Commercial Leases in Australia [7th ed.]

Commercial Leases in Australia is a comprehensive guide to understanding and drafting commercial leases agreements in Australia and to managing disputes when they arise.

Design and experimental testing of air slab caps which convert commercial electron diodes into dual purpose, correction-free diodes for small field dosimetry

Purpose Two diodes which do not require correction factors for small field relative output measurements are designed and validated using experimental methodology. This was achieved by adding an air layer above the active volume of the diode detectors, which canceled out the increase in response of the diodes in small fields relative to standard field sizes. Methods Due to the increased density of silicon and other components within a diode, additional electrons are created. In very small fields, a very small air gap acts as an effective filter of electrons with a high angle of incidence. The aim was to design a diode that balanced these perturbations to give a response similar to a water-only geometry. Three thicknesses of air were placed at the proximal end of a PTW 60017 electron diode (PTWe) using an adjustable “air cap”. A set of output ratios (ORfclin Det ) for square field sizes of side length down to 5 mm was measured using each air thickness and compared to ORfclin Det measured using an IBA stereotactic field diode (SFD). k fclin, f msr Qclin,Qmsr was transferred from the SFD to the PTWe diode and plotted as a function of air gap thickness for each field size. This enabled the optimal air gap thickness to be obtained by observing which thickness of air was required such that k fclin, f msr Qclin,Qmsr was equal to 1.00 at all field sizes. A similar procedure was used to find the optimal air thickness required to make a modified Sun Nuclear EDGE detector (EDGEe) which s “correction-free” in small field relative dosimetry. In addition, the feasibility of experimentally transferring k fclin, f msr Qclin,Qmsr values from the SFD to unknown diodes was tested by comparing the experimentally transferred k fclin, f msr Qclin,Qmsr values for unmodified PTWe and EDGEe diodes to Monte Carlo simulated values. Results 1.0 mm of air was required to make the PTWe diode correction-free. This modified diode (PTWeair) produced output factors equivalent to those in water at all field sizes (5–50 mm). The optimal air thickness required for the EDGEe diode was found to be 0.6 mm. The modified diode (EDGEeair) produced output factors equivalent to those in water, except at field sizes of 8 and 10 mm where it measured approximately 2% greater than the relative dose to water. The experimentally calculated k fclin, f msr Qclin,Qmsr for both the PTWe and the EDGEe diodes (without air) matched Monte Carlo simulated results, thus proving that it is feasible to transfer k fclin, f msr Qclin,Qmsr from one commercially available detector to another using experimental methods and the recommended experimental setup. Conclusions It is possible to create a diode which does not require corrections for small field output factor measurements. This has been performed and verified experimentally. The ability of a detector to be “correction-free” depends strongly on its design and composition. A nonwater-equivalent detector can only be “correction-free” if competing perturbations of the beam cancel out at all field sizes. This should not be confused with true water equivalency of a detector.

Commercial friendships between gay salesmen and straight female customers

Perhaps it is now sacrosanct in marketing to contemplate that many service encounters, especially those in retail settings, are social encounters in which bonds between and among customers and employees are critical drivers of consumption (Beatty et al., 1996; Rosenbaum, 2006). Indeed, within retail settings, it is often possible for salespeople and customers to form so-called “commercial friendships” (Price and Arnould, 1999). These friendships result in both salespeople and their customers having social interactions that are close to those experienced in personal friendships (Swan et al., 2001), and which are extremely satisfying for all parties. Outside of marketing, the social science literature (Grigoriou, 2004; Rumens, 2008; Russell, DelPriore, Butterfield, and Hill, 2013) and popular press (de la Cruz and Dolby, 2007; Hopcke and Rafaty, 1999; Tilmann-Healy, 2001, Whitney, 1990) is replete with knowledge regarding the “absolutely fabulous” friendships (Hopcke and Rafaty, 1999) that often form between gay men and straight women. In fact, Western culture regularly highlights the compatibility of gay men and straight women in film, television, and writing, to the extent that they have now influenced popular thinking on the topic, so that gay men and straight females are viewed as sharing common plights and interests (Rumens, 2008). Yet, thus far, marketing researchers have looked askance at the effect of friendships between gay male employees and heterosexual female customers in consumption settings, such as retail stores and boutiques. Indeed, with the exception of Peretz’s (1995) participant observation regarding how young and outwardly gay salesmen use their ambiguous gender to sell women’s clothing, in a Paris-based luxury boutique, any theoretical explorations regarding retail-based commercial friendships between gay salesmen and female customers are non-existent—until now. This research addresses this apparent chasm in the literature by putting forth an original framework that shows how the emotional closeness between gay salesmen and female customers, due to the absence of sexual interest and inter-female competition, results in an intense emotional closeness, that facilitates pleasurable retail transactions, customer satisfaction, loyalty, and positive word-of-mouth. In doing so, this work extends the commercial friendship paradigm by considering retail-based, commercial friendships between an under-researched marketplace dyad; gay men and straight females. It is worth noting here that some straight women may find the idea of commercial friendships with gay salesmen as undesirable, due to the very notion of having relationships with retail organizations or employees (Noble and Phillips, 2004), or a personal disdain for homosexuality.

Design & performance of a networked ad-hoc acoustic communications system using inexpensive commercial CDMA modems

We present a new approach for creating and implementing an ad-hoc underwater acoustic sensor network based on connecting a small processor to the serial port of a commercial CDMA acoustic modem. The processor acts as a "node controller" providing the networking layer that the modems lack. The ad-hoc networking protocol is based on a modified dynamic source routing (DSR) approach and can be configured for maximising information throughput or minimising energy expenditure. The system was developed in simulation and then evaluated during field trials using a 10 node deployment. Experimental results show reliable multi-hop networking under a variety of network configurations, with the added ability to determine internode ranges to within 1.5 m for localisation.

