Estudio experimental sobre la reacción álcali-sílice en el hormigón producida por áridos de reacción lenta

La finalidad de esta investigación se enmarca dentro de los estudios sobre hormigones de presas llevados a cabo en el Laboratorio Central de Estructuras y Materiales del CEDEX. En España se han diagnosticado 18 obras afectadas tanto por la reacción álcali-sílice de tipo rápido como por la de tipo lento. Dos de de las obras, fabricadas con áridos graníticos, no presentan signos de deterioro pero en laboratorio se han hallado productos expansivos. En las 16 presas españolas restantes, el hormigón de 10 de ellas estaba fabricado con áridos graníticos, de las cuales, 7 están afectadas por la reacción de tipo lento. Sin embargo, en las clasificaciones internacionales de las rocas potencialmente reactivas se establece habitualmente que las rocas graníticas son inocuas o de reactividad muy baja. En los casos puntuales encontrados en la literatura, la reactividad de este tipo de áridos se encuentra frecuentemente asociada al cuarzo microcristalino que contienen y ocasionalmente se asocia esta reactividad también al cuarzo deformado y/o microfisurado. En la tesis doctoral de Víctor Daniel Lanza Fernández, también realizada en el CEDEX, se han tratado los áridos de reacción rápida, dando una descripción detallada de los componentes que intervienen en este tipo de reacción y presentando un ensayo eficaz para su detección en el laboratorio. La investigación desarrollada en la presente tesis doctoral se ha centrado en los áridos de reacción lenta, mucho menos estudiados. A partir del estudio bibliográfico realizado sobre este tipo de reacción se ha detectado ciertas lagunas, basadas principalmente en la falta de un método de detección en el laboratorio para los áridos de reacción lenta. No se ha encontrado un procedimiento en el estudio petrográfico que sea fiable y cuantificable para este tipo de áridos. El ensayo acelerado de barras de mortero, que para los áridos de reacción rápida supone un método rápido y fiable, falla en la detección de los áridos de reacción lenta al aplicar los límites normalizados. Si bien en publicaciones recientes se ha propuesto la posibilidad de ampliar el tiempo de tratamiento hasta los 90 días, la duración del ensayo es más larga de lo deseado. Para resolver estas lagunas, se han tomado áridos de obras reales afectadas por la reacción álcali-sílice (en algún caso también de las canteras de donde se extrajeron los áridos para la ejecución), con lo que la reactividad de estos áridos queda demostrada por su comportamiento en obra. Al objeto de aumentar la muestra de ensayo y utilizar también áridos inocuos, se han tomado muestras de canteras, tanto en uso como abandonadas. Sobre estos áridos se ha realizado una caracterización completa con los ensayos actualmente disponibles para el estudio de su reactividad con los álcalis del cemento: estudio petrográfico, ensayo acelerado de barras de mortero y Gel-Pat modificado. En la investigación se ha desarrollado una metodología de tinción de geles álcali-sílice para la cuantificación de los mismos en el interior de las barras de mortero. Se ha relacionado el volumen de gel generado en la reacción con la expansión producida, tanto para áridos lentos, como rápidos, estableciendo analogías y diferencias en el comportamiento de ambos. La cuantificación de este tipo de compuestos realizada en las barras de mortero, abre la posibilidad de estudiar la capacidad expansiva que presentan en testigos de hormigón de obras afectadas. Este dato podría ser una herramienta importante para el desarrollo de modelos matemáticos que puedan predecir el futuro comportamiento de las estructuras afectadas por la reacción álcali-sílice. La tinción ha sido asimismo utilizada para establecer un método de detección de áridos reactivos basado en el ensayo de Gel-Pat modificado. La metodología de detección propuesta para estos áridos es cuantitativa y proporciona los resultados en 14 días, suponiendo una ventaja importante sobre los métodos actuales, que permiten detectarlos en 90 días (de forma orientativa en 56 días). This research is part of the studies on durability of concrete dams carried out in the Laboratorio Central de Estructuras y Materiales of CEDEX during the last years. At the present time, 18 public works affected by alkali-silica reaction have been diagnosed in Spain. In 12 of them the concrete was mixed with granitic aggregates, 7 of which were damaged by the slow alkali-silica reaction, 3 by the rapid alkali-silica reaction and in the other 2 cases, although there was no visual evidence of the reaction in field, the laboratory tests showed the presence of expansive products inside the concrete. However, in the international classifications of potentially reactive aggregates granitic rocks are pointed out as innocuous or as low reactivity and usually their reactivity is attributed to the presence of microcrystalline quartz and occasionally with the strained and microcracked quartz. The rapid reactive aggregates were deeply studied in a previous research (Víctor Daniel Lanza’s Thesis) also carried out in CEDEX. In this research, a detailed description of the components involved in the rapid alkali-silica reaction was given. Also, a fast method to detect them in the laboratory was developed. The research of the present PhD Thesis is focused in the slow-reactive aggregates, much less studied. The state of the art has shown some gaps in the knowledge about this reaction, mainly the absence of a reliable method to detect slow-reactive aggregates. On one side, there is no systematic and quantitative petrographic test for these aggregates. On the other side, the accelerated mortar bar test has been proved to be effective to detect rapid reactive aggregates but the standard limits fail in the detection of the slowreactive aggregates. In recent investigations it has been proposed extending the test until 90 days, but this period is considered too long. In this research, aggregates taken from affected structures have been used in the test, so their reactivity has been shown in practice. With the aim of increasing the number of samples aggregates from quarries have been also used. A method to stain alkali-silica gels has been applied to mortar bars, thereby quantifying the volume of gel generated inside. This volume has been related to the expansion of the bars, both for rapid for slow reactive aggregates, establishing similarities and differences. The quantification of the gel volume, applied to concrete cores extracted from affected structures, could be an important tool in mathematical models to predict the future behaviour of the structures affected by the alkali-silica reaction. The staining method has been also used to develop a method to detect slow reactive aggregates, based on the optimised Gel-Pat test, obtaining results in 14 days. This represents a major improvement compared to the actual methods (accelerated mortar bar test) which give an indicative value of reactivity at 56 days, and a final result at 90 days.

