Mollusks taken by Beam Trawl in the vicinity of Gray's Reef National Marine Sanctuary on the Continental Shelf off Georgia, Southeastern U.S.

Mollusks were sorted from samples of shell hash (obtained as bycatch during NOAA-sponsored studies of larval and juvenile fish distribution), and analyzed to gain qualitative insights on species composition, distribution and habitat affinities of the molluscan fauna on the continental shelf off Georgia. Samples came from beam trawls at 37 stations located in the immediate vicinity and offshore of the Gray’s Reef National Marine Sanctuary (GRNMS) at depths of 4.9 to 103 m. Two hundred sixty-three (263) taxa of mollusks (~58% as dead shells only) were collected, and nearly all (~99%) were identified to the species level. Ninety-seven of these taxa appeared in samples from one or more of the four stations established near the corners of the GRNMS. Samples were highly variable in terms of appearance, volume and species composition of mollusks, reflecting the extreme patchiness of benthic habitats within this region of the continental shelf. With very few exceptions, the mollusks were generally characteristic of either the Carolinian or Caribbean faunal provinces. The Georgia continental shelf, however, was outside the previously reported ranges for at least 16 of the species reported here. Most of these extralimital species were known previously from the East Coast of Florida, and represented northerly range extensions of 1-5° Latitude (110-560 km). One species represented a more significant range extension from the Bahamas and the southern Caribbean, and two represented southerly range extensions, known previously from only as close as off North Carolina. The high incidence of range extensions found in this study and the potential for discovery of additional species are discussed in the context of the diversity and patchiness of benthic habitats on the continental shelf of the region, and the sensitivity of species recruitment to variability in Gulf Stream patterns and global climate change. (PDF contains 52 pages)

Mellum Island (southern North Sea): dynamic processes and sedimentary structures. I. Southern tidal flat, transition zone and high-surface.[p.72 (Blasensand) only][Translation from: Senckenbergiana Maritima 11, 59-113, 1979]

This partial translation of a longer article describes the phenomenon of ”Blasensand”. Blasensand is formed when sedimentation of dried out sand is suddenly flooded from above. A more detailed explanation of Blasensand is given in this translated part of the paper.

The extent of the rearrangement of material in Neuwerk/Scharhom flat [Translation from: Hamburger Kuestenforschung 33, 1-24 [p23 only], 1975]

Investigations of the rearrangement of material in Neuwerk/Scharhom flat showed that with the exception of the western border/edge and the parts of the Elbe and Oste shores/banks which lie most seawards, the entire mudflat area is only infrequently exposed to strong hydraulic forces. Only in extreme conditions, which on average occur rarely more than once a year, would the mudflats be severely affected. This partial translation provides the summary of the original article only.

Distribution patterns of tidepool fishes on a tropical flat reef

Rockpools on a tropical f lat reef off the southeastern coast of Brazil were sampled to determine the influence of pool morphometry and water characteristics on fish community structure. The pool closest to the inner fringe of the reef had lower salinity and higher temperature due to inflow of groundwater. The other pools varied only with respect to their morphometric characteristics, algal cover, and bottom composition. Species with a strong affinity for estuarine- like waters characterized the pool closest to the beach and distinguished its fish community from that of the other pools. Instead of being strongly structured by the physicochemical setting and position in the reef, fish communities of the other pools were determined by behavioral preferences and intra- and interspecific interactions. Differences in community structure were related to pool size (the larger sizes permitting the permanency of schooling species), to algal cover (which allowed camouflage for large predatory species), to bottom composition (which provided substrate for turf flora available to territorial herbivores), and to ecological effects (e.g., competition, territoriality, and predation). Although distribution patterns of tidepool fishes have previously been related to the availability of niches, independent of pool position in the reef, our results show synergistic interactions between water properties, presence or absence of niches, and ecological relationships in structuring tidepool fish communities.

The relationships between fish assemblages and the amount of bottom horizontal beam exposed at California oil platforms: fish habitat preferences at man-made platforms and (by inference) at natural reefs

Between 1995 and 2002, we surveyed fish assemblages at seven oil platforms off southern and central California using the manned research submersible Delta. At each platform, there is a large horizontal beam situated at or near the sea floor. In some instances, shells and sediment have buried this beam and in other instances it is partially or completely exposed. We found that fish species responded in various ways to the amount of exposure of the beam. A few species, such as blackeye goby (Rhinogobiops nicholsii), greenstriped rockfish (Sebastes elongatus), and pink seaperch (Zalembius rosaceus) tended to avoid the beam. However, many species that typically associate with natural rocky outcrops, such as bocaccio (S. paucispinis), cowcod (S. levis), copper (S. caurinus), greenblotched (S. rosenblatti), pinkrose (S. simulator) and vermilion (S. miniatus) rockfishes, were found most often where the beam was exposed. In particular, a group of species (e.g., bocaccio, cowcod, blue (Sebastes mystinus), and vermilion rockfishes) called here the “sheltering habitat” guild, lived primarily where the beam was exposed and formed a crevice. This work demonstrates that the presence of sheltering sites is important in determining the species composition of man-made reefs and, likely, natural reefs. This research also indicates that adding structures that form sheltering sites in and around decommissioned platforms will likely lead to higher densities of many species typical of hard and complex structure.

