Olive growing in the arid valleys of Northwest Argentina (provinces of Catamarca, La Rioja and San Juan)

En este artículo se describe la situación del olivar en las provincias argentinas de Catamarca, La Rioja y San Juan.

Structure of Alluvial Valleys from 3-D Gravity Inversion: The Low Andarax Valley (Almería, Spain) Test Case

This paper presents a gravimetric study (based on 382 gravimetric stations in an area about 32 km2) of a nearly flat basin: the Low Andarax valley. This alluvial basin, close to its river mouth, is located in the extreme south of the province of Almería and coincides with one of the existing depressions in the Betic Cordillera. The paper presents new methodological work to adapt a published inversion approach (GROWTH method) to the case of an alluvial valley (sedimentary stratification, with density increase downward). The adjusted 3D density model reveals several features in the topography of the discontinuity layers between the calcareous basement (2,700 kg/m3) and two sedimentary layers (2,400 and 2,250 kg/m3). We interpret several low density alignments as corresponding to SE faults striking about N140?145°E. Some detected basement elevations (such as the one, previously known by boreholes, in Viator village) are apparently connected with the fault pattern. The outcomes of this work are: (1) new gravimetric data, (2) new methodological options, and (3) the resulting structural conclusions.

An analysis of installation of submarine pipelines

There are different methods of construction of outfall pipelines, all of them have to solve the problem of placing a tube over a known location in sea bed. This process has sometimes to be done in difficult conditions as waves, current or depths greater than 30 metres, where a diver cannot go safely beyond. Also the placement of the pipeline must be carried out without any damage to the tube, therefore a close control of the deflections and stresses in the structure must be performed. The importance of this control should be not diminished because a damage during the construction would imply a very difficult and expensive repair, that should be avoided with a proper design of the construction process. This paper is focused in the analysis of the tube during its placement according to a very well known construction method consisting in placing the tube from a boat, where all the connections between consecutive tube segments are performed, and also the whole process is controlled. This method is used for outfall as well as offshore pipelines, and it will be described in Section 2