4 resultados para Copper oxide nano-particles, Polyaniline derivatives film, Hydrogen peroxide, Electrocatalysis

em Aquatic Commons


Relevância:

100.00% 100.00%

Publicador:

Resumo:

Chitosan is a natural polymer obtained by deacetylation of chitin. After cellulose chitin is the second most abundant polysaccharide in nature. It is biologically safe, non-toxic, biocompatible and biodegradable polysaccharide. Chitosan loaded with zinc oxide nanoparticles have gained more attention bio sorbent because of their better stability, low toxicity, simple and mild preparation method and high sorption capacity. Chitosan loaded with zinc oxide nanoparticles have been prepared of chitosan. The physicochemical properties of nanoparticles were characterized by Fourier Transform Infrared (FTIR), Scanning Electron Microscope (SEM) Analysis. Its sorption capacity for lead and cadmium ions studied. Factors such as initial concentration of lead ions, cadmium ions sorbent amount, contact time, pH and temperature were investigated. It is found that chitosan loaded with zinc oxide nanoparticles could sorb lead and cadmium ions effectively, this sorption rate was affected significantly by initial concentration of lead and cadmium ions, sorbent amount, contact time, pH of solution. The maximum of percentage of lead sorption was 98 % with initial concentration 3 mg/l and sorbent amount 0.05 g, pH 11 in 45 min and cadmiumwas90 %with initial concentration 3mg/l and sorbent amount 0.05 g, pH 11 in45 min. Consequently chitosan loaded with zinc oxide nanoparticles demonstrated greater fixation ability for lead ions than cadmium ions.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

During a two years research hydrogen peroxide efficacy evaluated for Persian sturgeon, Chinese carps and common carp eggs. These series of the experiments conducted in various conditions different concentration of hydrogen peroxide include 250, 500, 750, 1,000 1,500 2,000 3,000 and 9,000 PPM used as ten and fifteen minutes baths, compared with Malachite green and natural control . In the next phase effect of Levaemisole hydrochloride as an immunostimulator which applied as 5 mg/I in twenty minutes baths from day sixth after hatch evaluated by daily mortality rate and leukocytes counts. The results shown that according fertilization percent and temperature condition hydrogen peroxide at 1,000 and 1,500 PPM concentrations is a effective antifungal agent during incubation periods of Persian sturgeon and even sometimes increasing hatching rates significantly comparing with natural controls and Malachite green. In Chinese carps although hydrogen peroxide controls water molds but it is not recommended in high temperatures because it make shortened incubation time and mold infections will decrease. Also the results shown 750 PPM concentration of hydrogen peroxide in common carp eggs controls water moulds infections and increase hatching rate significantly comparing with Malachite green and natural control. Daily mortality rates accessing of Persian sturgeon fries show that 20 minutes baths of 5mg/1 levamisole hydrochloride decreases daily mortality rate during yolk sac absorption. Nitrogenous compounds: nitrate and ammonium differ significantly between treated tanks with control. Blood leucocytes concentrations as an immune index was different significantly in treated fishes by levamisole hydrochloride comparing with controls. In Chinese carps because yolks sac absorption time is short there is not necessary to use the levamisole hydrochloride. Although treated larvae were more active than controls. As a result our suggestions is to use hydrogen peroxide in Persian sturgeon and common carp artificial propagation and also suggest the use levamisole hydrochloride for Persian sturgeon beside management method in stress and pollution condition

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Ozone due to having low half-life and devoid of environmental harmful effects is recognized as one of the most effective disinfectant and fungicide in aquaculture. The objective of this study is to consider the effects of periodicay ozonation, hydrogen peroxide treatment, and physical treatment capability in hatching rate enhancement. Three concentrations of 0.05, 0.1 and 0.15 ppm ozone (10 min) and peroxide hydrogen with dose of 500 and 1000 ppm in two procedures accompanied with physical treatment and without physical treatment were examined on hatching rate. In the first year, Egg ozonation (0.1 ppm) with physical treatment have been resulted the greatest hatching rate (81.4%). In the second year, egg treatment with 1000 ppm hydrogen peroxide with physical treatment have been showed the greatest hatching rate (78%). Average hatching rate for the blank control treatment (without disinfectin and physical treatment) was 32.7%. From the economic viewpoint, 0.05 ppm ozone with physical treatment, due to considerable minimizing at consumption energy and ozonation system retention costs, indicated as the best treatment than other ozone treatments for fungal control. Very low correlation (r=-0.14) have been observed between hatchery water temperature and fungal infection percentage in control treatment.

Relevância:

100.00% 100.00%

Publicador:

Resumo:

Pure Water, is a crucial demand of creature life. Following industrial development, extra amount of toxic metals such as chromium enters the environmental cycle through the sewage, which is considered as a serious threat for organisms. One of the modern methods of filtration and removal of contaminants in water, is applying Nano-technology. According to specific property of silicate materials, in this article we try to survey increased power in composites and various absorption in several morphologies and also synthesis of Nano-metal silicates with different morphologies as absorbent of metal toxic ions. At first, we synthesize nano zink silicate with three morphologies considering context and the purpose of this survey. 1) Nano synthesis of zink silicate hollow cavity by hydrothermal method in mixed solvent system of ethanol/glycol polyethylene. 2) Zink nano wires silicate in a water-based system by controlling the amount of sodium silicate. 3) Synthesis of nano zink silicate membrane. After synthesizing, we measured the cadmium ion absorbance by synthesized nano zink silicates. Controlling PH, is the applied absorption method. Next step, we synthesized nano zink-magnesium silicate composite in two various morphologies of nanowires and membrane by different precent of zink and magnesium, in order to optimize synthesized nano metal silicate. We used zink nitrate and magnesium nitrate and also measured cadmium absorption by synthesized nano metal silicates in the same way of PH control absorption. In the 3rd step, in order to determine the impact of the type of metal in nano metal silicate, we synthesized nano magnesium silicate and compared its absorption with nano zink silicate. Furthermore, we calculated the optimal concentration in one of synthesizes. Optimal concentration is the process which has the maximum absorption. While applying two methods of absorption in the test, finally we compared the effect of absorption method on the absorption level. Below you find further steps of synthesis: 1) Using IR, RAMAN, XRD spectroscopy to check the accuracy of synthesis. 2) Checking the dispersion of nano particles in ethanol solution by light microscope. 3) Measuring and observing particles with scanning electron microscope (SEM). 4) Using atomic absorption device for measuring the cadmium concentration in water-based solutions. The nano metal silicates were synthesized successfully. All of synthesized nano absorbents have the cadmium ion absorbency. The cadmium absorption via nano absorbents depend on various factors such as kind of metal in nano silicate and percent of metal in nano metal silicate composite. Meanwhile the absorption and PH control of medium containing the absorbent and solution would affect the cadmium absorption.