Measurements of attractive forces between proteins and end-grafted poly(ethylene glycol) chains

The surface force apparatus was used to measure directly the molecular forces between streptavidin and lipid bilayers displaying grafted Mr 2,000 poly(ethylene glycol) (PEG). These measurements provide direct evidence for the formation of relatively strong attractive forces between PEG and protein. At low compressive loads, the forces were repulsive, but they became attractive when the proteins were pressed into the polymer layer at higher loads. The adhesion was sufficiently robust that separation of the streptavidin and PEG uprooted anchored polymer from the supporting membrane. These interactions altered the properties of the grafted chains. After the onset of the attraction, the polymer continued to bind protein for several hours. The changes were not due to protein denaturation. These data demonstrate directly that the biological activity of PEG is not due solely to properties of simple polymers such as the excluded volume. It is also coupled to the competitive interactions between solvent and other materials such as proteins for the chain segments and to the ability of this material to adopt higher order intrachain structures.

Tissue spreading on implantable substrates is a competitive outcome of cell–cell vs. cell–substratum adhesivity

While the interactions of cells with polymeric substrata are widely studied, the influence of cell–cell cohesivity on tissue spreading has not been rigorously investigated. Here we demonstrate that the rate of tissue spreading over a two-dimensional substratum reflects a competition or “tug-of-war” between cell–cell and cell–substratum adhesions. We have generated both a “library” of structurally related copolymeric substrata varying in their adhesivity to cells and a library of genetically engineered cell populations varying only in cohesivity. Cell–substratum adhesivity was varied through the poly(ethylene glycol) content of a series of copolymeric substrata, whereas cell–cell cohesivity was varied through the expression of the homophilic cohesion molecules N- and R-cadherin by otherwise noncohesive L929 cells. In the key experiment, multicellular aggregates containing about 600 cells were allowed to spread onto copolymeric surfaces. We compared the spreading behavior of aggregates having different levels of cell–cell cohesivity on a series of copolymeric substrata having different levels of cell–substratum adhesivity. In these experiments, cell–cell cohesivity was measured by tissue surface tensiometry, and cell–substratum adhesivity was assessed by a distractive method. Tissue spreading was assayed by confocal microscopy as the rate of cell emigration from similar-sized, fluorescence-labeled, multicellular aggregates deposited on each of the substrata. We demonstrate that either decreasing substratum adhesivity or increasing cell–cell cohesivity dramatically slowed the spreading rate of cell aggregates.

Controlling cell attachment on contoured surfaces with self-assembled monolayers of alkanethiolates on gold.

This paper describes a method based on experimentally simple techniques--microcontact printing and micromolding in capillaries--to prepare tissue culture substrates in which both the topology and molecular structure of the interface can be controlled. The method combines optically transparent contoured surfaces with self-assembled monolayers (SAMs) of alkanethiolates on gold to control interfacial characteristics; these tailored interfaces, in turn, control the adsorption of proteins and the attachment of cells. The technique uses replica molding in poly(dimethylsiloxane) molds having micrometer-scale relief patterns on their surfaces to form a contoured film of polyurethane supported on a glass slide. Evaporation of a thin (< 12 nm) film of gold on this surface-contoured polyurethane provides an optically transparent substrate, on which SAMs of terminally functionalized alkanethiolates can be formed. In one procedure, a flat poly(dimethylsiloxane) stamp was used to form a SAM of hexadecanethiolate on the raised plateaus of the contoured surface by contact printing hexadecanethiol [HS(CH2)15CH3]; a SAM terminated in tri(ethylene glycol) groups was subsequently formed on the bare gold remaining in the grooves by immersing the substrate in a solution of a second alkanethiol [HS(CH2)11(OCH2CH2)3OH]. Then this patterned substrate was immersed in a solution of fibronectin, the protein adsorbed only on the methyl-terminated plateau regions of the substrate [the tri(ethylene glycol)-terminated regions resisted the adsorption of protein]; bovine capillary endothelial cells attached only on the regions that adsorbed fibronectin. A complementary procedure confined protein adsorption and cell attachment to the grooves in this substrate.

