Design and construction of portable surface aeration pump for tanks and small ponds

The maintenance of adequate dissolved oxygen level is very important in the economy of any aquaculture system. An easy to construct aerating device was created using 0.5 hp water-pump, shower rose, Styrofoam, and rubber hose. The aerator works by drawing water from below and discharging it into the atmosphere as a spray. The spray is aerated as it splashes into the water surface. The aerating device has an average spray of 1.2 unit and doubles the dissolved oxygen content of 37.8 m super(3) tank in one hour

Who's working on fishing gear design and construction for small-scale fisheries?

The findings are presented of a search conducted on traditional fishing gear design and construction using the ASFA database (1971-90) and the ICLARM Library and professional staff collections.

The design and construction of flat rectangular otter boards for bottom trawling: a review

The design and construction of the otter board is a subject of great importance for economy in trawling. This review incorporates a historical resume tracing the change and development• of otter boards. The size of the otter board and its relationship with the horse power of the engine and size of the net and the methods of rigging are dealt with. The factors influencing the horizontal spread are discussed. The effect of the angles of attack, heel and tilt and the ground reaction on the force coefficients have been reviewed and discussed with particular reference to flat rectangular otter boards used for bottom trawling. A short account of other designs of otter boards used for improved efficiency is given. Suggestion for improving the efficacy of otter boards based on the work hitherto done has been made. The contributions relating to the various aspects of design and performance of trawl boards carried out till 1969 have been considered.

Development of design and construction of fishing boats in Uganda

Fishing boats and canoes varied very little in Uganda from the middle of the 19th century umil 1949. types in use being the Dug Out Canoe. up to 40 ft. in length with 4 ft. beam hollowed from trees, and "Sesse" canoes which were used on Lake Victoria; these had an obvious Arab influence. The length of the "Sesse" in recent years as from about 1912 is 28 ft., and it is used as an open fishing craft.

Design and construction of a two dimensional duct equipped with a wave generator and a variable coastal slope and an ocean wave energy conversion system (OWC)

The aims of this thesis were evaluation the type of wave channel, wave current, and effect of some parameters on them and identification and comparison between types of wave maker in laboratory situations. In this study, designing and making of two dimension channels (flume) and wave maker for experiment son the marine buoy, marine building and energy conversion systems were also investigated. In current research, the physical relation between pump and pumpage and the designing of current making in flume were evaluated. The related calculation for steel building, channels beside glasses and also equations of wave maker plate movement, power of motor and absorb wave(co astal slope) were calculated. In continue of this study, the servo motor was designed and applied for moving of wave maker’s plate. One Ball Screw Leaner was used for having better movement mechanisms of equipment and convert of the around movement to linear movement. The Programmable Logic Controller (PLC) was also used for control of wave maker system. The studies were explained type of ocean energies and energy conversion systems. In another part of this research, the systems of energy resistance in special way of Oscillating Water Column (OWC) were explained and one sample model was designed and applied in hydrolic channel at the Sheikh Bahaii building in Azad University, Science and Research Branch. The dimensions of designed flume was considered at 16 1.98 0. 57 m which had ability to provide regular waves as well as irregular waves with little changing on the control system. The ability of making waves was evaluated in our designed channel and the results were showed that all of the calculation in designed flume was correct. The mean of error between our results and theory calculation was conducted 7%, which was showed the well result in this situation. With evaluating of designed OWC model and considering of changes in the some part of system, one bigger sample of this model can be used for designing the energy conversion system model. The obtained results showed that the best form for chamber in exit position of system, were zero degree (0) in angle for moving below part, forty and five (45) degree in front wall of system and the moving forward of front wall keep in two times of height of wave.

Pond construction: design and layout of ponds

(4pp.)

Chief Kerry's moose : a guidebook to land use and occupancy mapping, research design, and data collection

Aboriginal peoples in Canada have been mapping aspects of their cultures for more than a generation. Indians, Inuit, Métis, non-status Indians and others have called their maps by different names at various times and places: land use and occupancy; land occupancy and use; traditional use; traditional land use and occupancy; current use; cultural sensitive areas; and so on. I use “land use and occupancy mapping” in a generic sense to include all the above. The term refers to the collection of interview data about traditional use of resources and occupancy of lands by First Nation persons, and the presentation of those data in map form. Think of it as the geography of oral tradition, or as the mapping of cultural and resource geography. (PDF contains 81 pages.)

