The clinical utility of the Cornell Scale for Depression in Dementia as a routine assessment in nursing homes

Objective To examine the clinical utility of the Cornell Scale for Depression in Dementia (CSDD) in nursing homes. Setting 14 nursing homes in Sydney and Brisbane, Australia. Participants 92 residents with a mean age of 85 years. Measurements Consenting residents were assessed by care staff for depression using the CSDD as part of their routine assessment. Specialist clinicians conducted assessment of depression using the Semi-structured Clinical Diagnostic Interview for DSM-IV-TR Axis I Disorders for residents without dementia or the Provisional Diagnostic Criteria for Depression in Alzheimer Disease for residents with dementia to establish expert clinical diagnoses of depression. The diagnostic performance of the staff completed CSDD was analyzed against expert diagnosis using receiver operating characteristic (ROC) curves. Results The CSDD showed low diagnostic accuracy, with areas under the ROC curve being 0.69, 0.68 and 0.70 for the total sample, residents with dementia and residents without dementia, respectively. At the standard CSDD cutoff score, the sensitivity and specificity were 71% and 59% for the total sample, 69% and 57% for residents with dementia, and 75% and 61% for residents without dementia. The Youden index (for optimizing cut-points) suggested different depression cutoff scores for residents with and without dementia. Conclusion When administered by nursing home staff the clinical utility of the CSDD is highly questionable in identifying depression. The complexity of the scale, the time required for collecting relevant information, and staff skills and knowledge of assessing depression in older people must be considered when using the CSDD in nursing homes.

Assessment of the effects of CT dose in averaged x-ray CT images of a dose-sensitive polymer gel

The signal-to-noise ratio achievable in x-ray computed tomography (CT) images of polymer gels can be increased by averaging over multiple scans of each sample. However, repeated scanning delivers a small additional dose to the gel which may compromise the accuracy of the dose measurement. In this study, a NIPAM-based polymer gel was irradiated and then CT scanned 25 times, with the resulting data used to derive an averaged image and a "zero-scan" image of the gel. Comparison between these two results and the first scan of the gel showed that the averaged and zero-scan images provided better contrast, higher contrast-to- noise and higher signal-to-noise than the initial scan. The pixel values (Hounsfield units, HU) in the averaged image were not noticeably elevated, compared to the zero-scan result and the gradients used in the linear extrapolation of the zero-scan images were small and symmetrically distributed around zero. These results indicate that the averaged image was not artificially lightened by the small, additional dose delivered during CT scanning. This work demonstrates the broader usefulness of the zero-scan method as a means to verify the dosimetric accuracy of gel images derived from averaged x-ray CT data.

Method of symptom assessment influences cognitive, affective and somatic post-concussion-like symptom base rates

Primary objective: To investigate whether assessment method influences the type of post-concussion-like symptoms. Methods and procedures: Participants were 73 Australian undergraduate students (Mage = 24.14, SD = 8.84; 75.3% female) with no history of mild traumatic brain injury (mTBI). Participants reported symptoms experienced over the previous 2 weeks in response to an open-ended question (free report), mock interview and standardized checklist (British Columbia Post-concussion Symptom Inventory; BC-PSI). Main outcomes and results: In the free report and checklist conditions, cognitive symptoms were reported significantly less frequently than affective (free report: p < 0.001; checklist: p < 0.001) or somatic symptoms (free report: p < 0.001; checklist: p = 0.004). However, in the mock structured interview condition, cognitive and somatic symptoms were reported significantly less frequently than affective symptoms (both p < 0.001). No participants reported at least one symptom from all three domains when assessed by free report, whereas most participants did so when symptoms were assessed by a mock structured interview (75%) or checklist (90%). Conclusions: Previous studies have shown that the method used to assess symptoms affects the number reported. This study shows that the assessment method also affects the type of reported symptoms.

Editorial - Assessment of EAL/D learners : the validity of teachers' professional judgements

Assessment is a recurring theme in this issue of TESOL in Context. It is the focus of a themed section; addressed in some of the award-winning thesis research we feature; and one of several topics in an article on EFL teacher preparation in an Australian university. In the first section of the issue we are pleased to publish précis of the theses produced by the joint winners of the Penny McKay Memorial Award for Best Thesis in Language Education. Penny was a major figure in the development of EAL/D education in Australia (see Dooley & Moore, 2009). Her work is remembered and continued through an Award established by the Australian Council of TESOL Associations (ACTA) and the Applied Linguistics Association of Australia (ALAA). The award recognises doctoral research which makes an outstanding contribution to second/additional language education in Australian schools (http://www.tesol.org.au/About-ACTA/PENNY-MCKAY-MEMORIAL-FUND)...

