Design and construction of portable surface aeration pump for tanks and small ponds

The maintenance of adequate dissolved oxygen level is very important in the economy of any aquaculture system. An easy to construct aerating device was created using 0.5 hp water-pump, shower rose, Styrofoam, and rubber hose. The aerator works by drawing water from below and discharging it into the atmosphere as a spray. The spray is aerated as it splashes into the water surface. The aerating device has an average spray of 1.2 unit and doubles the dissolved oxygen content of 37.8 m super(3) tank in one hour

A field guide for Agency staff operating the SIMRAD EY500 portable scientific echosounder. 2nd draft 3rd August 1999

This manual has been produced by members of the national acoustics group (NAG) and represents the first in a series of outputs designed to promote co-ordination and consistency in Agency hydroacoustic surveys. It is designed as a field guide for Agency staff operating the SIMRAD EY500 portable scientific echosounder. It should be simplistic enough for the newcomer to EY500 to be able to set up and run a mobile hydroacoustic survey with some knowledge of the supporting theory. It should act as guidance for standardisation of survey procedures providing a concise list of settings and recommendations that can be used as a quick reference guide in the field. This manual condenses 5 years of practical experience of surveying fish populations using Simrad hardware and software for surveying large rivers and still waters throughout England and Wales. This document should be used as a companion to the manufacturers instruction manual and not act as a substitute for it.

Portable canvas tanks for culture of hybrid catfish (Clarias gariepinus x Clarias macrocephalus) by small-scale farmers in Malaysia

This paper describes the trials made with a simple portable canvas-tarpaulin tank system developed at the University Sains Malaysia for culture of hybrid catfish (Clarias gariepinus x Clarias macrocephalus) by Malaysia small scale farmers.

Portable electronic warp load meter

A portable type warp load meter has been developed for the use in fishing trawlers. The instrument enables to monitor the warp load in fishing trawlers accurately and easily without disturbing the routine fishing operations. The instrument can be used in several other places like cranes, bollard tests for marine engines, dry docks etc. especially when the operation has to be conducted easily without disturbing the load system. The information displayed in micro ammeter in the range 0 to 1000 kg can be fed to continuous recorders for detailed analysis and permanent records.

Leistungsmessung an Bord von Fischereifahrzeugen zur Kontrolle der 300-PS-Begrenzung in der Schollenbox

For monitoring of the engine power of fishing vessels permitted for fishery in the plaice box with engine power of 300 HP or less at sea three different portable power measurement systems are developed and tested. A system measuring the twist of the propeller shaft by two divisible gearwheels mounted on the shaft worked well at shafts with roller bearing at both sides of the measured interval of 100–300 mm length. Only at a very few fishing vessels this system is applicable and therefore for monitoring purposes not suitable. The application of a commercial available system measuring the stress at the surface of the shaft was simplified for application by non experts. The torque is measured by strain gauges. The calibration of the system, measuring and recording of the power is done by a PC automatically. A small polished facet on the shaft protected against oxidation is needed for easy and quick application. In this case the system can be used by technical personnel of supervision boats for monitoring of the engine power at sea in a short time. A third power measurement system determinates the torque by measuring the displacement of two supports clamped on the shaft at a distance of 100 mm. The displacement is measured by a micrometer gauge mounted on one of the supports. Readout of the rotating gauge display is possible taking advantage of stroboscopic effect. The system needs no conditioning of the shaft and can be used by non technicians. The development is not finished until now and some additional investigations and tests are required. Additional measures for monitoring of the power on fishing vessels by self recording power measurement systems and sealed fuel racks with limited injection are reported and discussed.

Natural habitat and population control mechanism of Crassula helmsii (Australian Swamp Stonecrop) in Australia

The plant Crassula helmsii (Kirk) Cochayne, was likely to become widely distributed and to dominate many damp and wet areas of nature reserves, recreational waters and agricultural drainage of Britain. The aim of this report was to study Australian Swamp Stonecrop in its natural habitat where it is in balance with its environment. This contrasts with its rapid and widespread distribution in the U.K. where its growth interferes with the use of fisheries and amenity lakes but also reduces the value of nature reserves and sites of special scientific interest by suppressing native flora. It was proposed to observe its growth at a variety of sites over its natural distribution and to include some environmental factors, e.g. water-level, water-chemistry (nutrients, acidity and alkalinity), frost-tolerance, salinity, with the help of portable sensors, locally-available services or data. 8 weeks of travel in Australia allowed time to study the plant in its natural habitat including the coastal areas of the southern half of the continent i.e . Western Australia, South Australia, New South Wales, Victoria, Tasmania and southern Queensland. The overall objective was to determine the environmental range by visits to selected sites of Crassula helmsii over its geographic range.