Ants, apples and the ABCs: The use of commercial phonics programmes in prior-to-school children's services

Commercial phonics programmes (e.g. Jolly Phonics and Letterland) are becoming widely used in the early years of school. These programmes claim to use a systematic explicit approach, considered as the preferred method of phonics instruction for teaching alphabetic code-breaking skills in Australia and the UK in the first years of school (Department of Education, Science and Training, 2005; Rose, 2006). However, little is known about the extent to which they are being used in prior-to-school settings, and the reasons behind decisions to use them. This study surveyed 283 early childhood staff in Sydney, Australia and found that commercial phonics programmes were being used in 36% of the early childhood settings surveyed. Staff with early childhood univer- sity qualifications and staff working in not-for-profit service types were less likely to use a commercial phonics programme than staff without university qualifications and staff working in for-profit services. Staff with less than 10 years’ experience were also more likely to use a commercial phonics programme. The rationale behind decisions deter- mining whether or not staff used the programmes ranged from pragmatic reasons, such as parent pressure or higher management decisions, to pedagogical reasons, such as teacher beliefs about how children learn to read and write. The practices staff engage in to teach phonics are explored.

Australian Commercial Law

Australian Commercial Law offers a concise yet comprehensive introduction to commercial law in Australia. The textbook provides a thorough and detailed discussion of a variety of topics in commercial law such as agency, bailment, the sale of goods, the transfer of property and the Personal Property Securities Act. The book also offers a detailed overview of topics within the Australian Consumer Law that are now relevant to commercial practice such as unconscionable conduct, consumer guarantees, and misleading and deceptive conduct. Written in a clear and accessible style, each chapter features key points and further reading to enhance students' understanding. Significant cases are discussed in detail and include excerpts from judgments to illustrate points of law. Australian Commercial Law is an indispensable resource for students who are seeking a comprehensive understanding of commercial law.

Designing and evaluating a persuasive child restraint television commercial

Objective Relatively high rates of child restraint inappropriate use, misuse and faults in the installation of restraints have suggested a crucial need for public education messages to raise parental awareness of the need to use restraints correctly. This project involved the devising and pilot testing of message concepts, filming of a television advertisement (the TVC), and the evaluation of the TVC. This paper focuses specifically upon the evaluation of the TVC. The development and evaluation of the TVC were guided by an extended Theory of Planned Behaviour which comprised the standard constructs of attitude, subjective norm, and perceived behavioural control as well as the additional constructs of group norm and descriptive norm. The study also explored the extent to which parents with low and high intentions to self-check restraint/s differed on salient beliefs regarding the behaviour. Methods An online survey of parents (N = 384) was conducted where parents were randomly assigned to either an Intervention group (n = 161), and therefore viewed the advertisement within the survey, or the Control group (n = 223) and therefore did not view the advertisement. Results Following a one-off exposure to the TVC, the results indicated that, although not a significant difference, parents in the Intervention group reported stronger intentions (M = 4.43, SD = .74) to self-check restraints than parents in the Control group (M = 4.18, SD = .86). Also, parents in the Intervention group (M = 4.59, SD = .47) reported significantly higher levels of perceived behavioural control than parents in the Control group (M = 4.40, SD = .73). The regression results revealed that, for parents in the Intervention group, attitude and group norm were significant predictors of parental intentions to self-check their child restraint. Finally, the exploratory analyses of parental beliefs suggested that those parents with low intentions to self-check child restraints were significantly more likely than high intenders to agree that they did not have enough time to check restraints or that having a child in a restraint is more important than checking the installation of the restraint. Conclusion Overall, the findings provide some support for the persuasiveness of the child restraint TVC and provide insight into the factors influencing reported parental intentions as well as salient beliefs underpinning self-checking of restraints. Interventions that attempt to increase parental perceptions of the importance of self-checking restraints regularly and brevity of the time involved in doing so may be effective.

A simple approach to improve the electrocatalytic properties of commercial Pt/C

Here we demonstrate that commercial carbon supported Pt nanoparticles react with [AuCl4]- ions at room temperature to produce a highly active Au/Pt/C material with an ultralow coverage of elemental Au on the Pt nanoparticles that exhibits significantly enhanced activity for ethanol oxidation when compared to Pt/C.

Understanding the performance of green commercial buildings: a Sustainable Built Environment National Research Centre (SBEnrc) briefing report

Efforts to reduce carbon emissions in the buildings sector have been focused on encouraging green design, construction and building operation; however, the business case is not very compelling if considering the energy cost savings alone. In recent years green building has been driven by a sense that it will improve the productivity of occupants,something with much greater economic returns than energy savings. Reducing energy demand in green commercial buildings in a way that encourages greater productivity is not yet well understood as it involves a set of complex and interdependent factors. This project investigates these factors and focuses on the performance of and interaction between: green design elements, internal environmental quality, occupant experience, tenant/leasing agreements, and building regulation and management. This paper suggests six areas of strategic research that are needed to understand how conditions can be created to support productivity in green buildings, and deliver significant energy consumption reductions.

The Australia-Chile free trade agreement 2008: Intellectual property and development. A submission to the Joint Standing Committee on treaties

A submission to the Joint Standing Committee on treaties