Workshop on turtle bycatch mitigation for longline fisheries: experimental design and data analysis, 7-8 November 2007, San Ramón de Alajuela, Costa Rica

Large numbers of fishing vessels operating from ports in Latin America participate in surface longline fisheries in the eastern Pacific Ocean (EPO), and several species of sea turtles inhabit the grounds where these fleets operate. The endangered status of several sea turtle species, and the success of circle hooks (‘treatment’ hooks) in reducing turtle hookings in other ocean areas, as compared to J-hooks and Japanese-style tuna hooks (‘control’ hooks), prompted the initiation of a hook exchange program on the west coast of Latin America, the Eastern Pacific Regional Sea Turtle Program (EPRSTP)1. One of the goals of the EPRSTP is to determine if circle hooks would be effective at reducing turtle bycatch in artisanal fisheries of the EPO without significantly reducing the catch of marketable fish species. Participating fishers were provided with circle hooks at no cost and asked to replace the J/Japanese-style tuna hooks on their longlines with circle hooks in an alternating manner. Data collected by the EPRSTP show differences in longline gear and operational characteristics within and among countries. These aspects of the data, in addition to difficulties encountered with implementation of the alternating-hook design, pose challenges for analysis of these data.

Design and implementation of fishery modules in integrated household surveys in developing countries

Fish and other aquatic animals contribute to the food security of citizens of developing countries, both as a source of income and as a component of healthy diets, yet fishing is not currently captured in most integrated household surveys. This sourcebook provides essential technical guidance on the design of statistical modules and questionnaires aimed at collecting fishery data at the household level. Background on the main policies important to the fishery sector, information on the data needed to analyze issues of policy relevance, and methodology on the construction of survey questions to collect necessary data are also provided. The document is organized to provide essential technical guidance on how to design statistical modules and questionnaires aimed at collecting fishery data at the household level. It includes an overview of the main technical and statistical challenges related to sampling fishery-dependent households. The document starts with an introductory section identifying the potential reasons why fisheries and in particular small-scale fisheries have not been adequately included in national statistical systems in a large number of countries. The report then proposes a succinct review of what is known (and what remains unknown) about small-scale fisheries and their contribution to the livelihoods of households in sub-Saharan Africa. It also provides readers with background on the main policies that are important to the fishery sector, information on the data needed to analyze issues of policy relevance, and methodology on the construction of survey questions to collect necessary data.

An evaluation of length-frequency sampling procedures and subsequent data analysis for purse seine-caught yellowfin tuna in the Eastern Pacific Ocean

