Modification to the bilge and sea water pumps fitted in 17.5 metre Jingha type trawlers

This paper brings out the difficulties encountered with the Bilge and sea water circulating pumps which are fitted and drawn in series along with a fresh water pump in the 17.5 m fishing trawlers.

Der Haftwasseranteil bei Heringsanlandungen über Bandwaagen

In 2004 the fish processing company Euro-Baltic Fischverarbeitungs GmbH Mukran, went into operation on the Isle of Rügen at the Baltic coast of Germany. About 20 % of the herring landed there is discharged from the cutters into the processing plant by pipes, driven by pumps, in case that the landed volume exceeds 10 t fresh weight. In such case the herring is transported in water suspension by means of a pressure-vacuum suction pump system into containers and further transported via conveyer belt to a flowscale. During this process most of the water runs off. It is however unknown how much water remains with the fish and is eventually weighted as fish. To estimate this proportion the mixture of water and fish was stored in special transport containers, which allow the measurement of the run-off. As a result the study shows that on average 2 % of weight measured by the tape scale is water. Along with this factors were determined which influence the variability of the proportion of water.

Der Anteil Transportwasser bei Heringsanlandungen mittels Vakuumsauganlage in Großraumbehältern

Estimation of the water content of herring landings caused by pressure-vacuum double tank pumps and using of multi purpose transport containers About 80 % of herring that is landed in the fish processing company Euro-Baltic Fischverarbeitungs GmbH Mukran, on the Isle of Rügen at the Baltic coast is transported from the cutter into the processing plant by pumping. For this purpose 700 l-Euro-size polyethylene tubs (containers) are filled with herring by means of a pressure-vacuum pump-systems during the unloading of the cutter. To be able to pump the fish from the hold on board it is kept floating in water (transport water). At the end of the pumping/transporting process the fish ends in a dewatering box before reaching the tub, where the transport water is separated from the fish. Then, the not completely dewatered fish is slipped into the transport containers. The amount of transport water reaching the containers depends on the type of PV-equipment and on the amount of transport water in the fish holds of the different cutters. Methodologically the mixture of fish and water must be weighed together. For the experiments specially designed transport container were used which allow the measurement of the run-off of the water to be quantified and thus to measure the proportion of water remaining with the fish. Based on 30 experiments it could be shown that on average 6 % of remaining weight of the mixture is water. Furthermore, factors were detected which influence the variability of the proportion of water.

Larval rearing of Macrobrachium rosenbergii (De Man) in artificial sea water

Larvae of Macrobrachium rosenbergii were successfully reared in artificial sea water prepared in fresh ground water. The water was circulated through a biological filter by means of air-lift pumps for a period of one week to remove the undissolved particles prior to use in the hatchery operation. The experiments were initiated during 1989 and the hatchery has been working on pilot scale since June, 1990. The larvae in all the experiments were fed with egg-custard, Mona and Artemia nauplii. The survival rate varied from 5 to 52% in the 12 experiments. These findings can add to the development of hatcheries in the inland areas which can further boost the popularization of giant freshwater prawn farming.

Modified water spray chumming system for pole and line fishing of tuna

A water spray chumming system consisting of a 65 x 50 mm centrifugal pump driven by the propulsion engine through a PTO clutch and 'V' pulley power transmission system has been developed for the pole and line fishing of tuna. Water is sprayed through pipe loop system fitted on the edge of the fishing platform of the boat through small holes. The distance of the spray length can be adjusted by controlling the flow of the pump discharge water through a wheel valve.