A method for estimating the rate of shedding of tags from yellowfin tuna

ENGLISH: The present paper describes a new method for estimating the shedding rate of tags. The method utilizes not only data on tagging and recovery of fish marked with two tags but also data from those marked with one. One important advantage of the new technique is that the estimates of the shedding rates are free from distortion caused by variations in fishing intensity during the total recovery period. The idea of this method appears to be implicit in a short note by Gulland (1963). This technique has been applied to the data obtained by the Inter-American Tropical Tuna Commission in a tagging cruise off the west coast of southern Baja California, during June 1963, at which time both single and double-tagged yellowfin tuna were released. Details of the tagging procedure and equipment have been described by Fink (1965b). The results presented in the present paper are for yellowfin tuna tagged with dart tags. Estimates of shedding should be made separately for each species investigated and also for each type of tag used, since these rates may be variable and often unexpectedly high (Springer and McErlean 1961, Chadwick 1963). SPANISH: El presente estudio describe un nuevo método para estimar las tasas del desprendimiento de marcas. El método emplea no solamente los datos sobre la marcación y recobro de peces marcados con dos marcas, pero también datos de los peces marcados con una marca. Una ventaja importante de la nueva técnica, es que las estimaciones de las tasas de desprendimiento son libres de alteración, causada por las variaciones en la intensidad de pesca durante el período total de recobro. La idea de este método parece ser implícita en un breve apunte por Gulland (1963). Esta técnica se ha aplicado a los datos obtenidos por la Comisión Interamericana del Atún Tropical, en un crucero de marcación efectuado frente a la costa occidental al sur de Baja California, en junio de 1963, tiempo en el cual fueron liberados atunes aleta amarilla marcados tanto con una como con dos marcas. Los detalles del procedimiento de la marcación y del equipo usado han sido descritos por Fink (1965b). Los resultados presentados en este estudio, pertenecen al atún aleta amarilla marcado con marcas de dardo. Las estimaciones del desprendimiento deben efectuarse separadamente para cada especie que ha sido investigada y también para cada tipo de marca usado, ya que estas tasas pueden ser vaiables, y a menudo inesperadamente altas (Springer y McErlean 1961, Chadwick 1963). (PDF contains 20 pages.)

A 30-Year History of Tide and Current Measurements in Elkhorn Slough, California

Elkhorn Slough was first exposed to direct tidal forcing from the waters of Monterey Bay with the construction of Moss Landing Harbor in 1946. Elkhorn Slough is located mid-way between Santa Cruz and Monterey close to the head of Monterey Submarine Canyon. It follows a 10 km circuitous path inland from its entrance at Moss Landing Harbor. Today, Elkhorn Slough is a habitat and sanctuary for a wide variety of marine mammals, fish, and seabirds. The Slough also serves as a sink and pathway for various nutrients and pollutants. These attributes are directly or indirectly affected by its circulation and physical properties. Currents, tides and physical properties of Elkhorn Slough have been observed on an irregular basis since 1970. Based on these observations, the physical characteristics of Elkhorn Slough are examined and summarized. Elkhorn Slough is an ebb-dominated estuary and, as a result, the rise and fall of the tides is asymmetric. The fact that lower low water always follows higher high water and the tidal asymmetry produces ebb currents that are stronger than flooding currents. The presence of extensive mud flats and Salicornia marsh contribute to tidal distortion. Tidal distortion also produces several shallow water constituents including the M3, M4, and M6 overtides and the 2MK3 and MK3 compound tides. Tidal elevations and currents are approximately in quadrature; thus, the tides in Elkhorn Slough have some of the characters of a standing wave system. The temperature and salinity of lower Elkhorn Slough waters reflect, to a large extent, the influence of Monterey Bay waters, whereas the temperature and salinity of the waters of the upper Slough (>5 km from the mouth) are more sensitive to local processes. During the summer, temperature and salinity are higher in the upper slough due to local heating and evaporation. Maximum tidal currents in Elkhorn Slough have increased from approximately 75 to 120 cm/s over the past 30 years. This increase in current speed is primarily due to the change in tidal prism which has increased from approximately 2.5 to 6.2 x 106 m3 between 1956 and 1993. The increase in tidal prism is the result of both 3 rapid man-made changes to the Slough, and the continuing process of tidal erosion. Because of the increase in the tidal prism, the currents in Elkhorn Slough exhibit positive feedback, a process with uncertain consequences. [PDF contains 55 pages]

Variation in trawl geometry due to unequal warp length

Survey standardization procedures can reduce the variability in trawl catch efficiency thus producing more precise estimates of biomass. One such procedure, towing with equal amounts of trawl warp on both sides of the net, was experimentally investigated for its importance in determining optimal trawl geometry and for evaluating the effectiveness of the recent National Oceanic and Atmospheric Administration (NOAA) national protocol on accurate measurement of trawl warps. This recent standard for measuring warp length requires that the difference between warp lengths can be no more than 4% of the distance between the otter doors measured along the bridles and footrope. Trawl performance data from repetitive towing with warp differentials of 0, 3, 5, 7, 9, 11, and 20 m were analyzed for their effect on three determinants of flatfish catch efficiency: footrope distance off-bottom, bridle length in contact with the bottom, and area swept by the net. Our results indicated that the distortion of the trawl caused by asymmetry in trawl warp length could have a negative inf luence on flatfish catch efficiency. At a difference of 7 m in warp length, the NOAA 4% threshold value for the 83112 Eastern survey trawl used in our study, we found no effect on the acous-tic-based measures of door spread, wing spread, and headrope height off-bottom. However, the sensitivity of the trawl to 7 m of warp offset could be seen as footrope distances off-bottom increased slightly (particularly in the center region of the net where flatfish escapement is highest), and as the width of the bridle path responsible for flatfish herding, together with the effective net width, was reduced. For this survey trawl, a NOAA threshold value of 4% should be considered a maximum. A more conservative value (less than 4%) would likely reduce potential bias in estimates of relative abundance caused by large differences in warp length approaching 7 m.

Sediment flux at selected coastal sites: proposed time series measurment by particle traps

Particle flux in the ocean reflects ongoing biological and geological processes operating under the influence of the local environment. Estimation of this particle flux through sediment trap deployment is constrained by sampler accuracy, particle preservation, and swimmer distortion. Interpretation of specific particle flux is further constrained by indeterminate particle dispersion and the absence of a clear understanding of the sedimentary consequences of ecosystem activity. Nevertheless, the continuous and integrative properties of the particle trap measure, along with the logistic advantage of a long-term moored sampler, provide a set of strategic advantages that appear analogous to those underlying conventional oceanographic survey programs. Emboldened by this perception, several stations along the coast of Southern California and Mexico have been targeted as coastal ocean flux sites (COFS).

Modified water spray chumming system for pole and line fishing of tuna

A water spray chumming system consisting of a 65 x 50 mm centrifugal pump driven by the propulsion engine through a PTO clutch and 'V' pulley power transmission system has been developed for the pole and line fishing of tuna. Water is sprayed through pipe loop system fitted on the edge of the fishing platform of the boat through small holes. The distance of the spray length can be adjusted by controlling the flow of the pump discharge water through a wheel valve.