Association of breakfast consumption with objectively measured and self-reported physical activity, sedentary time and physical fitness in European adolescents: the HELENA (Healthy Lifestyle in Europe by Nutrition in Adolescence) Study

Objective: To examine the association of breakfast consumption with objectively measured and self-reported physical activity, sedentary time and physical fitness. Design: The HELENA (Healthy Lifestyle in Europe by Nutrition in Adolescence) Cross-Sectional Study. Breakfast consumption was assessed by two non-consecutive 24 h recalls and by a ‘Food Choices and Preferences’ questionnaire. Physical activity, sedentary time and physical fitness components (cardiorespiratory fitness, muscular fitness and speed/agility) were measured and self-reported. Socio-economic status was assessed by questionnaire. Setting: Ten European cities. Subjects: Adolescents (n 2148; aged 12?5–17?5 years). Results: Breakfast consumption was not associated with measured or self-reported physical activity. However, 24 h recall breakfast consumption was related to measured sedentary time in males and females; although results were not confirmed when using other methods to assess breakfast patterns or sedentary time. Breakfast consumption was not related to muscular fitness and speed/agility in males and females. However, male breakfast consumers had higher cardiorespiratory fitness compared with occasional breakfast consumers and breakfast skippers, while no differences were observed in females. Overall, results were consistent using different methods to assess breakfast consumption or cardiorespiratory fitness (all P#0?005). In addition, both male and female breakfast skippers (assessed by 24 h recall) were less likely to have high measured cardiorespiratory fitness compared with breakfast consumers (OR50?33; 95% CI 0?18, 0?59 and OR50?56; 95 %CI 0?32, 0?98,respectively). Results persisted across methods. Conclusions: Skipping breakfast does not seem to be related to physical activity,sedentary time or muscular fitness and speed/agility as physical fitness components in European adolescents; yet it is associated with both measured and self-reported cardiorespiratory fitness, which extends previous findings.

Geomorphological analysis and evolution of an altered floodplain drainage system. The case of the Partido Stream (Spain)

The Partido Stream is a small torrential course that flows into the marsh of the Doñana National Park, an area that was declared a World Heritage Site in 1994. Before 1981, floods occurred, and the stream overflowed onto a floodplain. As an old alluvial fan, the floodplain has its singular orography and functionality. Fromthe floodplain, several drainage channels, locally called caño, discharged into themarsh. The Partido Streamhad themorphology of a caño and covered approximately 8 km from the old fan to the marsh. The stream was straightened and channelised in 1981 to cultivate the old fan. This resulted in floods that were concentrated between the banks in the following years, which caused the depth of water and the shear stress to increase, thus, scouring the river bed and river banks. In this case, the eroded materials were carried towards the marsh where a new alluvial fan evolved. Control measures on the old fan were implemented in 2006 to stop the development of the new alluvial fan downstream over the marsh. Thus, the stream would partially recover its original behaviour that it had before channelisation, moving forwards in a new, balanced state. The present study describes the geomorphological evolution that channelisation has caused since 1981 and the later slow process of recovery of the original hydraulic-sedimentation regime since 2006. Additionally, it deepens the understanding of the original hydraulic behaviour of the stream, combining field data and 2D simulations.

Investigaciones dendrogeomorfológicas aplicadas al estudio de la peligrosidad por avenidas e inundaciones en el parque nacional de la Caldera de Taburiente (La Palma, Islas Canarias).

Las Angustias torrent is an ungauged stream located in the Caldera de Taburiente National Park (Canary Islands), where frequent and intense flood events occur (even causing fatalities, such as in November 2001). The aim of this research is to analyse the flood hazard in one of the most visited areas of this protected area. To carry out this objective, during two dendrogeomorphological campaigns, all pine trees located on the stream bed and banks showing external evidence of flash flood damage were sampled. In addition, a detailed topographical survey using GPS and total station allowed us to obtain the inputs for hydraulic modelling. In the preliminary results, two flood events have been identified (1967-1968 and 1999- 2000), and evidence of other dates has been observed (1976, 1983, 1993 and 2001). Magnitude reconstruction of these events will improve flood hazard and risk analyses and will be useful for National Park managers.

