Preparation and characterization of stable aqueous suspensions of up-converting Er3+/Yb3+-doped LiNbO3 nanocrystals

The preparation of LiNbO3:Er3+/Yb3+ nanocrystals and their up-conversion properties have been studied. It is demonstrated that polyethyleneimine- (PEI) assisted dispersion procedures allow obtaining stable aqueous LiNbO3:Er3+/Yb3+ powder suspensions, with average size particles well below the micron range (100–200 nm) and the isoelectric point of the suspension reaching values well above pH 7. After excitation of Yb3+ ions at a wavelength of 980 nm, the suspensions exhibit efficient, and stable, IR-to-visible (green and red) up-conversion properties, easily observed by the naked eye, very similar to those of the starting crystalline bulk material.

Embryogenic suspensions of adult cork oak: the first step towards mass propagation.

Abstract Protocols have been established to clone adult cork oak trees by somatic embryogenesis using semisolid medium. However, for economically viable mass propagation, embryogenic cultures in liquid medium need to be developed. In this study, suspension cultures were initiated from embryo clusters obtained by secondary embryogenesis on a gelled medium lacking plant growth regulators. After 6 days of culture, these embryo clusters generated high cell density suspensions that also contained small organized structures (embryos and embryogenic clumps). As the culture duration increased, tissue necrosis and fewer embryogenic structures were observed and the establishment of suspension cultures failed. An alternative method was found adequate for initiation of embryogenic suspensions: embryo clusters from gelled medium were briefly shaken in liquid medium and detached cells and embryogenic masses of 41?800 lm were used as inoculum. Maintenance of embryogenic suspensions was achieved using a low-density inoculum (43 mg l-1) by subculturing four embryogenic clumps of 0.8?1.2 mm per 70 ml of medium. Proliferation ability was maintained for almost 1 year through ten consecutive subcultures. The initiation and maintenance protocols first developed for a single genotype were effective when tested on 11 cork oak genotypes.

Electrophoretic Deposition of Transparent ZnO Thin Films from Highly Stabilized Colloidal Suspensions

The parameters that control the stability of ZnO-nanoparticles suspensions and their deposition by electrophoretic deposition were studied, so as to organize the assembly and compaction of nanoparticles. The addition of cationic polyelectrolyte - Polyethylenimine (PEI) - with different molecular weights was investigated, in order to study their effectiveness and the influence of the molecular weight of the organic chain on suspensions dispersion. It was found that PEI with the highest molecular weight provided better dispersion conditions. Cathodic EPD was performed under previously optimized suspensions conditions and over electropolished stainless steel substrates. Experimental results showed that the EPD process in these conditions allows obtaining dense transparent ZnO thin films. Deposition times and intensities were optimized by analyzing the resulting thin films characteristics. Finally, the deposits were characterized by FE-SEM, AFM, and different spectroscopic techniques.

Photoacoustic effect measurement in aqueous suspensions of gold nanorods caused by low-frequency and low-power near-infrared pulsing laser irradiation

When aqueous suspensions of gold nanorods are irradiated with a pulsing laser (808 nm), pressure waves appear even at low frequencies (pulse repetition rate of 25 kHz). We found that the pressure wave amplitude depends on the dynamics of the phenomenon. For fixed concentration and average laser current intensity, the amplitude of the pressure waves shows a trend of increasing with the pulse slope and the pulse maximum amplitude.We postulate that the detected ultrasonic pressure waves are a sort of shock waves that would be generated at the beginning of each pulse, because the pressure wave amplitude would be the result of the positive interference of all the individual shock waves.

Assessment of the influence of the elastic properties of rail vehicle suspensions on safety, ride quality and track fatigue

A sensitivity analysis has been performed to assess the influence of the elastic properties of railway vehicle suspensions on the vehicle dynamic behaviour. To do this, 144 dynamic simulations were performed modifying, one at a time, the stiffness and damping coefficients, of the primary and secondary suspensions. Three values were assigned to each parameter, corresponding to the percentiles 10, 50 and 90 of a data set stored in a database of railway vehicles.After processing the results of these simulations, the analyzed parameters were sorted by increasing influence. It was also found which of these parameters could be estimated with a lesser degree of accuracy in future simulations without appreciably affecting the simulation results. In general terms, it was concluded that the highest influences were found for the longitudinal stiffness and the lateral stiffness of the primary suspension, and the lowest influences for the vertical stiffness and the vertical damping of the primary suspension, with the parameters of the secondary suspension showing intermediate influences between them.

Analysis of concurrent constraint logic programs with a fixed scheduling rule

The analysis of concurrent constraint programs is a challenge due to the inherently concurrent behaviour of its computational model. However, most implementations of the concurrent paradigm can be viewed as a computation with a fixed scheduling rule which suspends some goals so that their execution is postponed until some condition awakens them. For a certain kind of properties, an analysis defined in these terms is correct. Furthermore, it is much more tractable, and in addition can make use of existing analysis technology for the underlying fixed computation rule. We show how this can be done when the starting point is a framework for the analysis of sequential programs. The resulting analysis, which incorporates suspensions, is adequate for concurrent models where concurrency is localized, e.g. the Andorra model. We refine the analysis for this particular case. Another model in which concurrency is preferably encapsulated, and thus suspensions are local to parts of the computation, is that of CIAO. Nonetheless, the analysis scheme can be generalized to models with global concurrency. We also sketch how this could be done, and we show how the resulting analysis framework could be used for analyzing typical properties, such as suspensión freeness.

