16 resultados para 690202 Coastal water transport
em University of Michigan
Resumo:
A comprehensive engineering analysis of the coastal sediment transport processes along a 42-kilometer segment of the North Carolina shoreline from Wrightsville Beach to Fort Fisher is presented. Included in the analysis is an interpretation of the littoral processes, longshore transport, and the behavior and success of beach nourishment projects at Wrightsville Beach and Carolina Beach, North Carolina. The historical position of the MLW, MSL, and MHW contours, relative to a fixed base line, is plotted for the period between 1964 and 1975. An equivalent volumetric erosion or accretion between successive surveys is determined by multiplying the average excursion distance of the contours by a constant of proportionality. The plots of excursion distance versus time for the MLW, MSL, and MHW contours also show the time response of the beach fills. This response is described by a mathematical function. The alongshore components of wave-induced energy flux are also determined within the study area through wave refraction analysis. This information, together with the information on volumetric change, is used in a sediment budget analysis to determine the coefficient of alongshore sediment transport and the inlet trapping characteristics. (Author).
Resumo:
Mode of access: Internet.
Resumo:
"ST/TAO/ser.C/43,E/CN.11/534."
Resumo:
Cover title.
Resumo:
"April 1987."
Resumo:
"August 1987."
Resumo:
"October 1969."
Resumo:
"May 1979."
Resumo:
"January 1976."
Radioactivity transport in water--environmental behavior of nitrosylruthenium : technical report 3 /
Resumo:
"Atomic Energy Commission Contract AT(11-1)-490."
Resumo:
"June 1980."
Resumo:
The development of sand ripples in an oscillatory-flow water tunnel was observed in 104 laboratory experiments approximating conditions at the seabed under steady progressive surface waves. The period, T, and amplitude, a, of the water motion were varied over wide ranges. Three quartz sands were used, with mean grain diameters, D = 0.55, 0.21, and 0.18 millimeter. In 24 experiments, with the bed initially leveled, T was reduced until ripples appeared, and their development to final equilibrium form was observed without further change in T. The remaining 80 experiments investigated the response of previously established bed forms to changes in T or a or both. The ripple length, lambda, and height, eta, were measured from photos, except when bed forms were three dimensional.
Resumo:
As presently used, the immersed weight rate, I sub l, is the volume rate, Q, of longshore transport, multiplied by a constant. For use in engineering problems, I sub l must be converted back to the equivalent Q. The I sub l formulation may be important where the unit weight of sand differs significantly from the unit weight of sand at the open-coast sites contributing data to the design curve. Increase in void ratio may result in a 10- to 20-percent increase in actual (as compared to predicted) shoaling volumes where sand accumulates in protected water. Void ratio should be measured in field studies of longshore transport.
Resumo:
Mode of access: Internet.
Resumo:
"HWRIC TN88-010."