Sewage sludge gasification. Dolomite performance under different operating conditions

Gasification is a technology that can replace traditional management alternatives used up to date to deal with this waste (landfilling, composting and incineration) and which fulfils the social, environmental and legislative requirements. The main products of sewage sludge gasification are permanent gases (useful to generate energy or to be used as raw material in chemical synthesis processes), liquids (tars) and char. One of the main problems to be solved in gasification is tar production. Tars are organic impurities which can condense at relatively high temperatures making impossible to use the produced gases for most applications. This work deals with the effect of some primary tar removal processes (performed inside the gasifier) on sewage sludge gasification products. For this purpose, analysis of the gas composition, tar production, cold gas efficiency and carbon conversion were carried out. The tests were performed with air in a laboratory scale plant consisting mainly of a bubbling bed gasifier. No catalyzed and catalyzed (10% wt of dolomite in the bed and in the feeding) tests were carried out at different temperatures (750ºC, 800ºC and 850ºC) in order to know the effect of these parameters in the gasification products. As far as tars were concerned, qualitative and quantitative tar composition was determined. In all tests the Equivalence Ratio (ER) was kept at 0.3. Temperature is one of the most influential variables in sewage sludge gasification. Higher temperatures favoured hydrogen and CO production while CO2 content decreased, which might be partially explained by the effect of the cracking, Boudouard and CO2 reforming reactions. At 850ºC, cold gas efficiency and carbon conversion reached 49% and 76%, respectively. The presence of dolomite as catalyst increased the production of H2 reaching contents of 15.5% by volume at 850 °C. Similar behaviour was found for CO whereas CO2 and CnHm (light hydrocarbons) production decreased. In the presence of dolomite, a tar reduction of up to 51% was reached in comparison with no catalyzed tests, as well as improvements on cold gas efficiency and carbon conversion. Several assays were developed in order to test catalyst performance under more rough gasification conditions. For this purpose, the throughput value (TR), defined as kg sludge “as received” fed to the gasifier per hour and per m2 of cross sectional area of the gasifier, was modified. Specifically, the TR values used were 110 (reference value), 215 and 322 kg/h·m2. When TR increased, the H2, CO and CH4 production decreased while the CO2 and the CnHm production increased. Tar production increased drastically with TR during no catalysed tests what is related to the lower residence time of the gas inside the reactor. Nevertheless, even at TR=322 kg/h·m2, tar production decreased by nearly 50% with in-bed use of dolomite in comparison with no catalyzed assays under the same operating conditions. Regarding relative tar composition, there was an increase in benzene and naphthalene content when temperature increased while the content of the rest of compounds decreased. The dolomite seemed to be effective all over the range of molecular weight studied showing tar removal efficiencies between 35-55% in most cases. High values of the TR caused a significant increase in tar production but a slight effect on tar composition.

Experimental investigation of dynamic pressure loads during dam break

The objectives of this work are to revisit the experimental measurements on dam break flow over a dry horizontal bed and to provide a detailed insight into the dynamics of the dam break wave impacting a vertical wall downstream the dam, with emphasis on the pressure loads. The measured data are statistically analyzed and critically discussed. As a result, an extensive set of data for validation of computational tools is provided.

Diseño de un sistema regional de alerta de tsunamis como parte integral de la operación portuaria

