Potencial del cultivo de la chumbera (Opuntia ficus-indica (L) Miller) para la obtención de biocombustibles

El presente trabajo trata sobre el potencial del cultivo de chumbera (Opuntia ficus-indica (L) Miller) para la obtención de dos biocombustibles: bioetanol y biogás. Para lograr este objetivo se ha estudiado, por una parte, el empleo de procedimientos orientados a la producción de bioetanol no celulósico a partir de cladodios de chumbera, lo que ha dado como resultado rendimientos de entre 156 y 221 litros de etanol por cada tonelada de materia seca de biomasa, y, por otra, la obtención de biogás mediante la digestión anaeróbica de los mismos en régimen mesófilo, donde se han hallado rendimientos en torno a 198 m3 de metano por tonelada de materia seca. Una vez determinado el potencial de la materia prima se han diseñado procesos para una escala industrial que permitan la transformación de los cladodios de chumbera en ambos biocombustibles y se han determinado sus balances energéticos, los cuales han dado como resultado la autosuficiencia de ambos procesos, obteniéndose, además, un excedente térmico de 1.235 kcal L-1 de etanol producido, y en torno a 140 kep de energía total (térmica + eléctrica) por tonelada de materia seca empleada en la digestión anaeróbica. Por último se ha estimado el potencial de producción de ambos combustibles en un área apta para el cultivo de la chumbera. En concreto, este estudio se ha llevado a cabo para la provincia de Almería, elegida por tratarse de una zona con cierta tradición en el manejo de esta planta y presentar un clima semiárido mediterráneo. La superficie apta para el cultivo de la chumbera en esta provincia se ha estimado en 100.616 ha y el rendimiento medio del cultivo en 5 t MS ha-1 año-1. En el caso del bioetanol esto implicaría un potencial de producción en torno a 82.158 m3 año-1 que podrían dar lugar a la creación de dos macrodestilerías (con una producción de 100.000 L diarios) o de 49 microdestilerías (con 5.000 L diarios de producción). Si se optara por la transformación de la biomasa de chumbera en metano, podrían obtenerse 99,4 M de metros cúbicos, lo cual permitiría el establecimiento de 79 plantas de cogeneración de 500 kW cada una. ABSTRACT The present work deals with the potential of prickly pear (Opuntia ficus-indica (L) Mill.) biomass as a feedstock for bioethanol and biogas. In order to reach this objective different procedures aiming at the production of non-cellulosic bioethanol from cladodes were carried out; yields from156 to 221 litres of bioethanol per ton of dry matter were found. Mesophilic anaerobic digestion of cladodes was also studied and yields around 198 m3 of methane per ton of dry matter were reached. From these results, processes on an industrial scale were designed for both pathways of energy conversion of prickly-pear biomass and the respective energy balances were calculated. They resulted to be self-sufficient from an energetic point of view; the bioethanol pathway generated a thermal energy surplus of 1,235 kcal per litre of ethanol, while around 140 kep of total energy (heat + electricity) were obtained from the anaerobic digestion of one ton of dry cladodes. Finally, the potential production of both biofuels from prickly pear biomass was estimated for a specific area. The province of Almeria was chosen because of its climate conditions and the previous existence of prickly pear plantations. The area suitable for prickly pear cultivation in the province was estimated at a maximum of 100.616 ha, with an average yield of about 5 t DM ha-1 year-1. If prickly pear biomass were cropped for bioethanol in Almeria, the potential production of bioethanol could reach 82,158 m3 year-1, in either two macrodistilleries (100,000 L day-1) or 49 microdestilleries (5,000 L day-1). If the biogas pathway were preferred, 99. 4 Mm3 of methane could be reached and this would represent 79 CHP plants (500 kW each one).

Experimental determination of some physical properties of gasoline,ethanol and ETBE ternary blends

The addition of oxygenated renewable fuels, such as ethanol or ethyl tert-butyl ether (ETBE) to standard gasoline may be necessary to comply with some environmental directives but could also prevent compliance with some fuel regulations and could also seriously change engine performance. From this point of view, the Reid Vapour Pressure (RVP), the distillation curve, the oxygen content and the density belong to the group of the most relevant parameters. This study evaluates the influence of the simultaneous addition of ethanol and ETBE on some physical properties of engine gasoline. The main conclusion is that the simultaneous addition of ETBE and ethanol changes the RVP, the distillation curve and the density in a way that can affect engine operation and the mandatory EN 228 and ASTM D4814 standards. Some opposite properties of both oxygenates could help to increase the renewable energy content without preventing compliance with these regulations.

Production of biodiesel from animal fat using supercritical ethanol

Biodiesel is currently produced from a catalytic transesterification reaction of various types of edible and non-edible oil with methanol. The use of waste animal tallow instead of edible oils opens a route to recycle this waste. This material has the advantage of lower costs but the problem of high content of free fatty acids, becoming necessary a pre-esterification reaction that increases the cost of the catalytic process. The production of biodiesel using supercritical alcohols is appropriate for materials with high acidity and water content, therefore the use of this process with animal fat is a promising alternative. Ethanol has been used because it can be produced from biomass via fermentation resulting in a complete renewable biodiesel, instead of methanol that derives from fossil feedstocks. Two different processes have been studied: first, the direct transesterification of animal fat using supercritical ethanol and second a two-step process where the first step is a hydrolysis of the animal fat and the second step is the esterification of the resulting fatty acids. The temperature, the molar ratio ethanol:fat and the time have been modified in the different reactions to study the effect in the final conversion and the degradation of the unsaturated fatty acid esters, main inconvenient of these high temperature and pressure processes.