Avaliação tribológica de novas modificações superficiais para cilindros de laminação a frio

The present work analyzed the tribological behavior of coatings/surface modifications traditionally used in cold rolling mill rolls and new coatings/surface modificationswith potential to replace the carcinogenic hard chrome. The study started with identification of wear mechanisms occurring in real coldrollingmill rolls. Due the high cost and dimensions of the rolls, thereplication technique was used. Replicas were obtained from 4 different rolling millBrazilian companies before and after a normal rolling campaign. Initial sliding tests were conducted using spherical and cylindrical counter bodies in order to verifywhichtribological conditions allowed to reproduce the wear mechanisms found in the replicas. These tests indicated the use of reciprocating sliding tests with cylindrical counter bodies (line contact), normal load of 100 N, and test times of and 1 h and 5 h. Different surface modifications were carried out on samples produced from a fragment of a rolling mill roll. The specimens were heat treated and ground on both sides. After, some specimens were surface textured by electrical discharge texturing (EDT). For both groups (ground and EDT), subsequent treatments of chromium plating, electroless NiP coating and plasma nitriding were carried out. The results of the reciprocating tests showed that specimens with electroless NiP coating presented the lowest friction coefficients, while plasma nitrided specimens showed the highest. In general, previous surface texturing before the coating/surface modification increased the wear of the counter bodies. Oneexceptionwas for EDT with subsequent electroless NiP coating, which presented the lowest counter bodies wear rate. The samples withelectroless NiP coating promoted a tribolayer consisting of Nickel, Phosphorus and Oxygen on both the specimens andthecounter bodies, which was apparently responsible for the reduction of friction coefficient and wear rate. The increase of the test time reduced the wear rate of the samples, apparently due the stability of the tribolayers formed, except for the nitrided samples. For the textured specimens, NiP coating showed the best performance in maintaining the surface topography of the specimens after the sliding tests.

Respostas ecofisiológicas de Cybistax antisyphilitica Mart. (Ipê verde) em função das alterações na intensidade de luz

Light varies widely in both time and space in forest formation of “Bioma Cerrado”. Cybistax antisyphilitica occurs in areas typical of this biome, such as cerrado sensu stricto, “cerradões”, and altered areas. The aim of this study was to understand the morphological and physiological responses of C. antisyphilitica to alterations in light intensity. Juvenile plants (5 month of age) were taken to a fragment of semideciduous forest in Uberlândia-MG, and were divided into three treatments: 50 were maintained under the canopy (UC) 20 were kept in small gap (SG) and 20 were maintained under in full sun (FS). The daily courses of chlorophyll a fluorescence were made at the beginning, middle and end of dry season in 2015. At the end of the experiment measurements of chlorophyll content, gas exchange and growth were made. The plants showed dynamic photoinhibition as exhibited by reductions on Fv/Fm close to midday at the end of the dry season. Regarding the effective quantum yield (ΔF/Fm'), plants under FS showed reduced values that coincided with the higher values of electron transport rates (ETR). Plants under FS showed higher values of net CO2 assimilation rates, stomatal conductance, transpiration rates, water use efficiency and chlorophyll content compared to plants under UC. The stem diameter, dry mass of leaves and stem, total dry mass and relative growth rate were higher in plants under FS than plants under UC. On the other hand, plants under UC showed superior values of height, specific leaf area and leaf area ratio. Our results indicate that C. antisyphilitica has plasticity to survive in the contrasting light environments of the semideciduous forests, but this species was able to growth better under full sun conditions.