Stabilization of experimental bioretention basins during intermittent wetting and drying


Autoria(s): Subramaniam, D.; Egodawatta, P.; Mather, P.; Rajapakse, J.
Data(s)

07/08/2014

Resumo

Stormwater bioretention basins are subjected to spontaneous intermittent wetting and drying, unlike water treatment filter systems that are subjected to continuous feed. Drinking water filters when constructed new or after back-wash, are subjected to a phase of stabilization. Experiments show that bioretention basins are similarly impacted by intermittent wetting and drying. The common parameter monitored in the stabilisation of filters is the concentration of total solids in the outflow. Filter media in bioretention basins however, consists of a mix of particulate organic matter and fine sand. Organic carbon and solids are therefore needed to be monitored. Four Perspex bioretention filter columns of 94 mm (ID) were packed with a filter layer (800 mm), transition layer and a gravel layer and operated with synthetic stormwater in the laboratory. The filter layer contained 8% organic material by weight. A free board of 350 mm provided detention storage and head to facilitate infiltration. Synthetic stormwater was prepared by adding NH4NO3 (ammonium nitrate) and C2H5NO2 (glycine) and a mixture of kaolinite and montmorillonite clay, to tapwater. The columns were fed with synthetic stormwater with different Antecedent Dry Days (ADD) (0 – 25 day) and constant inflow concentration (2 ppm: nitrate-nitrogen, 1.5 ppm: ammonium-nitrogen, 2.5 ppm: organic-nitrogen 100 ppm: total suspended solids and 7 ppm: organic carbon) at a feed rate of 100mL.min (85.7cm/h). Samples were collected from the outflow at different time intervals between 2 – 150 min from the start of outflow and were tested for Total Suspended Solids (TSS) and Total Organic Carbon (TOC). Both TSS and TOC concentrations in the outflow were observed to be much higher than the concentration of both the parameters in the inflow during the stabilisation period indicating a phase of wash-off (first flush) which lasted for approximately 30 min for both parameters at the beginning of each storm event. The wash-off of TSS and TOC were found to be highly variable depending on the age of the filter and the number of antecedent dry days. The duration of stabilisation phase in the experiments is significant compared with many of the stormwater events. A computational analysis on total mass of each pollutant further affirmed the significance of the first flush of an event on removal of these pollutants. Therefore, the kinetics of the first flush in the stabilisation phase needs to be considered in the performance analysis of the systems.

Formato

application/pdf

Identificador

http://eprints.qut.edu.au/75796/

Relação

http://eprints.qut.edu.au/75796/3/75796.pdf

http://www.gemsevents.com.au/stormwaterqld/resources/2014papers/Subramaniam,%20D.%20Stabalisation%20of%20Experimental%20Bioretention%20Basins%20During%20Intermittent%20Wetting%20and%20Drying.pdf

Subramaniam, D., Egodawatta, P., Mather, P., & Rajapakse, J. (2014) Stabilization of experimental bioretention basins during intermittent wetting and drying. In 2014 Stormwater Queensland Conference : Visions to Realities, 6-8 August 2014, RACV Noosa Resort, Noosa Heads.

Direitos

Copyright 2014 please consult author(s)

Fonte

School of Earth, Environmental & Biological Sciences; Science & Engineering Faculty

Palavras-Chave #090509 Water Resources Engineering #090701 Environmental Engineering Design #Bioretention Basins #Stormwater treatment #Stabilization #Total Organic Carbon #Suspended Solids
Tipo

Conference Paper