Transit route occupancy load factor and passenger average travel time for quality of service assessment

This paper investigates quality of service (QoS) and resource productivity implications of transit route passenger loading and travel time. It highlights the value of occupancy load factor as a direct passenger comfort QoS measure. Automatic Fare Collection data for a premium radial bus route in Brisbane, Australia, is used to investigate time series correlation between occupancy load factor and passenger average travel time. Correlation is strong across the entire span of service in both directions. Passengers tend to be making longer, peak direction commuter trips under significantly less comfortable conditions than off-peak. The Transit Capacity and Quality of Service Manual uses segment based load factor as a measure of onboard loading comfort QoS. This paper provides additional insight into QoS by relating the two route based dimensions of occupancy load factor and passenger average travel time together in a two dimensional format, both from the passenger’s and operator’s perspectives. Future research will apply Value of Time to QoS measurement, reflecting perceived passenger comfort through crowding and average time spent onboard. This would also assist in transit service quality econometric modeling. The methodology can be readily applied in a practical setting where AFC data for fixed scheduled routes is available. The study outcomes also provide valuable research and development directions.

Transit route occupancy load factor and passenger average travel time for quality of service assessment

This presentation investigates quality of service (QoS) and resource productivity implications of transit route passenger loading and travel time. It highlights the value of occupancy load factor as a direct passenger comfort QoS measure. Automatic Fare Collection data for a premium radial bus route in Brisbane, Australia, is used to investigate time series correlation between occupancy load factor and passenger average travel time. Correlation is strong across the entire span of service in both directions. Passengers tend to be making longer, peak direction commuter trips under significantly less comfortable conditions than off-peak. The Transit Capacity and Quality of Service Manual uses segment based load factor as a measure of onboard loading comfort QoS. This paper provides additional insight into QoS by relating the two route based dimensions of occupancy load factor and passenger average travel time together in a two dimensional format, both from the passenger’s and operator’s perspectives. Future research will apply Value of Time to QoS measurement, reflecting perceived passenger comfort through crowding and average time spent onboard. This would also assist in transit service quality econometric modeling. The methodology can be readily applied in a practical setting where AFC data for fixed scheduled routes is available. The study outcomes also provide valuable research and development directions.

The global burden attributable to low bone mineral density

Introduction The Global Burden of Disease Study 2010 estimated the worldwide health burden of 291 diseases and injuries and 67 risk factors by calculating disability-adjusted life years (DALYs). Osteoporosis was not considered as a disease, and bone mineral density (BMD) was analysed as a risk factor for fractures, which formed part of the health burden due to falls. Objectives To calculate (1) the global distribution of BMD, (2) its population attributable fraction (PAF) for fractures and subsequently for falls, and (3) the number of DALYs due to BMD. Methods A systematic review was performed seeking population-based studies in which BMD was measured by dual-energy X-ray absorptiometry at the femoral neck in people aged 50 years and over. Age- and sex-specific mean ± SD BMD values (g/cm2) were extracted from eligible studies. Comparative risk assessment methodology was used to calculate PAFs of BMD for fractures. The theoretical minimum risk exposure distribution was estimated as the age- and sex-specific 90th centile from the Third National Health and Nutrition Examination Survey (NHANES III). Relative risks of fractures were obtained from a previous meta-analysis. Hospital data were used to calculate the fraction of the health burden of falls that was due to fractures. Results Global deaths and DALYs attributable to low BMD increased from 103 000 and 3 125 000 in 1990 to 188 000 and 5 216 000 in 2010, respectively. The percentage of low BMD in the total global burden almost doubled from 1990 (0.12%) to 2010 (0.21%). Around one-third of falls-related deaths were attributable to low BMD. Conclusions Low BMD is responsible for a growing global health burden, only partially representative of the real burden of osteoporosis.

