Detection and Isolation of Simultaneous Additive and Parametric Faults in Nonlinear Stochastic Dynamical Systems

This paper presents a new fault detection and isolation scheme for dealing with simultaneous additive and parametric faults. The new design integrates a system for additive fault detection based on Castillo and Zufiria, 2009 and a new parametric fault detection and isolation scheme inspired in Munz and Zufiria, 2008 . It is shown that the so far existing schemes do not behave correctly when both additive and parametric faults occur simultaneously; to solve the problem a new integrated scheme is proposed. Computer simulation results are presented to confirm the theoretical studies.

Isolation of recombinant antibody fragments (scFv) by phage display technology for detection of almond allergens in food products

Tree nut allergies are considered an important health issue in developed countries. To comply with the regulations on food labeling, reliable allergen detection methods are required. In this work we isolated almond-specific recombinant antibody fragments (scFv) from a commercial phage display library bypassing the use of live animals, hence being consistent with the latest policies on animal welfare. To this end an iterative selection procedure employing the Tomlinson I phage display library and a crude almond protein extract was carried out. Two different almond-specific scFv (named PD1F6 and PD2C9) were isolated after two rounds of biopanning, and an indirect phage ELISA was implemented to detect the presence of almond protein in foodstuffs. The isolated scFvs demonstrated to be highly specific and allowed detection of 40 ng mL?1 and 100 ng mL?1 of raw and roasted almond protein, respectively. The practical detection limit of the assay in almond spiked food products was 0.1 mg g?1 (110e120 ppm). The developed indirect phage ELISA was validated by analysis of 92 commercial food products, showing good correlation with the results obtained by a previously developed real-time PCR method for the detection of almond in foodstuffs. The selected phage clones can be affinity maturated to improve their sensitivity and genetically engineered to be employed in different assay formats.

Characterization of Amorphous Tantalum Oxide for Insulating Acoustic Mirrors

This work describes the assessment of the acoustic properties of sputtered tantalum oxide films intended as high impedance films for the acoustic isolation of bulk acoustic wave devices operating in the GHz frequency range. The films are grown by sputtering a metallic tantalum target under different oxygen and argon gas mixtures, total pressures, pulsed DC powers and substrate bias. The structural properties of the films are assessed through infrared absorption spectroscopy and X-ray diffraction measurements. Their acoustic impedance is obtained after estimating the mass density by X-ray reflectometry measurements and the longitudinal acoustic velocity by analyzing the longitudinal λ/2 resonance induced in a tantalum oxide film inserted between an acoustic reflector and an AlN-based resonator. A second measurement of the sound velocity is achieved through picosecond acoustic spectroscopy.

High isolation series-shunt photoconductive microwave switch

This article presents a wide band compact high isolation photoconductive switch, which is based on the series-shunt switch design with three photoconductive switches made of diced high-resistivity silicon wafer placed over a microstrip gap and activated by 808-nm near-infrared laser diodes. The switch shows an insertion loss of 1.2 dB and an isolation of 44.8 dB at 2 GHz. It is easy to operate and control by light, high-speed, electromagnetically transparent and it does not require any biasing circuits.