Análisis molecular de sistemas génicos implicados en la homeostasis de níquel y eficiencia simbiótica en Rhizobium leguminosarum

Los suelos ultramáficos, que poseen elevadas concentraciones de níquel, cobalto y cromo de manera natural, son fuente de bacterias resistentes a altas concentraciones de metales. Se realizó la caracterización físico-química de seis suelos ultramáficos del suroeste europeo, seleccionándose un suelo de la región de Gorro, Italia, como el más adecuado para aislar bacterias endosimbióticas resistentes a metales. A partir de plantas-trampa de guisante y lenteja inoculados con suspensiones de ese suelo, se obtuvieron 58 aislados de Rhizobium leguminosarum bv. viciae (Rlv) que fueron clasificados en 13 grupos según análisis de PCR-RAPDs. Se determinó la resistencia a cationes metálicos [Ni(II), Co(II), Cu(II), Zn(II)] de una cepa representante de cada grupo, así como la secuencia de los genomas de las cepas que mostraron altos niveles (UPM1137 y UPM1280) y bajos niveles (UPM1131 y UPM1136) de tolerancia a metales. Para identificar mecanismos de resistencia a metales se realizó una mutagénesis al azar en dicha cepa mediante la inserción de un minitransposón. El análisis de 4313 transconjugantes permitió identificar 14 mutantes que mostraron una mayor sensibilidad a Ni(II) que la cepa silvestre. Se determinó el punto de inserción del minitransposón en todos ellos y se analizaron en más detalle dos de los mutantes (D2250 y D4239). En uno de los mutantes (D2250), el gen afectado codifica para una proteína que presenta un 44% de identidad con dmeF (divalent efflux protein) de Cupriavidus metallidurans. Cadena arriba de dmeF se identificó un gen que codifica una proteína con un 39% de identidad con el regulador RcnR de Escherichia coli. Se decidió nombrar a este sistema dmeRF, y se generó un mutante en ambos genes en la cepa Rlv SPF25 (Rlv D15). A partir de experimentos de análisis fenotípico y de regulación se pudo demostrar que el sistema dmeRF tiene un papel relevante en la resistencia a Ni(II) y sobre todo a Co(II) en células en vida libre y en simbiosis con plantas de guisante. Ambos genes forman un operón cuya expresión se induce en respuesta a la presencia de Ni(II) y Co(II). Este sistema se encuentra conservado en distintas especies del género Rhizobium como un mecanismo general de resistencia a níquel y cobalto. Otro de los mutantes identificados (D4239), tiene interrumpido un gen que codifica para un regulador transcripcional de la familia AraC. Aunque inicialmente fue identificado por su sensibilidad a níquel, experimentos posteriores demostraron que su elevada sensibilidad a metales era debida a su sensibilidad al medio TY, y más concretamente a la triptona presente en el medio. En otros medios de cultivo el mutante no está afectado específicamente en su tolerancia a metales. Este mutante presenta un fenotipo simbiótico inusual, siendo inefectivo en guisantes y efectivo en lentejas. Análisis de complementación y de mutagénesis dirigida sugieren que el fenotipo de la mutación podría depender de otros factores distintos del gen portador de la inserción del minitransposón. ABSTRACT Ultramafic soils, having naturally high concentrations of nickel, cobalt and chrome, are potential sources of highly metal-resistant bacteria. A physico-chemical characterization of six ultramafic soils from the European southwest was made. A soil from Gorro, Italy, was chosen as the most appropriated for the isolation of heavy-metal-resistant endosymbiotic bacteria. From pea and lentil trap plants inoculated with soil suspensions, 58 isolates of Rhizobium leguminosarum bv. viciae (Rlv) were obtained and classified into 13 groups based on PCR-RAPDs analysis. The resistance to metallic cations [Ni(II), Co(II), Cu(II), Zn(II)] was analyzed in a representative strain of each group. From the results obtained in the resistance assays, the Rlv UPM1137 strain was selected to identify metal resistance mechanism. A random mutagenesis was made in UPM1137 by using minitransposon insertion. Analysis of 4313 transconjugants allowed to identify 14 mutants with higher sensitivity to Ni(II) than the wild type strain. The insertion point of the minitransposon was determined in all of them, and two mutants (D2250 and D4239) were studied in more detail. In one of the mutants (D2250), the affected gene encodes a protein with 44% identity in compared with DmeF (divalent efflux protein) from Cupriavidus metallidurans. Upstream R. leguminosarum dmeF, a gene encoding a protein with 39% identity with RcnR regulator from E. coli was identified. This protein was named DmeR. A mutant with both genes in the dmeRF deleted was generated and characterized in Rlv SPF25 (Rlv D15). From phenotypic and regulation analysis it was concluded that the dmeRF system is relevant for Ni(II) and specially Co(II) tolerance in both free living and symbiotic forms of the bacteria. This system is conserved in different Rhizobium species like a general mechanism for nickel and cobalt resistance. Other of the identified mutants (D4239) contains the transposon insert on a gene that encodes for an AraC-like transcriptional regulator. Although initially this mutant was identified for its nickel sensitivity, futher experiments demonstrated that its high metal sensitivity is due to its sensitivity to the TY medium, specifically for the tryptone. In other media the mutant is not affected specifically in their tolerance to metals. This mutant showed an unusual symbiotic phenotype, being ineffective in pea and effective in lentil. Complementation analysis and directed mutagenesis suggest that the mutation phenotype could depend of other factors different from the insertion minitransposon gene.

Thermodynamic aproach to particle size distribution in granular media

The study of particulate systems is of great interest in many fields of science and technology. Soil, sediments, powders, granular materials, colloidal and particulate suspensions are examples of systems involving many size particles. For those systems, the statistical description of the particle size distribution (PSD), that is, the mathematical distribution that defines the relative amounts of particles present, sorted according to size, is a crutial issue. The PSD can be important in understanding soil hydraulic properties, the geological origin or sediments or the physical and chemical properties of granular materials and ceramics, among others.