Contribution to the Analysis, Design and Assessment of Compact Antenna Test Ranges At Millimeter Wavelengths - Contribución al Análisis, Diseño y Caracterización de Sistemas de Medida de Antenas en Rango Compacto para Frecuencias Milimétricas

This Doctoral Thesis entitled Contribution to the analysis, design and assessment of compact antenna test ranges at millimeter wavelengths aims to deepen the knowledge of a particular antenna measurement system: the compact range, operating in the frequency bands of millimeter wavelengths. The thesis has been developed at Radiation Group (GR), an antenna laboratory which belongs to the Signals, Systems and Radiocommunications department (SSR), from Technical University of Madrid (UPM). The Radiation Group owns an extensive experience on antenna measurements, running at present four facilities which operate in different configurations: Gregorian compact antenna test range, spherical near field, planar near field and semianechoic arch system. The research work performed in line with this thesis contributes the knowledge of the first measurement configuration at higher frequencies, beyond the microwaves region where Radiation Group features customer-level performance. To reach this high level purpose, a set of scientific tasks were sequentially carried out. Those are succinctly described in the subsequent paragraphs. A first step dealed with the State of Art review. The study of scientific literature dealed with the analysis of measurement practices in compact antenna test ranges in addition with the particularities of millimeter wavelength technologies. Joint study of both fields of knowledge converged, when this measurement facilities are of interest, in a series of technological challenges which become serious bottlenecks at different stages: analysis, design and assessment. Thirdly after the overview study, focus was set on Electromagnetic analysis algorithms. These formulations allow to approach certain electromagnetic features of interest, such as field distribution phase or stray signal analysis of particular structures when they interact with electromagnetic waves sources. Properly operated, a CATR facility features electromagnetic waves collimation optics which are large, in terms of wavelengths. Accordingly, the electromagnetic analysis tasks introduce an extense number of mathematic unknowns which grow with frequency, following different polynomic order laws depending on the used algorithmia. In particular, the optics configuration which was of our interest consisted on the reflection type serrated edge collimator. The analysis of these devices requires a flexible handling of almost arbitrary scattering geometries, becoming this flexibility the nucleus of the algorithmia’s ability to perform the subsequent design tasks. This thesis’ contribution to this field of knowledge consisted on reaching a formulation which was powerful at the same time when dealing with various analysis geometries and computationally speaking. Two algorithmia were developed. While based on the same principle of hybridization, they reached different order Physics performance at the cost of the computational efficiency. Inter-comparison of their CATR design capabilities was performed, reaching both qualitative as well as quantitative conclusions on their scope. In third place, interest was shifted from analysis - design tasks towards range assessment. Millimetre wavelengths imply strict mechanical tolerances and fine setup adjustment. In addition, the large number of unknowns issue already faced in the analysis stage appears as well in the on chamber field probing stage. Natural decrease of dynamic range available by semiconductor millimeter waves sources requires in addition larger integration times at each probing point. These peculiarities increase exponentially the difficulty of performing assessment processes in CATR facilities beyond microwaves. The bottleneck becomes so tight that it compromises the range characterization beyond a certain limit frequency which typically lies on the lowest segment of millimeter wavelength frequencies. However the value of range assessment moves, on the contrary, towards the highest segment. This thesis contributes this technological scenario developing quiet zone probing techniques which achieves substantial data reduction ratii. Collaterally, it increases the robustness of the results to noise, which is a virtual rise of the setup’s available dynamic range. In fourth place, the environmental sensitivity of millimeter wavelengths issue was approached. It is well known the drifts of electromagnetic experiments due to the dependance of the re sults with respect to the surrounding environment. This feature relegates many industrial practices of microwave frequencies to the experimental stage, at millimeter wavelengths. In particular, evolution of the atmosphere within acceptable conditioning bounds redounds in drift phenomena which completely mask the experimental results. The contribution of this thesis on this aspect consists on modeling electrically the indoor atmosphere existing in a CATR, as a function of environmental variables which affect the range’s performance. A simple model was developed, being able to handle high level phenomena, such as feed - probe phase drift as a function of low level magnitudes easy to be sampled: relative humidity and temperature. With this model, environmental compensation can be performed and chamber conditioning is automatically extended towards higher frequencies. Therefore, the purpose of this thesis is to go further into the knowledge of millimetre wavelengths involving compact antenna test ranges. This knowledge is dosified through the sequential stages of a CATR conception, form early low level electromagnetic analysis towards the assessment of an operative facility, stages for each one of which nowadays bottleneck phenomena exist and seriously compromise the antenna measurement practices at millimeter wavelengths.