En este trabajo se presenta el desarrollo de una metodología para obtener un universo de funciones de Green y el algoritmo correspondiente, para estimar la altura de tsunamis a lo largo de la costa occidental de México en función del momento sísmico y de la extensión del área de ruptura de sismos interplaca localizados entre la costa y la Trinchera Mesoamericana. Tomando como caso de estudio el sismo ocurrido el 9 de octubre de 1995 en la costa de Jalisco-Colima, se estudiaron los efectos del tsunami originados en la hidrodinámica del Puerto de Manzanillo, México, con una propuesta metodológica que contempló lo siguiente: El primer paso de la metodología contempló la aplicación del método inverso de tsunamis para acotar los parámetros de la fuente sísmica mediante la confección de un universo de funciones de Green para la costa occidental de México. Tanto el momento sísmico como la localización y extensión del área de ruptura de sismos se prescribe en segmentos de planos de falla de 30 X 30 km. A cada uno de estos segmentos del plano de falla corresponde un conjunto de funciones de Green ubicadas en la isobata de 100 m, para 172 localidades a lo largo de la costa, separadas en promedio 12 km entre una y otra. El segundo paso de la metodología contempló el estudio de la hidrodinámica (velocidades de las corrientes y niveles del mar en el interior del puerto y el estudio del runup en la playa) originada por el tsunami, la cual se estudió en un modelo hidráulico de fondo fijo y en un modelo numérico, representando un tsunami sintético en la profundidad de 34 m como condición inicial, el cual se propagó a la costa con una señal de onda solitaria. Como resultado de la hidrodinámica del puerto de Manzanillo, se realizó un análisis de riesgo para la definición de las condiciones operativas del puerto en términos de las velocidades en el interior del mismo, y partiendo de las condiciones iniciales del terremoto de 1995, se definieron las condiciones límites de operación de los barcos en el interior y exterior del puerto. In this work is presented the development of a methodology in order to obtain a universe of Green's functions and the corresponding algorithm in order to estimate the tsunami wave height along the west coast of Mexico, in terms of seismic moment and the extent of the area of the rupture, in the interplate earthquakes located between the coast and the Middle America Trench. Taking as a case of study the earthquake occurred on October 9, 1995 on the coast of Jalisco-Colima, were studied the hydrodynamics effects of the tsunami caused in the Port of Manzanillo, Mexico, with a methodology that contemplated the following The first step of the methodology contemplated the implementation of the tsunami inverse method to narrow the parameters of the seismic source through the creation of a universe of Green's functions for the west coast of Mexico. Both the seismic moment as the location and extent of earthquake rupture area prescribed in segments fault planes of 30 X 30 km. Each of these segments of the fault plane corresponds a set of Green's functions located in the 100 m isobath, to 172 locations along the coast, separated on average 12 km from each other. The second step of the methodology contemplated the study of the hydrodynamics (speed and directions of currents and sea levels within the port and the study of the runup on the beach Las Brisas) caused by the tsunami, which was studied in a hydraulic model of fix bed and in a numerical model, representing a synthetic tsunami in the depth of 34 m as an initial condition which spread to the coast with a solitary wave signal. As a result of the hydrodynamics of the port of Manzanillo, a risk analysis to define the operating conditions of the port in terms of the velocities in the inner and outside of the port was made, taken in account the initial conditions of the earthquake and tsunami ocurred in Manzanillo port in 1995, were defined the limits conditions of operation of the ships inside and outside the port.

Biomass Gasification in a Fluidized Bed Reactor: Effect of Temperature, Stoichiometric Ratio and Biomass Type

This paper investigates the gasification of two biomass types (pine wood and olive stones) in a laboratory scale bubbling fluidized bed reactor, in order to evaluate comparatively their potential in the production of syngas.

Deposition reactors for solar grade silicon: a comparative thermal analysis of a Siemens reactor and a fluidized bed reactor

Polysilicon production costs contribute approximately to 25-33% of the overall cost of the solar panels and a similar fraction of the total energy invested in their fabrication. Understanding the energy losses and the behaviour of process temperature is an essential requirement as one moves forward to design and build large scale polysilicon manufacturing plants. In this paper we present thermal models for two processes for poly production, viz., the Siemens process using trichlorosilane (TCS) as precursor and the fluid bed process using silane (monosilane, MS).We validate the models with some experimental measurements on prototype laboratory reactors relating the temperature profiles to product quality. A model sensitivity analysis is also performed, and the efects of some key parameters such as reactor wall emissivity, gas distributor temperature, etc., on temperature distribution and product quality are examined. The information presented in this paper is useful for further understanding of the strengths and weaknesses of both deposition technologies, and will help in optimal temperature profiling of these systems aiming at lowering production costs without compromising the solar cell quality.