Stochastic analysis of transit route segments' passenger load variation for capacity and quality of service assessment

This paper investigates stochastic analysis of transit segment hourly passenger load factor variation for transit capacity and quality of service (QoS) analysis using Automatic Fare Collection data for a premium radial bus route in Brisbane, Australia. It compares stochastic analysis to traditional peak hour factor (PHF) analysis to gain further insight into variability of transit route segments’ passenger loading during a study hour. It demonstrates that hourly design load factor is a useful method of modeling a route segment’s capacity and QoS time history across the study weekday. This analysis method is readily adaptable to different passenger load standards by adjusting design percentile, reflecting either a more relaxed or more stringent condition. This paper also considers hourly coefficient of variation of load factor as a capacity and QoS assessment measure, in particular through its relationships with hourly average and design load factors. Smaller value reflects uniform passenger loading, which is generally indicative of well dispersed passenger boarding demands and good schedule maintenance. Conversely, higher value may be indicative of pulsed or uneven passenger boarding demands, poor schedule maintenance, and/or bus bunching. An assessment table based on hourly coefficient of variation of load factor is developed and applied to this case study. Inferences are drawn for a selection of study hours across the weekday studied.

Stochastic analysis of transit route segments' passenger load variation for capacity & quality of service assessment

This study uses weekday Automatic Fare Collection (AFC) data on a premium bus line in Brisbane, Australia •Stochastic analysis is compared to peak hour factor (PHF) analysis for insight into passenger loading variability •Hourly design load factor (e.g. 88th percentile) is found to be a useful method of modeling a segment’s passenger demand time-history across a study weekday, for capacity and QoS assessment •Hourly coefficient of variation of load factor is found to be a useful QoS and operational assessment measure, particularly through its relationship with hourly average load factor, and with design load factor •An assessment table based on hourly coefficient of variation of load factor is developed from the case study

Investigative trends in understanding penalty-kick performance in association football: An ecological dynamics perspective

There have been different approaches to studying penalty-kick performance in association football. In this paper, the authors synthesize key findings within an ecological dynamics theoretical framework. According to this theoretical perspective, information is the cornerstone for understanding the dynamics of action regulation in penalty-kick performance. Research suggests that investigators need to identify the information sources that are most relevant to penalty-kick performance. An important task is to understand how constraints can channel (i.e. change, emphasize or mask) information sources used to regulate upcoming actions and how the influence of these constraints is expressed in players' behavioural dynamics. Due to the broad range of constraints influencing penalty-kick performance, it is recommended that future research adopts an interdisciplinary focus on performance assessment to overcome the current lack of representativeness in penalty-kick experimental designs. Such an approach would serve to capture the information-based control of action of both players as components of this dyadic system in competitive sport.

The contribution of three components of nutrition knowledge to socio-economic differences in food purchasing choices

Objectives: To assess socio-economic differences in three components of nutrition knowledge, i.e. knowledge of (i) the relationship between diet and disease, (ii) the nutrient content of foods and (iii) dietary guideline recommendations; furthermore, to determine if socio-economic differences in nutrition knowledge contribute to inequalities in food purchasing choices. Design: The cross-sectional study considered household food purchasing,nutrition knowledge, socio-economic and demographic information. Household food purchasing choices were summarised by three indices, based on self-reported purchasing of sixteen groceries, nineteen fruits and twenty-one vegetables. Socio-economic position (SEP) was measured by household income and education. Associations between SEP, nutrition knowledge and food purchasing were examined using general linear models adjusted for age, gender, household type and household size. Setting: Brisbane, Australia in 2000. Subjects: Main household food shoppers (n 1003, response rate 66?4 %), located in fifty small areas (Census Collectors Districts). Results: Shoppers in households of low SEP made food purchasing choices that were less consistent with dietary guideline recommendations: they were more likely to purchase grocery foods comparatively higher in salt, sugar and fat, and lower in fibre, and they purchased a narrower range of fruits and vegetables. Those of higher SEP had greater nutrition knowledge and this factor attenuated most associations between SEP and food purchasing choices. Among nutrition knowledge factors, knowledge of the relationship between diet and disease made the greatest and most consistent contribution to explaining socio-economic differences in food purchasing. Conclusions: Addressing inequalities in nutrition knowledge is likely to reduce socio-economic differences in compliance with dietary guidelines. Improving knowledge of the relationship between diet and disease appears to be a particularly relevant focus for health promotion aimed to reduce socio-economic differences in diet and related health inequalities.