Une carte des zones de cisaillement ductiles des Alpes Centrales

The main deformation structures due to the Tertiary continental collision in the Western Swiss Alps are ductile shear zones. Four main shear zones can be recognized on the structural map, each characterised by a different shear direction. The first D I shear zone with a X I, SE (transverse) stretching direction has been created during the under-thrusting towards the SE of the European plate under the Adriatic plate. This took place mainly by ductile deformation of the upper part of the European continental basement with the formation of the external massifs basement folds and the Penninic foldnappes. The second D II shear zone (Simplon ductile shear zone) is characterized by a XII stretching, dipping from 0 to 30-degrees to the SW (longitudinal stretching). It is approximately 10 km wide, and crosses the Alpine nappes in an oblique direction. It corresponds to a relative SW transport direction of the upper units together with the Adriatic plate. This dextral transpression zone is also responsible for the stretching parallel to the elongation of the Alpine belt. The third D III shear zone is made of mylonites with a steep stretching direction and corresponds to the hanging wall of the Canavese reverse fault. The D IV shear zones, dextral wrench zones combined with underthrusting movement, are characterised by a W and SW stretching direction. They were formed during and after the S facing backfolding which for instance made the Mischabel fold and the Boggioleto fold. Actually it occupies two narrow areas of more ductile rocks between the Mischabel backfold to the N and the Monte Rosa nappe to the S and allong the Canavese Line. These dextral shear zones represent probably the western continuation of the Tonale Line dextral wrench fault. The D I to IV ductile shear zone were formed under greenschist and amphibolite facies conditions during the Tertiary orogenic metamorphism. Their regional distribution is limited to the metamorphic ductile zone representing the deep part of the Alpine belt, between 10 and 30 km depth. The emplacement and orientation of the shear zones was also directed by the geometry of the boundaries of the European and Adriatic plates. The analysis of the superposed Central Alpine shear zones permits thus to propose a model of the history of the relative convergent and wrench movements which took place between the European and Adriatic plates during the Alpine Tertiary continental collision.