Gear modifications for fishing octopus, Octopus vulgaris, on live-bottom and adjacent flat bottom habitats in coastal waters off North Carolina

The Common Octopus, Octopus vulgaris, is an r-selected mollusk found off the coast of North Carolina that interests commercial fishermen because of its market value and the cost-effectiveness of unbaited pots that can catch it. This study sought to: 1) determine those gear and environmental factors that influenced catch rates of octopi, and 2) evaluate the feasibility of small-scale commercial operations for this species. Pots were fished from August 2010 through September 2011 set in strings over hard and sandy bottom in waters from 18 to 30 m deep in Onslow Bay, N.C. Three pot types were fished in each string; octopus pots with- and without lids, and conch pots. Proportional catch was modeled as a function of gear design and environmental factors (location, soak time, bottom type, and sea surface water temperature) using binomially distributed generalized linear models (GLM’s); parsimony of each GLM was assessed with Akaike Information Criteria (AIC). A total of 229 octopi were caught throughout the study. Pots with lids, pots without lids, and conch pots caught an average of 0.15, 0.17, and 0.11 octopi, respectively, with high variability in catch rates for each pot type. The GLM that best fit the data described proportional catch as a function of sea surface temperature, soak time, and station; greatest proportional catches occurred over short soak times, warmest temperatures, and less well known reef areas. Due to operating expenses (fuel, crew time, and maintenance), low catch rates of octopi, and high gear loss, a directed fishery for this species is not economically feasible at the catch rates found in this study. The model fitting to determine factors most influential on catch rates should help fishermen determine seasons and gear soak times that are likely to maximize catch rates. Potting for octopi may be commercially practical as a supplemental activity when targeting demersal fish species that are found in similar habitats and depth ranges in coastal waters off North Carolina.

Developmental characters of Psettina Iijimae (Jordan and Starks), bothid flat fishes - Pisces

Post larval stages of Psettina Iijimae ranging from 1.8 mm NL to 44.6 mm SL collected during Naga Expedition and International Indian Ocean Expedition (IIOE) are described. The characteristics which help to identify larval stages of Psettina are: the presence of pigmented urohyal appendage in early stages which is progressively reduced during flexion stages and which disappears in later postflexion stages, the meristics, the spines on urohyal and posterior basipterygial processes and the absence of spines on cleithra. The P. iijimae can be distinguished by the presence of spines on the median fin rays which differentiate near the baseosts along the dorsal and ventral body wall much before the fin rays. The larvae of P.iijimae were more abundant in the Gulf of Thailand compared to South China Sea and Indian Ocean.

Seasonal fluctuation in the distribution of eggs and larvae of flat fishes (Pleuronectiformes - Pisces) in the Cochin backwater

Attempts have been made to correlate the abundance of eggs and larvae of flat fishes belonging to families Cynoglossidae and Soleidae with the hydrographical parameters of the environment, particularly the salinity. The eggs and larvae were found to occur in the Cochin backwater during the pre-monsoon period but not during the south west monsoon period. During the south west monsoon period larvae belonging to very early stages were found at the marine end (Fairway Buoy). The continued or prolonged existence of very low salinity appears to restrict the distribution of flat fish larvae. In the post-monsoon period also the eggs and larvae were not found in regions of very low salinity. Larvae of Cynoglossus puncticeps (Richardson), C. brevis Gunther, C. cynoglossus (Ham. Buch), C. lida (Bleeker) and Solea heinii Steindachner were obtained in the collection taken from the estuary. From the data it is seen that each species has specific spawning period.

The design and construction of flat rectangular otter boards for bottom trawling: a review

The design and construction of the otter board is a subject of great importance for economy in trawling. This review incorporates a historical resume tracing the change and development• of otter boards. The size of the otter board and its relationship with the horse power of the engine and size of the net and the methods of rigging are dealt with. The factors influencing the horizontal spread are discussed. The effect of the angles of attack, heel and tilt and the ground reaction on the force coefficients have been reviewed and discussed with particular reference to flat rectangular otter boards used for bottom trawling. A short account of other designs of otter boards used for improved efficiency is given. Suggestion for improving the efficacy of otter boards based on the work hitherto done has been made. The contributions relating to the various aspects of design and performance of trawl boards carried out till 1969 have been considered.

Results of comparative fishing trials with rectangular flat and rectangular curved otter boards

The communication deals with the results of comparative fishing operations conducted to study the effectiveness of rectangular flat and rectangular curved otter boards. Based on the analysis of data gathered during the course of actual field trials, following conclusions have been drawn: the average catch per hour of trawling was more by 22 kg during attachment of rectangular curved otter boards. The average horizontal spread between rectangular curved otter boards in action was more by 13% and works out to 50% of the head-rope length of the net including sweeps. The towing resistance of the gear with horizontally curved otter boards was more by 10%.

Proximate composition of five species of flat fishes

Five species of flat fishes, namely Cynoglossus semifaciatus, C. lida, C. bilineatus, C. macrolepidotus and Psettodes erumei caught in trawlers off Mangalore were analysed for proximate composition of different body parts. These data are discussed in terms of their variability and applications. In whole body of C. lida and C. semifaciatus mean values for moisture, protein, fat and ash content on dry basis respectively were 75.9%, 75.3%, 7.1%, 16.1% and 78.9%, 75.6%. 7.9% and 16.6%. Mean values of these constituents of edible parts in the same order for C. semifaciatus and Psettodes erumei were 77.3%, 80.7%, 7.8%, 10.8% and 77.4%, 86.2%, 3.5% and 11.1% respectively.

On the comparative efficiency of "V" shaped and rectangular flat otter boards for trawling off Veraval, north west coast of India

V shaped all steel boards, with their inherent stability to tide over obstacles and mud, interchangeability of starboard and portside boards are found to be superior to conventional flat rectangular boards for bottom trawling. These are cheaper in construction, offer less resistance and give longer service. Comparative trials with the two types of boards showed significant difference in tension between the boards but not in catch or horizontal opening.