ENGLISH: A two-stage sampling design is used to estimate the variances of the numbers of yellowfin in different age groups caught in the eastern Pacific Ocean. For purse seiners, the primary sampling unit (n) is a brine well containing fish from a month-area stratum; the number of fish lengths (m) measured from each well are the secondary units. The fish cannot be selected at random from the wells because of practical limitations. The effects of different sampling methods and other factors on the reliability and precision of statistics derived from the length-frequency data were therefore examined. Modifications are recommended where necessary. Lengths of fish measured during the unloading of six test wells revealed two forms of inherent size stratification: 1) short-term disruptions of existing pattern of sizes, and 2) transition zones between long-term trends in sizes. To some degree, all wells exhibited cyclic changes in mean size and variance during unloading. In half of the wells, it was observed that size selection by the unloaders induced a change in mean size. As a result of stratification, the sequence of sizes removed from all wells was non-random, regardless of whether a well contained fish from a single set or from more than one set. The number of modal sizes in a well was not related to the number of sets. In an additional well composed of fish from several sets, an experiment on vertical mixing indicated that a representative sample of the contents may be restricted to the bottom half of the well. The contents of the test wells were used to generate 25 simulated wells and to compare the results of three sampling methods applied to them. The methods were: (1) random sampling (also used as a standard), (2) protracted sampling, in which the selection process was extended over a large portion of a well, and (3) measuring fish consecutively during removal from the well. Repeated sampling by each method and different combinations indicated that, because the principal source of size variation occurred among primary units, increasing n was the most effective way to reduce the variance estimates of both the age-group sizes and the total number of fish in the landings. Protracted sampling largely circumvented the effects of size stratification, and its performance was essentially comparable to that of random sampling. Sampling by this method is recommended. Consecutive-fish sampling produced more biased estimates with greater variances. Analysis of the 1988 length-frequency samples indicated that, for age groups that appear most frequently in the catch, a minimum sampling frequency of one primary unit in six for each month-area stratum would reduce the coefficients of variation (CV) of their size estimates to approximately 10 percent or less. Additional stratification of samples by set type, rather than month-area alone, further reduced the CV's of scarce age groups, such as the recruits, and potentially improved their accuracy. The CV's of recruitment estimates for completely-fished cohorts during the 198184 period were in the vicinity of 3 to 8 percent. Recruitment estimates and their variances were also relatively insensitive to changes in the individual quarterly catches and variances, respectively, of which they were composed. SPANISH: Se usa un diseño de muestreo de dos etapas para estimar las varianzas de los números de aletas amari11as en distintos grupos de edad capturados en el Océano Pacifico oriental. Para barcos cerqueros, la unidad primaria de muestreo (n) es una bodega de salmuera que contenía peces de un estrato de mes-área; el numero de ta11as de peces (m) medidas de cada bodega es la unidad secundaria. Limitaciones de carácter practico impiden la selección aleatoria de peces de las bodegas. Por 10 tanto, fueron examinados los efectos de distintos métodos de muestreo y otros factores sobre la confiabilidad y precisión de las estadísticas derivadas de los datos de frecuencia de ta11a. Se recomiendan modificaciones donde sean necesarias. Las ta11as de peces medidas durante la descarga de seis bodegas de prueba revelaron dos formas de estratificación inherente por ta11a: 1) perturbaciones a corto plazo en la pauta de ta11as existente, y 2) zonas de transición entre las tendencias a largo plazo en las ta11as. En cierto grado, todas las bodegas mostraron cambios cíclicos en ta11a media y varianza durante la descarga. En la mitad de las bodegas, se observo que selección por ta11a por los descargadores indujo un cambio en la ta11a media. Como resultado de la estratificación, la secuencia de ta11as sacadas de todas las bodegas no fue aleatoria, sin considerar si una bodega contenía peces de un solo lance 0 de mas de uno. El numero de ta11as modales en una bodega no estaba relacionado al numero de lances. En una bodega adicional compuesta de peces de varios lances, un experimento de mezcla vertical indico que una muestra representativa del contenido podría estar limitada a la mitad inferior de la bodega. Se uso el contenido de las bodegas de prueba para generar 25 bodegas simuladas y comparar los resultados de tres métodos de muestreo aplicados a estas. Los métodos fueron: (1) muestreo aleatorio (usado también como norma), (2) muestreo extendido, en el cual el proceso de selección fue extendido sobre una porción grande de una bodega, y (3) medición consecutiva de peces durante la descarga de la bodega. EI muestreo repetido con cada método y distintas combinaciones de n y m indico que, puesto que la fuente principal de variación de ta11a ocurría entre las unidades primarias, aumentar n fue la manera mas eficaz de reducir las estimaciones de la varianza de las ta11as de los grupos de edad y el numero total de peces en los desembarcos. El muestreo extendido evito mayormente los efectos de la estratificación por ta11a, y su desempeño fue esencialmente comparable a aquel del muestreo aleatorio. Se recomienda muestrear con este método. El muestreo de peces consecutivos produjo estimaciones mas sesgadas con mayores varianzas. Un análisis de las muestras de frecuencia de ta11a de 1988 indico que, para los grupos de edad que aparecen con mayor frecuencia en la captura, una frecuencia de muestreo minima de una unidad primaria de cada seis para cada estrato de mes-área reduciría los coeficientes de variación (CV) de las estimaciones de ta11a correspondientes a aproximadamente 10% 0 menos. Una estratificación adicional de las muestras por tipo de lance, y no solamente mes-área, redujo aun mas los CV de los grupos de edad escasos, tales como los reclutas, y mejoró potencialmente su precisión. Los CV de las estimaciones del reclutamiento para las cohortes completamente pescadas durante 1981-1984 fueron alrededor de 3-8%. Las estimaciones del reclutamiento y sus varianzas fueron también relativamente insensibles a cambios en las capturas de trimestres individuales y las varianzas, respectivamente, de las cuales fueron derivadas. (PDF contains 70 pages)

Daily MOBY Data Processing

(PDF contains 57 pages)

The design and development of the Windermere Profiler. An instrument for measuring how various environmental parameters vary with depth in lakes, reservoirs and rivers

A review article detailing the background, development and functionality of the Windermere Profiler, a multi parameter environmental monitoring instrument for use in lakes, reservoirs and rivers. The article explains the requirement for regular data collection by the Freshwater Biological Association at Windermere. The article covers the requirements of a profiling instrument, the design considerations, the electronic circuitry, the computer program, the operation of the computer software, the profiler in use and further developments to the design. A number of figures and images accompany the article.

Water temperature studies on the R. North Tyne after impoundment by Kielder dam. 1. General introduction and background data

This report describes the general background to the project, defines the stations from which data sets have been obtained and lists the available data. The project had the following aims: To develop a more accurate and less labour-intensive system for the collection and processing of water temperature data from a number of stations within a stream/river system, and to use the River North Tyne downstream of the Kielder impoundment as a test bed for the system. This should yield useful information on the effects of impoundment upon downstream water temperatures.