Field and laboratory performance evaluation of a field-blended rubber asphalt.

ALICE is one of four major experiments of particle accelerator LHC installed in the European laboratory CERN. The management committee of the LHC accelerator has just approved a program update for this experiment. Among the upgrades planned for the coming years of the ALICE experiment is to improve the resolution and tracking efficiency maintaining the excellent particles identification ability, and to increase the read-out event rate to 100 KHz. In order to achieve this, it is necessary to update the Time Projection Chamber detector (TPC) and Muon tracking (MCH) detector modifying the read-out electronics, which is not suitable for this migration. To overcome this limitation the design, fabrication and experimental test of new ASIC named SAMPA has been proposed . This ASIC will support both positive and negative polarities, with 32 channels per chip and continuous data readout with smaller power consumption than the previous versions. This work aims to design, fabrication and experimental test of a readout front-end in 130nm CMOS technology with configurable polarity (positive/negative), peaking time and sensitivity. The new SAMPA ASIC can be used in both chambers (TPC and MCH). The proposed front-end is composed of a Charge Sensitive Amplifier (CSA) and a Semi-Gaussian shaper. In order to obtain an ASIC integrating 32 channels per chip, the design of the proposed front-end requires small area and low power consumption, but at the same time requires low noise. In this sense, a new Noise and PSRR (Power Supply Rejection Ratio) improvement technique for the CSA design without power and area impact is proposed in this work. The analysis and equations of the proposed circuit are presented which were verified by electrical simulations and experimental test of a produced chip with 5 channels of the designed front-end. The measured equivalent noise charge was <550e for 30mV/fC of sensitivity at a input capacitance of 18.5pF. The total core area of the front-end was 2300?m × 150?m, and the measured total power consumption was 9.1mW per channel.

Investigation on performance characteristics of dense graded hot mix asphalt with RAP and Crumb Rubber

The use of recycled materials in asphalt mixtures such as reclaimed asphalt pavements (RAP) have become widely accepted as a replacement for virgin asphalt binder or virgin aggregates. In this study, the RAP content was 30%, and CR additives were blended with the soft unmodified binder by using dry processes. The objective of this study was to investigate and evaluate the engineering properties of dry method application of crumb rubber influences on reclaimed asphalt pavement (RAP) mixtures. To evaluate the effect of rubber-bitumen interaction on the mixture’s mechanical properties, a laboratory investigation has been conducted on a range of dense graded and 30% RAP by dry process crumb rubber modified (CRM) asphalt mixtures containing 0% (control), 1% crumb rubber by the total aggregate mass. The experimental program in this research include the binder extraction for estimating the amount of aged binder in the both fine and coarse RAP material. Before extracting the binder the RAP sieve analysis, have been done to provide the Black grading curve. In continue after the binder extraction the material sieved again to providing the white curve. The comparison of Black and White curve indicated that there is a remarkable difference between the aggregate grading even for the fine RAP. The experimental program was continued by fabricating 12 specimens in different 4 types of mixtures. For the first group no RAP, no rejuvenator and no crumb rubber were used. For the second group 30% of virgin aggregates substituted by RAP material and the third group was similar to the second group just with 0.01% rejuvenator. the forth group was the group, which in that the specimens contain RAP, rejuvenator and crumb rubber. Finally the specimens were tested for Indirect tensile strength. The results indicated that the addition of crumb rubber increased the optimum amount of binder in the mixture with 30% RAP.

Executive summary : implication of RACT for the cutback asphalt industry /

Mode of access: Internet.

Short-term guidelines to improve crumb rubber modified asphalt concrete pavements. Final report.

Texas Department of Transportation, Austin

Procedures for controlling the effect of increased tire pressure on asphalt concrete pavement damage. Final report.

Oregon Department of Transportation, Salem

Design and construction of asphalt paving materials with crumb rubber modifier : state of the practice /

"May 1992."

State-of-the-art in asphalt pavement specifications /

"July 1984."

Response of asphalt concrete pavements to dynamic truck loads. Final report.

California Department of Transportation, Sacramento

Drawdown tests on earth cover material placed over an asphalt membrane, East Bench Canal, Missouri River Basin Project, Montana /

Mode of access: Internet.

Evaluation of wood lignin as a substitute or extender of asphalt /

Mode of access: Internet.

Recycling of asphalt concrete airfield pavement : a laboratory study /

Performing organization : Civil Enginnering Laboratory. Naval Construction Battalion Center

National apprenticeship standards for cement masonry, asphalt, and composition trade.

Mode of access: Internet.

Asphalt-sporen door geheel Nederland, in verband met de eerste sluiting der geldleening ten behoeve van het asphalt-spoor tusschen Amsterdam en Haarlem.

Mode of access: Internet.

Evaluation of Stone Matrix Asphalt : final report /

"January 1996"--Cover.

Evaluation of the use of rubber modified asphalt concrete pavement in the State of Illinois /

"ILENR/RR-93/02."