Chemical analysis of water samples of station M1_1207, Red Sea (Table 1-3)


Autoria(s): Hartmann, Martin; Lohmann, Ludwig
Cobertura

LATITUDE: 21.300000 * LONGITUDE: 38.000000 * MINIMUM ORDINAL NUMBER: 1 * MAXIMUM ORDINAL NUMBER: 6

Data(s)

08/01/1968

Resumo

Two water samples and two sediment samples taken in 1965 by the R. V. "Meteor" in the area of the hot salt brine of the Atlantis II-Deep were chemically investigated, and in addition the sediment samples were subjected to X-ray and optical analysis. The investigation of the sulfur-isotope-ratios showed the same values for all water samples. This information combined with the Ca-sulfate solubility data leads us to conclude that, for the most part, the sulfate content of the salt brine resulted from mixing along the boundary with the normal seawater. In this boundary area gypsum or anhydrite is formed which sinks down to the deeper layers of the salt brine where it is redisolved when the water becomes undersaturated. In the laboratory, formation of CaS04 precipitate resulted from both the reheating of the water sample from the uppermost zone of the salt brine to the in-situ-temperature as well as by the mixing of the water sample with normal Red Sea water. The iron and manganese delivered by the hot spring is separated within the area of the salt brine by their different redox-potentials. Iron is sedimented to a high amount within the salt brine, while, as evidenced by its small amounts in all sediment samples, the more easily reducible manganese is apparently carried out of the area before sedimentation can take place. The very good layering of the salt brine may be the result of the rough bottom topography with its several progressively higher levels allowing step-like enlargements of the surface areas of each successive layer. Each enlargement results in larger boundary areas along which more effective heat transfer and mixing with the next layer is possible. In the sediment samples up to 37.18% Fe is found, mostly bound as very poorly crystallized iron hydroxide. Pyrite is present in only very small amounts. We assume that the copper is bound mostly as sulfide, while the zinc is most likely present in an other form. The sulfur-isotope-investigations indicate that the sulfur in the sediment, bound as pyrite and sulfides, is not a result of bacterical sulfate-reduction in the iron-rich mud of the Atlantis II-Deep, but must have been brought up with the hot brine.

Formato

text/tab-separated-values, 65 data points

Identificador

https://doi.pangaea.de/10.1594/PANGAEA.472227

doi:10.1594/PANGAEA.472227

Idioma(s)

en

Publicador

PANGAEA

Direitos

CC-BY: Creative Commons Attribution 3.0 Unported

Access constraints: unrestricted

Fonte

Supplement to: Hartmann, Martin; Lohmann, Ludwig (1968): Untersuchungen an der heißen Salzlauge und am Sediment des Atlantis II-Tiefs in Roten Meer. Meteor Forschungsergebnisse, Deutsche Forschungsgemeinschaft, Reihe C Geologie und Geophysik, Gebrüder Bornträger, Berlin, Stuttgart, C1, 13-20

Palavras-Chave #Alkalinity, total; Atlantis II Deep; BC; Box corer; Calcium; Calcium carbonate; Carbon, organic, total; Chloride; Comment; Copper; delta 34S, sulfate; Description; GIK/IfG; IIOE - International Indian Ocean Expedition; Institute for Geosciences, Christian Albrechts University, Kiel; Iron; Loss on ignition; M1; M1_1207; Magnesium; Manganese; Meteor (1964); ORDINAL NUMBER; Oxygen; pH; Sample code/label; Sulfate; Sulfur, total; Zinc
Tipo

Dataset