Using quantitative descriptive analysis and temporal dominance of sensations analysis as complementary methods for profiling commercial blackcurrant squashes

Quantitative descriptive analysis (QDA) is used to describe the nature and the intensity of sensory properties from a single evaluation of a product, whereas temporal dominance of sensation (TDS) is primarily used to identify dominant sensory properties over time. Previous studies with TDS have focused on model systems, but this is the first study to use a sequential approach, i.e. QDA then TDS in measuring sensory properties of a commercial product category, using the same set of trained assessors (n = 11). The main objectives of this study were to: (1) investigate the benefits of using a sequential approach of QDA and TDS and (2) to explore the impact of the sample composition on taste and flavour perceptions in blackcurrant squashes. The present study has proposed an alternative way of determining the choice of attributes for TDS measurement based on data obtained from previous QDA studies, where available. Both methods indicated that the flavour profile was primarily influenced by the level of dilution and complexity of sample composition combined with blackcurrant juice content. In addition, artificial sweeteners were found to modify the quality of sweetness and could also contribute to bitter notes. Using QDA and TDS in tandem was shown to be more beneficial than each just on its own enabling a more complete sensory profile of the products.

Preliminary temperature Accelerated Life Test (ALT) on III-V commercial concentrator triple-junction solar cells

A quantitative temperature accelerated life test on sixty GaInP/GaInAs/Ge triple-junction commercial concentrator solar cells is being carried out. The final objective of this experiment is to evaluate the reliability, warranty period, and failure mechanism of high concentration solar cells in a moderate period of time. The acceleration of the degradation is realized by subjecting the solar cells at temperatures markedly higher than the nominal working temperature under a concentrator Three experiments at three different temperatures are necessary in order to obtain the acceleration factor which relates the time at the stress level with the time at nominal working conditions. . However, up to now only the test at the highest temperature has finished. Therefore, we can not provide complete reliability information but we have analyzed the life data and the failure mode of the solar cells inside the climatic chamber at the highest temperature. The failures have been all of them catastrophic. In fact, the solar cells have turned into short circuits. We have fitted the failure distribution to a two parameters Weibull function. The failures are wear-out type. We have observed that the busbar and the surrounding fingers are completely deteriorate

Quantitative assessment based on kinematic measures of functional impairments during upper extremity movements: a review

Quantitative measures of human movement quality are important for discriminating healthy and pathological conditions and for expressing the outcomes and clinically important changes in subjects' functional state. However the most frequently used instruments for the upper extremity functional assessment are clinical scales, that previously have been standardized and validated, but have a high subjective component depending on the observer who scores the test. But they are not enough to assess motor strategies used during movements, and their use in combination with other more objective measures is necessary. The objective of the present review is to provide an overview on objective metrics found in literature with the aim of quantifying the upper extremity performance during functional tasks, regardless of the equipment or system used for registering kinematic data.

Impact of using new commercial glutathione enriched inactive dry yeast oenological preparations on the aroma and sensory properties of wines

The effect of the addition of a commercial enriched glutathione inactive dry yeast oenological preparation in the volatile and sensory properties of industrially manufactured rosé Grenache wines was evaluated during their shelf-life. In addition, triangle tests were performed at different times during wine aging (among 1 and 9 months) to determine the sensory differences between wines with and without glutathione inactive dry yeast preparations. Descriptive sensory analysis with a trained panel was carried out when sensory differences in the triangle test were noticed. In addition, consumer tests were performed in order to investigate consumers’ acceptability of wines. Results revealed significant sensory differences between control and glutathione inactive dry yeast wines after 9 months of aging. At that time, glutathione inactive dry yeast wines were more intense in fruity aromas (strawberry, banana) and less intense in yeast notes than control wine. The impact of the glutathione inactive dry yeast in the aroma might be the consequence of different effects that these preparations could induce in wine composition: modification of yeast byproducts during fermentation, release of volatile compounds from inactive dry yeast, interaction of wine volatile compounds with yeast macromolecules from inactive dry yeast and a possible antioxidant effect of the glutathione released by the inactive dry yeast preparation on some specific volatile compounds.