Instrument for the measurement of the fore and aft tilt of otterboards

A portable self-contained instrument has been designed and developed for the measurement of the Fore and Aft tilt of otter boards within the range —22° to + 22° with an accuracy of ± 1°. An underwater transducer fitted on the otter board converts its tilt into corresponding electrical resistance which is measured in an ohmmeter on board, both being connected by electric cable.

National report of the frame survey 2010 on the Uganda side of Lake Victoria

This is a report on the results of the Frame Survey conducted in the Uganda side of Lake Victoria during August 2010 by the LVFO Institutions, namely: the Department of Fisheries Resources (DFR) Uganda and the National Fisheries Resources Research Institute (NaFIRRI) in close collaboration with the District Fisheries offices of Busia, Bugiri, Mayuge, Jinja, Mukono, Kampala, Wakiso, Mpigi, Masaka, Kalangala and Rakai. The authors are grateful to the LVEMP II, for providing funds for the survey and the LVFO secretariat coordination. Fisheries Frame surveys have been carried out on Lake Victoria biannually since 2000 to determine the number of fishers, fish landing sites, and facilities at the landing sites, as well as the composition of fishing crafts, their mode of propulsion, fishing gears and the fish species they target. This information is used to guide development and management of the lake’s fisheries. Following the reorganisation of landing sites into Beach Management Units (BMUs), the number of landing sites decreased from 597 in 2000 to 435 in 2008. The survey in 2010 showed an increase to 503 landing sites, an indication that new landing sites are coming up. The fish landing sites continue to have inadequate facilities such as fish shades, cold rooms to service the fisheries industry and very few (5%) have access to electricity and 32% had access to all weather roads. There has been some progressive improvement in the landing site coverage of basic hygiene and sanitation facilities, especially public toilet facilities from 17% in 2000 to 39% in 2010; and portable water from 4% to 17% respectively. However more effort is required to cover all landing sites. Most landing sites (83%) have access to mobile phone networks which eases communication. 46% of landing sites had access to a Health clinic and 64% had a Primary school within a radius of 2 km.

National report of the frame survey 2006 in the Ugandan part of Lake Victoria

Fisheries Frame surveys have been carried out on Lake Victoria biannually since 2000 to determine· the number of fishers, fish landing sites, facilities at the landing sites. Information on the composition fishing crafts, their mode of propulsion, fishing gears and the fish species they target is also collected. This information is used to guide development and management of the lake's fisheries. The results of the four surveys carried out since 2000 show that the number of landing sites has decreased by 24% from 597 in 2000 to 481 in 2006, mainly as result of reorganisation of landing sites into Beach Management Units (BMUs). The fish landing sites continue to have inadequate facilities to service the fisheries industry e.g. in the 2006 survey only 11.2% of landing sites had fish shades; <0.6% had cold rooms; 3.5% had electricity; and only 35.5% had toilet facilities. Similarly, only 11.4% of landing sites had portable water; 2.5% had jetties, 3.7% had 'fish stores; and 36% were accessible by all weather roads. There is need to improve facilities servicing fisheries at landing sites, with major emphasis on sanitary facilities, especially toilets and portable water. The BMUs should be sensitised to prioritise the construction and utilisation of public toilet facilities at their respective landing sites. The ultimate aim should be to have public toilets at all fish landing sites. The trend of the various indicators of fishing effort has continued upwards: The total number of fishers increased by 43.5% from 37,721 in 2004 to 54,148 in 2006 and the number of fishing crafts increased (43.9%) from 16,775 in 2004 to 24,148 in 2006 over the same period. The total number of gillnets increased by 28.6% from 458,597 in 2004 to 589,777 in 2006 and the number of long line hooks increased by 136% from 968,848 to 2,285,609. The number of fishing crafts using outboard engines also increased from 3,173 in 2004 to 5,047 in 2006 suggesting that more fishers were going far in search of fish. There is still a large number of illegal gears especially beach seines, which increased by 58.8% from 954 in 2004 to 1420 in 2006. Efforts to remove these very destructive gears should be stepped up. There was also larger increase in number of illegal gillnets <5 inch mesh size. These increased by 63% from 56,246 in 2004 to 91,740 in 2006 compared with 23.8% increase of gillnets ~5 inch mesh size. There were also large increases in the numbers of gillnets of 5 and 5% inch mesh size, which increased by 48% and 130% from 2004 to 2006 implying a trend towards use of smaller gillnet mesh sizes. The number of traps which are used in shallow vegetated areas, flood plains and river mouths to target tilapiines and riverine species decreased drastically from 5,361 traps in 2004 to only 499 traps in 2006, a decrease of 974%, a phenomenon attributed to the receding water levels which have left the shallow vegetated areas dry. A total of 17,475 fishing crafts, 72% of all fishing crafts, in the Ugandan part of the lake are still using paddles and the. number of parachute crafts is also still very high, (Le. 5,064) comprising a high proportion (21 %) of the total number of fishing. There is need to promote the use of large fishing crafts with sails or a combination of sail and outboard motor. The Mukene fishery in the Ugandan waters of Lake Victoria has remained underdeveloped with only 9% of all fishing crafts operating in this fishery. Also less than 2% of fishing crafts with sails or motor operate in this fishery which implies that it is limited to near shore waters. Effort should be made to develop this fishery as it appears to have high potential, especially in deep offshore waters which are hardly fished.

