Secundary school profile in science and technology versus the first year at the Technical University of Madrid. Cause of failure or quitting?

Se analiza el absentismo, el fallo y el abandono de los estudiantes en los primeros semestres del grado sobre la base de su formación en la educación secundaria.

Instituto de Sistemas Fotovoltaicos de Concentración concentration photovoltaics hybrid system first year of operation and improvements

A photovoltaic (PV) hybrid system combines PV with other forms of electricity generation, usually a diesel generator. The system presented in this paper uses concentration photovoltaic (CPV) as the main generator in combination with a storage system and the grid, configured as the backup power supply. The load of the system consists of an air conditioning system of an office building. This paper presents the results obtained from the first months of operation of the CPV hybrid system installed at Instituto de Sistemas Fotovoltaicos de Concentración facilities together with exhaustive simulations in order to model the system behaviour and be able to improve the self-consumption ratio. This system represents a first approach to the use of a CPV in office buildings complemented by an existing AC-coupled hybrid system. The contribution of this paper to the analysis of this new system and the existing tools available for its simulation, at least a part of it, can be considered as a starting point for the development of these kinds of systems.

Chemistry Education around the World: The First-Year Experience

En este trabajo se analizan y discuten las similitudes en el primer año de enseñanza de la química a nivel universitario en diferentes países. Este aspecto es una base fundamental que deben considerar, tanto profesores como alumnos, en programas de intercambio.

Compatison of S-SI, A-SI and CDTE technologies wording at the same conditions, after the first year of electricity production

Grid connected solar plants are a good opportunity for their use for research as a secondary objective. In countries were feed-in tariffs are still active, it is possible to include in the design of the solar plant elements for its use for research. In the case of the solar plant presented here both objectives are covered. The solar plant of this work is formed by PV modules of three different technologies: Multicrystalline, amorphous and CdTe. In one part of the solar plant, the three technologies are working at the same conditions, not only ambient conditions but also similar voltage and current input to the inverters. Both the commercial and the experimental parts of the solar plant have their own independent inverters with their meters but are finally connected to the same meter to inject. In this work we analyse the results for the first year of operation of the experimental solar plant. Productions of three different technologies in exactly the same conditions are compared and presented. According to the results, all the three technologies have conversion efficiencies dropping when the temperature increases. Amorphous module experiences the lesser reduction, whereas the multicrystalline module suffers the most.

Assessing Creativity In Engineering Students: A Comparative Between Degrees and Sudents In First And Last Year

An online open access test (CREAX self-assessment) has been used in this work so that students from degrees in engineering in the Universidad Polite¿cnica of Madrid (UPM) could self-assess their creative competence after several classroom activities. Different groups from the first year course have been statistically compared using data from their assessment. These first year students had different professors in the subject ?Technical Drawing? and belonged to several degrees in the UPM. They were as well compared regarding sex and a group of first year students was also compared to another last year group of the degree so as to observe possible differences in the achievement of this competence. Only one difference was detected concerning sex in one of the degrees. Among degrees, the higher marks obtained by students who had done specific exercises for the development of creativity in class is highlighted. Finally, a significantly high mark was observed in students during their last year of degree with respect to first year students. The tool CREAX has become very useful in the assessment of this competence in the UPM degrees in which it has been implemented.

Study about the Problem of Dropping of Subjects by Students During an Academinc Year at the University.

In university studies, it is not unusual for students to drop some of the subjects they have enrolled in for the academic year. They start by not attending lectures, sometimes due to neglect or carelessness, or because they find the subject too difficult, this means that they lose the continuity in the topics that the professor follows. If they try to attend again they discover that they hardly understand anything and become discouraged and so decide to give up attending lectures and study on their own. However some fail to turn up to do their final exams and the failure rate of those who actually do the exams is high. The problem is that this is not only the case with one specific subject, but it is often the same with many subjects. The result is that students arent’s productive enough, wasting time and also prolonging their years of study which entails a great cost for families. Degree courses structured to be conducted and completed in three academic courses, it may in fact take up to an average of six or more academic courses. In this paper, we have studied this problem, which apart from the waste of money and time, produces frustration in the student, who finds that he has not been able to achieve what he had proposed at the beginning of the course. It is quite common, to find students who do not even pass nor 50% of the subjects they had enrolled in for the academic year. If this happens repeatedly to a student, it can be the point when he considers dropping out altogether. This is also a concern for the universities, especially in the early courses. In our experience as professors, we have found that students, who attend lectures regularly and follow the explanations, approach the final exams with confidence and rarely fail the subject. In this proposal we present some techniques and methods carried out to solve in possible, the problem of lack of attendance to lectures. This involves "rewarding students for their assistance and participation in lectures". Rewarding assistance with a "prize" that counts for the final mark on the subject and involving more participation in the development of lectures. We believe that we have to teach students to use the lectures as part of their learning in a non-passive way. We consider the professor's work as fundamental in terms of how to convey the usefulness of these topics explained and the applications that they will have for their professional life in the future. In this way the student see for himself the use and importance of what he is learning. When his participation is required, he will feel more involved and confident participating in the educational system. Finally we present statistical results of studies carried out on different degrees and on different subjects over two consecutive years. In the first year we assessed only the final exams without considering the students attendance, or participation. In the second year, we have applied the techniques and methods proposed here. In addition we have compared the two ways of assessing subjects.