Ein Vorschlag zur Senkung des Schlepppwiderstandes von Grundschleppnetzen

Mathematical modelling shows that the projection area of the trawl twine influencing its hydrodynamic resistance can be reduced by approx. 30 % through increasing the mesh size of the trawl wings and the conical parts of the trawls, in combi-nation with the use of thinner twine. The interrelation between fuel consumption and projection area of the trawl twine as well as the influence of the enlarged meshes of the wings and first panels on the catch composition can only be measured by trials on fishing boats.

T90-Steert: Letzte Untersuchungen vor der Übernahme ins EU-Regelwerk

After due consideration the EU Commission has decided in December 2005 to admit cod-ends made of netting turned 90 de-grees (T90) as an allowable alternative for the cod fishery of the Baltic. The construction was included as one of two admissibles versions into the newly issued EU regulation 2187/2005 on technical measures for the conservation of fishery resources of the Baltic. This contribution describes some of the investigations preceeding that decision with which some of the previous demurs could be dispelled. In the course of these experiments it was detected that the cod-end netting material plays an important role for the mesh selection of a T90 cod-end, whereas the netting twine diameter is negligible. Problems with modern twine mate-rial have to be taken in consideration for constructional changes of T90 cod-ends. A relation of 1 to 2 in the circumferences in meshes at the joining round between last row of the belly and extension/cod-end turned out to be acceptable. Both the hauling technique (sidetrawler or sterntrawler) and an extensive use in the commercial fishery proved to be of no relevance for to the selection of T90 cod-ends. Taken alone, the different hydrodynamic conditions in a cod-end are insufficient to fully explain the selection phenomena. This was demonstrates by the material-related differences in selectivity of T90 cod-ends.

Application of participatory rural appraisal (PRA) techniques in the verification of fisheries data and trend on Lake Kainji

After several years of surveys on the Kainji Lake fisheries activities by the Nigerian German Kainji Lake Fish promotion Project (KLFPP) trends regarding catches, yield and other parameter begin to emerge. However, it became obvious that some of the data were not quite as accurate as they were believed to be. Looking at the different editions of the statistical bulletin of Kainji Lake, concerning one given fisheries parameter, sometimes it is possible to reveal inconsistencies and unexplained trends. As compared to the survey method, PRA is primarily for analysis of differences in local phenomenon and processes. Therefore, PRA was used as a complementary tool to enhance the knowledge on issues like fisher women, entrepreneurs, gear ownership structure, mode of operation by owners of large gear number, preference in the use of twine and nylon gill nets, and reasons for misinformation on the number of fishing equipment owned by entrepreneurs, which cannot be done with frame survey. PRA techniques like timeline, mapping, seasonal calendar, transect walk and key informant interviews were utilized in the study process

On the comparative efficiency of conventional and bulged belly fish trawls

To ensure a greater vertical opening while under tow, a trawl net with a bulged belly was made and compared with a conventional design under actual fishing conditions. It was found that the new design landed 31.8% more fish. Since the percentage lateral spread was relatively less for the bulged belly net, it was inferred that this net had higher head line height, while under operation and this was further substantiated by a greater catch of off—bottom fishes. Further, half the quantity of twine can be saved by changing the conventional trawl to that of bulged belly type.

Observation on the lunar and tidal influence on gill netting in the Bay of Bengal

The effect of lunar and tidal influence on the landing of pelagic fish with drift gill nets has been studied for the first time from Bay of Bengal along the Orissa coast. The catchability of the gear was highest during the first quarter and lowest in the fourth quarter of the moon. The variation in catch rates during the four different quarters was not statistically significant. Contrary to the earlier belief, landing with gill net was not poor during the moonlit nights. The extensive use of bluish grey nylon twine matching with seawater in place of indigenous hemp or cotton twine, has largely eliminated the visibility of gear during the brighter phase of the moon. The rate of exploitation was found to be significantly higher during the nights of neap tide, compared to those of spring tide. A plausible explanation for this phenomenon has been offered.

A note on the comparative catch efficiency of nylon over cotton gill nets in reservoir fishing

The authors conducted a series of experiments to evaluate the relative efficiency of nylon over cotton in tropical waters, particularly in reservoir fishing. The experiments were conducted in the Gobindsagar reservoir (Himachal Pradesh/Punjab). The nets made with both materials were identical in essential details like twine size, mesh size, number of floats arid sinkers and hanging coefficients.

Selectivity of gill nets for Scomberomorus commersoni

Selectivity of gill nets for S. commersoni was studied with nets made of 4 different mesh sizes fabricated with 4 different specifications of nylon twines. Fishing operations were conducted off Cochin through the fishing seasons 1968-72. The commercially significant size group of S. commersoni was found to fall in the length range of 850-950 mm. The optimum mesh size required for the capture of this group of S. commersoni was estimated as 76 mm. bar in nylon twine 210/12/3. The relationship between the twine size and mesh size was also worked out.

Tensile strength properties of polyethylene netting twines under exposure to out-door and artificial UV radiation

Photodegradation of three types of polyethylene twines namely, polyethylene fibrillated tape twine, polyethylene flat tape twine and polyethylene monofilament twines were studied by exposing them to sunlight and artificial UV radiation. The percentage residual strength varied in the samples, the monofilament with the highest residual strength followed by fibrillated tape twine and flat tape twine. A plot of the difference between the breaking strengths of the fibrillated tape twine and the mono filament twines against any given period of exposure exhibited a linear relationship

Studies on the suitability of HDPE material for gill nets

The suitability of HDPE yarn and HDPE twine in place of nylon for gill nets has been studied. As regards total catch nylon gill net is found to be better than HDPE nets. However, statistical analysis of the catch in respect of quality fishes shows that HDPE yarn nets are equally efficient as nylon nets.