In situ temperature and salinity meter

Development of a portable self-contained electronic meter for on the spot determination of temperature and salinity is described. Instant and remote measurements of temperature and salinity of sea and estuarine waters in the range of 25-30°C and 30-35°C for temperature with an accuracy ± 0.05°C and 0-37‰ and 31-37‰ for salinity with an accuracy of ± 0.2‰ and ± 0.05‰ respectively are possible with the instrument. The temperature compensations of the salinity measurements are done manually with the help of temperature charts. The temperature and salinity measurements can be fed to continuous recorders.

Preliminary chemical and physical evaluation of some formulated feeds for P. monodon

The culture of Penaeus monodon has explicitly defined the need for diet formulations or supplementary feeds that would promote optimum growth and survival of the animal. A total of 28 feed combinations were developed for P. monodon. Fish meal, shrimp head meal, squid head meal, Ascetes spp. rice bran, and soybean cake were used as primary ingredients in these feeds. The commercial vitamin mix No. 22 was added to the dry ingredients. Gelatinized corn starch and wheat flour were used as binders. The pellets were extruded using a portable kitchen grinder with a diameter of 4 mm. The products were either sun-dried for 8 hours or oven-dried overnight at 50 degree C to stabilize moisture at 8-10%. The pellets were then kept in covered glass bottles and stored in the laboratory at room temperature. The cost of the feeds excluding labour were also computed. The pellets were analyzed for protein, fat, carbohydrate, crude fiber, ash, and moisture contents using standard procedures. They were also analyzed for water stability. To test the stability of pellets in water, 2-g samples were placed in plankton nets (mesh #40) and suspended in water for two, and six hours. The undissolved samples were then vacuum-dried and the moisture determined. Cost of the feeds ranged from P1.10 to P2.60 per kg depending on the feed ingredient. Squid and Ascetes spp. were rather expensive for use as basic ingredients. Proximate analysis of dry weight showed percentage protein content ranged from 20-63 g; fat, 8-20 g; carbohydrate (by difference), 11-36 g; ash, 8-28 g; moisture, 6-11 g; and crude fiber, 5 . 13 g. Stability tests showed that after two hours, 35-88% of solids remained intact and after 6 hours, 20-55% of the pellets remained undissolved. When a pellet disintegrates easily, pollution of the water occurs. Chances for the shrimp to feed on the pellet is minimized when the pellet is unstable. Thus, the search for a more compact feed pellet has to be continued.

Development of a fishing log for use in trawlers

The paper describes the technical and operational features of a composite equipment for simultaneous measurement of five important parameters, warp load, boat speed, water temperature, water salinity and air temperature pertaining to the craft, gear and the environment. The equipment is designed for continuous measurement in small and medium crafts easily without disturbance to routine fishing operations. The system operated on 9V supply, is suitable for portable operations from one vessel to another. The compact electronic meter kept in the wheel-house displays the data one by one in engineering units.

Improved cement block fish smoking kiln

The kiln described below is based on a portable sheet steel kiln designed by Beny in 1964. Improvement of quality of the final product, increased operating efficiency and reduction in firewood consumption were the reasons prompting the design. The design discussed was evolved by the author after a number of experimental prototypes were built, in order to reduce first cost and heat losses, both high with the all-steel kiln. Traditionally, a simple pit and table is used, around the shures of Lake Kyoga, for smoking fish.