MDNR-NOAA trawl standardization study

Long-term living resource monitoring programs are commonly conducted globally to evaluate trends and impacts of environmental change and management actions. For example, the Woods Hole bottom trawl survey has been conducted since 1963 providing critical information on the biology and distribution of finfish and shellfish in the North Atlantic (Despres-Patango et al. 1988). Similarly in the Chesapeake Bay, the Maryland Department of Natural Resources (MDNR) Summer Blue Crab Trawl survey has been conducted continuously since 1977 providing management-relevant information on the abundance of this important commercial and recreational species. A key component of monitoring program design is standardization of methods over time to allow for a continuous, unbiased data set. However, complete standardization is not always possible where multiple vessels, captains, and crews are required to cover large geographic areas (Tyson et al. 2006). Of equal issue is technological advancement of gear which serves to increase capture efficiency or ease of use. Thus, to maintain consistency and facilitate interpretation of reported data in long-term datasets, it is imperative to understand and quantify the impacts of changes in gear and vessels on catch per unit of effort (CPUE). While vessel changes are inevitable due to ageing fleets and other factors, gear changes often reflect a decision to exploit technological advances. A prime example of this is the otter trawl, a common tool for fisheries monitoring and research worldwide. Historically, trawl nets were constructed of natural materials such as cotton and linen. However modern net construction consists of synthetic materials such as polyamide, polyester, polyethylene, and polypropylene (Nielson et. al. 1983). Over the past several decades, polyamide materials which will be referred to as nylon, has been a standard material used in otter trawl construction. These trawls are typically dipped into a latex coating for increased abrasion resistance, a process that is referred to as “green dipped.” More recently, polyethylene netting has become popular among living resource monitoring agencies. Polyethylene netting, commonly known as sapphire netting, consists of braided filaments that form a very durable material more resistant to abrasion than nylon. Additionally, sapphire netting allows for stronger knot strength during construction of the net further increasing the net’s durability and longevity. Also, sapphire absorbs less water with a specific gravity near 0.91 allowing the material to float as compared to nylon with specific gravity of 1.14 (Nielson et. al. 1983). This same property results in a light weight net which is more efficient in deployment, retrieval and fishing of the net, particularly when towing from small vessels. While there are many advantages to the sapphire netting, no comparative efficiency data is available for these two trawl net types. Traditional nylon netting has been used consistently for decades by the MDDNR to generate long term living resource data sets of great value. However, there is much interest in switching to the advanced materials. In addition, recent collaborative efforts between MDNR and NOAA’s Cooperative Oxford Laboratory (NOAA-COL) require using different vessels for trawling in support of joint projects. In order to continue collaborative programs, or change to more innovative netting materials, the influence of these changes must be demonstrated to be negligible or correction factors determined. Thus, the objective of this study was to examine the influence of trawl net type, vessel type, and their interaction on capture efficiency.

Observations on the durability of fifteen species of CCA treated timber in the Cochin harbour

Observations on the durability of fifteen species of common Indian timber treated with CCA at two absorption levels, for eight years are presented. CCA treatment has improved the durability of this timber to a great extent. T. grandis, D. indicus and X. xylocarpa give maximum durability on treatment with CCA. Less durable A. kurzi, T. nudiflora and P. longifolia when treated with CCA showed results comparable to the best species.

Trolling for Nile perch (Lates niloticus) in Lake Kyoga

Nile perch were introduced into Lake Kyoga in the mid·1950s from Lake Albert. Murchison Falls on the River Nile, between the two lakes, prevented Nile Perch and other elements of the typical nilotic fish population from naturally reaching Lake Kyoga. The introduction has been successful and considerable stocks of Nile Perch now exist in Lake Kyoga. In 1967, 13,000 tons of Nile Perch were estimated to have been landed by the commercial fishermen, fish of 200 lb. being now caught and specimens of 100 lb. being fairly common. Large Nile perch are caught commercially on long lines baited with live Protopterus' spp. or Clarias spp. Large mesh gillnets uccasionally take Nile Perch of up to 30 lb., but the high cost of the nets does not, at the moment, appear to justify this method of fishing; a 10 in. net, stretched 100 yards long (unmounted). 15 meshes deep and 60-ply nylon. costs approximately U. Shs. 300. The long·lines used are extremely simple and cheap to make, but considerable labour is needed to catch bait. Small Protopterus are normally caught by turning over floating rafts of grasses and papyrus, and extracting the fish from the root mass; this is hard and dirty work. Other small fish, more readily available, do not, according to fishermen, work as well, possibly because they are not as durable as the Protopterus or Clarias. Dead bait is never used.

Impacts of fishery activities on lake shore environment and options for sustainable management

Over the years, degradation of the lakeshore resources has been going on due to human induced activities. Human activities notably house construction, fish smoking, boat construction and cooking at the landings impact the tree and forest cover along the lakeshore and Islands. The survey was conducted in ten districts surrounding Lake Victoria and the landings sampled were selected with the help of the District Fisheries Officers. Data was obtained from selected fishermen and Key informants at these landing sites. The study examined the extent of knowledge on importance, utilization, threats and conservation of trees/forests at the landings. Results showed that the fishers (98%) were aware of the benefits derived from the trees/forests. According to the respondents, the most commonly used tree species for boat construction were Mvule (40%), Mkibu (20%), Musizi (17%) and Mpewere (11 %). This was mainly because these trees were durable. For house construction, Nsambya (25%), Musizi (24%) and other materials (12%) were the most commonly used. For other activities like fish smoking and cooking at the landing, the Fisherfolk used any type of tree species readily available at the landings. As regards the status of the trees at the landings, most of the respondents (72%) J agreed that due to some fishery related activities some tree species had reduced more than others in the vicinity of most landings. Most respondents said that the, most reduced tree species around the landings were Mvule (36%) and Musizi (22%). Among the fishery related activities that had a significant impact on the trees/forests, construction of houses (44%) and boats (22%) emerged uppermost. Other activities such as fish smoking (14%) and cooking (12%) had the least impact on trees/forests. Generally, there was extensive reduction of trees at the landings. Therefore there was need to regulate cutting of trees and to have specific programmes targeting afforestation at and around fish landings.