A Surface Displacement Analysis for Volcan Pacaya from October 2001 through March 2013 by Means of 3-D Modeling of Precise Position GPS Data

Volcán Pacaya is one of three currently active volcanoes in Guatemala. Volcanic activity originates from the local tectonic subduction of the Cocos plate beneath the Caribbean plate along the Pacific Guatemalan coast. Pacaya is characterized by generally strombolian type activity with occasional larger vulcanian type eruptions approximately every ten years. One particularly large eruption occurred on May 27, 2010. Using GPS data collected for approximately 8 years before this eruption and data from an additional three years of collection afterwards, surface movement covering the period of the eruption can be measured and used as a tool to help understand activity at the volcano. Initial positions were obtained from raw data using the Automatic Precise Positioning Service provided by the NASA Jet Propulsion Laboratory. Forward modeling of observed 3-D displacements for three time periods (before, covering and after the May 2010 eruption) revealed that a plausible source for deformation is related to a vertical dike or planar surface trending NNW-SSE through the cone. For three distinct time periods the best fitting models describe deformation of the volcano: 0.45 right lateral movement and 0.55 m tensile opening along the dike mentioned above from October 2001 through January 2009 (pre-eruption); 0.55 m left lateral slip along the dike mentioned above for the period from January 2009 and January 2011 (covering the eruption); -0.025 m dip slip along the dike for the period from January 2011 through March 2013 (post-eruption). In all bestfit models the dike is oriented with a 75° westward dip. These data have respective RMS misfit values of 5.49 cm, 12.38 cm and 6.90 cm for each modeled period. During the time period that includes the eruption the volcano most likely experienced a combination of slip and inflation below the edifice which created a large scar at the surface down the northern flank of the volcano. All models that a dipping dike may be experiencing a combination of inflation and oblique slip below the edifice which augments the possibility of a westward collapse in the future.

Insoluble residues of the fine-grained sediments from DSDP Leg 67 Holes

Insoluble residues of Late Cretaceous to Quaternary deep-sea samples from slope, trench, and oceanic plate sites south of Guatemala were examined, specifically for the distribution of clay minerals in the <2-µm fraction and of silt grains in the 20-63-µm fraction. Widespread "oceanic" particles (biogenic opal, rhyolitic glass) and their diagenetic products (smectite, clinoptilolite, heulandite) were distinguished from terrigenous material - illite, kaolinite, chlorite, plagioclase, quartz, and heavy minerals. The main results of this investigation are: (1) At Site 494 on the slope immediately adjacent to the trench, terrigenous supplies testify to a slope position of the whole sequence back to the Late Cretaceous. (2) At Site 495 on the Pacific Cocos Plate, "oceanic" and terrigenous sedimentation are clearly separated. Whereas the pelagic sedimentation prevailed in the early Miocene, terrigenous minerals appeared in the middle Miocene in the clay fraction, and in the early Pliocene in the coarse silt fraction. These terrigenous supplies are interpreted as having been transported by suspension clouds crossing the slope and even the trench. The alternative, however, an eolian transport, cannot be excluded.

Characteristics, pyrolysis, age, lithology, sedimentation rate, organic matter, and thermal alteration index at DSDP Leg 67 Holes

Marine-derived amorphous organic matter dominates hemipelagic and trench sediments in and around the Middle America Trench. These sediments contain, on the average, 1% to 2% total organic carbon (TOC), with a maximum of 4.8%. Their organic facies and richness reflect (1) the small land area of Guatemala, which contributes small amounts of higher land plant remains, and (2) high levels of marine productivity and regionally low levels of dissolved oxygen, which encourage deposition and preservation of marine organic remains. These sediments have good potential for oil but are now immature. For this reason, gaseous hydrocarbons like the ethane identified in the deep parts of the section, as at Sites 496 and 497, are probably migrating from a mature section at depth. The pelagic sediments of the downgoing Cocos Plate are lean in organic carbon and have no petroleum potential

Occurrence and abundance of late Early Cretaceous radiolarians at DSDP Leg 62 Holes

Well-preserved Mesozoic radiolarian faunas have been recovered at four sites of Deep Sea Drilling Project Leg 62. Late Early Cretaceous assemblages, which occur always with foraminifers or calcareous nannoplankton, allow the description of 21 new species, the introduction of a new zone scheme, and calibration of the radiolarian zones with the geochronological scale.

Calcareous nannofossil range-distribution and zonation of sediments from three ODP Leg 205 holes

Ocean Drilling Program Leg 205 of the research vessel JOIDES Resolution was a return expedition to the Leg 170 sites located on the Costa Rica subduction zone. Here the entire sediment cover on the incoming Cocos plate, including significantly large sections of calcareous nannofossil ooze and chalk, is underthrust beneath the overriding Caribbean plate. The large amount of subducted carbonate produces characteristic styles of volcanic and seismic activity that differ from those found farther along strike in Nicaragua and elsewhere. An understanding of the fate of subducted carbonate sediment sections is an essential component to our understanding of the global biogeochemical cycling of carbon dioxide. Because Leg 205 drilling operations were performed within meters of the Leg 170 drill sites occupied during October-December 1996, minimal coring was done during Leg 205. Although the biostratigraphy of the Leg 170 sites has since been documented in detail, questions remained regarding the age and nature of a gabbro sill that was only partially penetrated by coring during Leg 170. Coring operations during Leg 205 fully penetrated the gabbro sill, followed by an additional 12 m of sediments below the sill, and then ~160 m of gabbro. Coring halted at 600 meters below seafloor (mbsf). Calcareous nannofossil age dating of the sediments immediately above the igneous sill, as well as the sediment between the sill and the lower igneous unit, indicates a minimum age of 15.6 Ma and a maximum age of 18.2 Ma for the sediments. This implies that the sill was emplaced more recently than 18.2 Ma. The calcareous nannofossil assemblage in baked sediments in contact with the top of the lower igneous unit also suggests that the maximum age for emplacement is 18.2 Ma. At Site 1254, coring was accomplished between 150 and 230 mbsf (prism section), and from 300 to 367.5 mbsf (prism and through the décollement into the underthrust section). In the interval from 150 to 322 mbsf, the biostratigraphic analysis of calcareous nannofossils suggests that the sediments are early Pleistocene age between 150 and 161 mbsf, late Pliocene age from 161 to 219 mbsf, and early Pliocene age from 219 to 222 mbsf (no younger than 3.75 Ma). The lack of marker fossils in the interval of sediments cored from 300 to 350.6 mbsf does not allow for any age determinations; however, sediments from 351.6 to 359.81 mbsf could be age dated and are also early Pliocene age, but no younger than 3.75 Ma.