On the formation of ephippia in some Cladocera (Crustacea) [Translation from: Zoologicheskie Zhurnal 61, 1425-1427, 1982]

The determination of relative connections between families and genera of Cladocera, necessary for the construction of their natural systems, must be based on various criteria, among them on the structure of the ephippia. Of particular interest is the study of the process of formation and structure of the ephippium in Macrothricidae, different representatives of which differ significantly among themselves according to this criterion. In this article are presented the results of an investigation of the features of formation of the ephippium in seven species of Macrothricidae and in the moinid Moina weismanni Ishikawa (Moinidae).

Studies on the complex formation of iron with humic substances [Translation from: Vom Wasser 53, 243-247, 1979]

Most of the humic substances which occur in natural waters have an iron content of a few percent, indicated by the mg/1 content of organically-bonded carbon. This iron is apparently bound in a complex with the humic substances, for it quite plainly differs in its chemical and physico-chemical properties from what one would expect from the purely inorganic iron-water system. The deviations range from the solubility to the redox behaviour, and thus are frequently the basis of analytical and technical difficulties. The key to the solution of most of this problem lies in a better understanding of the aforementioned bonds between the iron and the humic substances. This paper studies the iron content of the humic substance concentration from a bog lake sample and the complexing of iron by humic substances from the surface of the bog lake.

Mechanism of mass transfer in the formation of hydrothermal deposits of sulphides [Translation from: Trudy Inst.Geol.rudn.Mesterozh. 16, 80 [pages 44-46 ”Solubility of sulphides of iron” only], 1958]

This partial translation of the original paper provides the summary of this study of the mechanism of mass transfer in the formation of hydrothermal deposits of sulphides. For determining the solubility of sulphides of iron, the radioactive isotope Fe59 was used. The solubility of two sulphides was determined.

Quantitative determination of the timing of otolith ring formation from marginal increments in four marine teleost species from northwestern Australia

The sectioned otoliths of four fish species from a tropical demersal trawl fishery in Western Australia revealed a series of alternating trans-lucent and opaque zones in reflected light. The translucent zones, referred to as growth rings, were counted to determine fish ages. The width of the opaque zone on the periphery of the otolith section as a proportion of the width of the previous opaque zone (index of completion) was used to determine the periodicity of growth-ring formation. This article describes a method for modeling changes in the index of ring completion over time, from which a parameter for the most probable time of growth-ring formation (with confidence intervals) can be determined. The parameter estimate for the timing of new growth-ring formation for Lethrinus sp. 3 was from mid July to mid September, for Lutjanus vitta from early July to the end of August, for Nemipterus furcosus from mid July to late September, and for Lutjanus sebae from mid July to mid November. The confidence intervals for the timing of formation of growth rings was variable between species, being smallest for L. vitta, and variable between fish of the same species with different numbers of growth rings. The stock assessments of these commercially important species relies on aging information for all the age classes used in the assessment. This study demonstrated that growth rings on sectioned otoliths were laid down annually, irrespective of the number of growth rings, and also demonstrated that the timing of ring formation for these tropical species can be determined quantitatively (with confidence intervals.

New food processing equipment

The article presents new food processing equipment for coating and frying. These are predusters, liquid enrobers and applicators for large-particle crumbs.