation for steel building, channels beside glasses and also equations of wave maker plate movement, power of motor and absorb wave(co astal slope) were calculated. In continue of this study, the servo motor was designed and applied for moving of wave maker’s plate. One Ball Screw Leaner was used for having better movement mechanisms of equipment and convert of the around movement to linear movement. The Programmable Logic Controller (PLC) was also used for control of wave maker system. The studies were explained type of ocean energies and energy conversion systems. In another part of this research, the systems of energy resistance in special way of Oscillating Water Column (OWC) were explained and one sample model was designed and applied in hydrolic channel at the Sheikh Bahaii building in Azad University, Science and Research Branch. The dimensions of designed flume was considered at 16 1.98 0. 57 m which had ability to provide regular waves as well as irregular waves with little changing on the control system. The ability of making waves was evaluated in our designed channel and the results were showed that all of the calculation in designed flume was correct. The mean of error between our results and theory calculation was conducted 7%, which was showed the well result in this situation. With evaluating of designed OWC model and considering of changes in the some part of system, one bigger sample of this model can be used for designing the energy conversion system model. The obtained results showed that the best form for chamber in exit position of system, were zero degree (0) in angle for moving below part, forty and five (45) degree in front wall of system and the moving forward of front wall keep in two times of height of wave.