Developing alternatives for optimal representation of seafloor habitats and associated communities in Stellwagen Bank National Marine Sanctuary

The implementation of various types of marine protected areas is one of several management tools available for conserving representative examples of the biological diversity within marine ecosystems in general and National Marine Sanctuaries in particular. However, deciding where and how many sites to establish within a given area is frequently hampered by incomplete knowledge of the distribution of organisms and an understanding of the potential tradeoffs that would allow planners to address frequently competing interests in an objective manner. Fortunately, this is beginning to change. Recent studies on the continental shelf of the northeastern United States suggest that substrate and water mass characteristics are highly correlated with the composition of benthic communities and may therefore, serve as proxies for the distribution of biological biodiversity. A detailed geo-referenced interpretative map of major sediment types within Stellwagen Bank National Marine Sanctuary (SBNMS) has recently been developed, and computer-aided decision support tools have reached new levels of sophistication. We demonstrate the use of simulated annealing, a type of mathematical optimization, to identify suites of potential conservation sites within SBNMS that equally represent 1) all major sediment types and 2) derived habitat types based on both sediment and depth in the smallest amount of space. The Sanctuary was divided into 3610 0.5 min2 sampling units. Simulations incorporated constraints on the physical dispersion of sampling units to varying degrees such that solutions included between one and four site clusters. Target representation goals were set at 5, 10, 15, 20, and 25 percent of each sediment type, and 10 and 20 percent of each habitat type. Simulations consisted of 100 runs, from which we identified the best solution (i.e., smallest total area) and four nearoptimal alternates. We also plotted total instances in which each sampling unit occurred in solution sets of the 100 runs as a means of gauging the variety of spatial configurations available under each scenario. Results suggested that the total combined area needed to represent each of the sediment types in equal proportions was equal to the percent representation level sought. Slightly larger areas were required to represent all habitat types at the same representation levels. Total boundary length increased in direct proportion to the number of sites at all levels of representation for simulations involving sediment and habitat classes, but increased more rapidly with number of sites at higher representation levels. There were a large number of alternate spatial configurations at all representation levels, although generally fewer among one and two versus three- and four-site solutions. These differences were less pronounced among simulations targeting habitat representation, suggesting that a similar degree of flexibility is inherent in the spatial arrangement of potential protected area systems containing one versus several sites for similar levels of habitat representation. We attribute these results to the distribution of sediment and depth zones within the Sanctuary, and to the fact that even levels of representation were sought in each scenario. (PDF contains 33 pages.)

Bearbeitung von Fangproben mit neuen elektronischen Messmethoden

For 10 years the Institute for Fishing Technology, Hamburg (IFH) has been carrying out experiments in the brown shrimp fishery with beam trawls aiming at a reduction of unwanted bycatches. When the tests were transferred to commercial fishery conditions the personnel effort and costs increased markedly. It became e.g. necessary to install a deep-freeze chain to make it possible to evaluate more samples in the laboratory. This again required to increase the number of technicians for measuring the fish and shrimp samples, but also made it necessary to perform this work in the most rational and time-saving way by applying modern electronic aids. Though all samples still have to be sorted by species and have to be weighed and measured the introduction of electronic aids, however, like electronic measuring board and computer-aided image processing system, all weight and length data are immediately and digitally recorded after processing. They are transferred via a network to a server PC which stores them into a purpose-designed database. This article describes the applicationof two electronic systems: the measuring board (FM 100, Fa. SCANTROL), iniated by a project in the Norwegian Institute for Fishing Technology, and a computer-aided image processing system, focussing on measuring shrimps in their naturally flexed shape, also developed in the Institute for Fishing Technology in close collaboration with the University of Duisburg. These electronic recording systems allow the consistent and reproducible record of data independent of the changing day-to-day personal form of the staff operating them. With the help of these systems the number of measurements the laboratory could be maximized to 250 000 per year. This made it possible to evaluate, in 1999, 525 catch samples from 75 commercial hauls taken during 15 days at sea. The time gain in measuring the samples is about one third of the time previously needed (i.e. one hour per sample). An additional advantage is the immediate availability of the digitally stored data which enables rapid analyses of all finished subexperiments. Both systems are applied today in several institutes of the Federal Research Centre. The image processing system is now the standard measuring method in an international research project.

Note on the occurrence of a terrestrial isopod, Hemilepistus klugii (Brandt) in Baluchistan, Pakistan

During a computer-aided search of the Crustacea collection in the Department of Invertebrate Zoology at the Smithsonian Institution (USNM), a record was found for the existence of Hemilepistus klugii (Brandt, 1833) in Pakistan.