Rapid polyether cleavage via extracellular one-electron oxidation by a brown-rot basidiomycete

Fungi that cause brown rot of wood are essential biomass recyclers and also the principal agents of decay in wooden structures, but the extracellular mechanisms by which they degrade lignocellulose remain unknown. To test the hypothesis that brown-rot fungi use extracellular free radical oxidants as biodegradative tools, Gloeophyllum trabeum was examined for its ability to depolymerize an environmentally recalcitrant polyether, poly(ethylene oxide) (PEO), that cannot penetrate cell membranes. Analyses of degraded PEOs by gel permeation chromatography showed that the fungus cleaved PEO rapidly by an endo route. 13C NMR analyses of unlabeled and perdeuterated PEOs recovered from G. trabeum cultures showed that a major route for depolymerization was oxidative C—C bond cleavage, a reaction diagnostic for hydrogen abstraction from a PEO methylene group by a radical oxidant. Fenton reagent (Fe(II)/H2O2) oxidized PEO by the same route in vitro and therefore might account for PEO biodegradation if it is produced by the fungus, but the data do not rule out involvement of less reactive radicals. The reactivity and extrahyphal location of this PEO-degrading system suggest that its natural function is to participate in the brown rot of wood and that it may enable brown-rot fungi to degrade recalcitrant organopollutants.

Heat-Shock-Induced Changes in Intracellular Ca2+ Level in Tobacco Seedlings in Relation to Thermotolerance1

Exposure of plants to elevated temperatures results in a complex set of changes in gene expression that induce thermotolerance and improve cellular survival to subsequent stress. Pretreatment of young tobacco (Nicotiana plumbaginifolia) seedlings with Ca2+ or ethylene glycol-bis(β-aminoethylether)-N,N,N′,N′-tetraacetic acid enhanced or diminished subsequent thermotolerance, respectively, compared with untreated seedlings, suggesting a possible involvement of cytosolic Ca2+ in heat-shock (HS) signal transduction. Using tobacco seedlings transformed with the Ca2+-sensitive, luminescent protein aequorin, we observed that HS temperatures induced prolonged but transient increases in cytoplasmic but not chloroplastic Ca2+. A single HS initiated a refractory period in which additional HS signals failed to increase cytosolic Ca2+. However, throughout this refractory period, seedlings responded to mechanical stimulation or cold shock with cytosolic Ca2+ increases similar to untreated controls. These observations suggest that there may be specific pools of cytosolic Ca2+ mobilized by heat treatments or that the refractory period results from a temporary block in HS perception or transduction. Use of inhibitors suggests that HS mobilizes cytosolic Ca2+ from both intracellular and extracellular sources.

Mimics of the binding sites of opioid receptors obtained by molecular imprinting of enkephalin and morphine.

Molecular imprinting of morphine and the endogenous neuropeptide [Leu5]enkephalin (Leu-enkephalin) in methacrylic acid-ethylene glycol dimethacrylate copolymers is described. Such molecular imprints possess the capacity to mimic the binding activity of opioid receptors. The recognition properties of the resultant imprints were analyzed by radioactive ligand binding analysis. We demonstrate that imprinted polymers also show high binding affinity and selectivity in aqueous buffers. This is a major breakthrough for molecular imprinting technology, since the binding reaction occurs under conditions relevant to biological systems. The antimorphine imprints showed high binding affinity for morphine, with Kd values as low as 10(-7) M, and levels of selectivity similar to those of antibodies. Preparation of imprints against Leu-enkephalin was greatly facilitated by the use of the anilide derivative rather than the free peptide as the print molecule, due to improved solubility in the polymerization mixture. Free Leu-enkephalin was efficiently recognized by this polymer (Kd values as low as 10(-7) M were observed). Four tetra- and pentapeptides, with unrelated amino acid sequences, were not bound. The imprints showed only weak affinity for two D-amino acid-containing analogues of Leu-enkephalin. Enantioselective recognition of the L-enantiomer of phenylalanylglycine anilide, a truncated analogue of the N-terminal end of enkephalin, was observed.