Mineral and oxygen isotopic compositions in a profile through the altered lower oceanic crust, ODP Hole 176-735B

ODP Hole 735B located on the Southwest Indian Ridge at 57°E is an in situ sampled long, continuous section of lower oceanic crust. Oxygen isotope compositions of constituent minerals of Leg 176 gabbros have been measured by UV-laser oxygen isotope microprobe. Together with existing data from Leg 118, a complete oxygen isotope profile through the lower oceanic crust has been obtained. Most clinopyroxenes and olivines have normal mantle values of ~5.5 per mil and ~5.2 per mil, respectively, while plagioclases show slight d18O enrichment relative to its mantle value of 6.1per mil. Down-hole variations of Hole 735B gabbro indicate a downward decreasing d18O profile, with a kink at a depth of about 800 m below sea floor. Above this depth, gabbros are depleted in 18O relative to unaltered basalts, while below ~800 m they show nearly unmodified d18O values. Abundant seawater penetration appears to be limited to the upper part of the lower crust at ODP site 735 (~800 m into the gabbroic layer and ~2-2.5 km into the oceanic crust from the top of pillow basalts). Mass balance calculations show that the lower crust formed under this ultra-slow-spreading ridge has an average d18O value of 5.5 per mil. The whole crust at Site 735 has an overall 18O enrichment with d18O values of 6.0 per mil to 7.8 per mil, depending on the possible variation of the d18O values of the upper pillow basalts and sheeted dykes. The apparent difference in oxygen isotope compositions of ocean crusts formed with different spreading rates has important implications on the buffering of ocean water over geological time, as well as on the oxygen recycling between crust and mantle through subduction. The difference of seawater penetration between fast- and slow-spreading ridges could be related to their particular magmatic-tectonic history during the formation and aging of the crust. However, more analyses on continuous sections through oceanic and ophiolitic crust in different tectonic settings are required to derive any predictive models.

Mineral quantification of a Jordan Cretaceous outcrop (Section GM3, Ghawr Al Mazar, Ghor al Mazrar)

Cyclic fluctuations in global sea level during epochs of warm greenhouse climate have remained enigmatic, because absence or subordinate presence of polar ice during these periods precludes an explanation by glacio-eustatic forcing. An alternative concept suggests that the water-bearing potential of groundwater aquifers is equal to that of ice caps and that changes in the dynamic balance of aquifer charge versus discharge, as a function of the temperature-related intensity of the hydrological cycle, may have driven eustasy during warm climates. However, this idea has long been neglected for two reasons: 1) the large storage potential of subsurface aquifers was confused with the much smaller capacity of rivers and lakes and 2) empirical data were missing that document past variations in the hydrological cycle in relation to eustasy. In the present study we present the first empirical evidence for changes in precipitation, continental weathering intensity and evaporation that correlate with astronomically (long obliquity) forced sea-level cycles during the warmest period of the Cretaceous (Cenomanian-Turonian). We compare sequence-stratigraphic data with changes in the terrigenous mineral assemblage in a low-latitude marine sedimentary sequence from the equatorial humid belt at the South-Tethyan margin (Levant carbonate platform, Jordan), thereby avoiding uncertainties from land-ocean correlations. Our data indicate covariance between cycles in weathering and sea level: predominantly chemical weathering under wet climate conditions is reflected by dominance of weathering products (clays) in deposits that represent sea-level fall (aquifer charge > discharge). Conversely, preservation of weathering-sensitive minerals (feldspars, epidote and pyroxenes) in transgressive sediments reflects decreased continental weathering due to dryer climate (aquifer discharge > charge). Based on our results we suggest that aquifer-eustasy represents a viable alternative to glacio-eustasy as a driver of cyclic 3rd-order sea-level fluctuations during the middle Cretaceous greenhouse climate, and it may have been a pervasive process throughout Earth history.

Whole-rock and mineral geochemistry of ODP Hole 176-735B gabbros

We report mineral chemistry, whole-rock major element compositions, and trace element analyses on Hole 735B samples drilled and selected during Leg 176. We discuss these data, together with Leg 176 shipboard data and Leg 118 sample data from the literature, in terms of primary igneous petrogenesis. Despite mineral compositional variation in a given sample, major constituent minerals in Hole 735B gabbroic rocks display good chemical equilibrium as shown by significant correlations among Mg# (= Mg/[Mg + Fe2+]) of olivine, clinopyroxene, and orthopyroxene and An (=Ca/[Ca + Na]) of plagioclase. This indicates that the mineral assemblages olivine + plagioclase in troctolite, plagioclase + clinopyroxene in gabbro, plagioclases + clinopyroxene + olivine in olivine gabbro, and plagioclase + clinopyroxene + olivine + orthopyroxene in gabbronorite, and so on, have all coprecipitated from their respective parental melts. Fe-Ti oxides (ilmenite and titanomagnetite), which are ubiquitous in most of these rocks, are not in chemical equilibrium with olivine, clinopyroxene, and plagioclase, but precipitated later at lower temperatures. Disseminated oxides in some samples may have precipitated from trapped Fe-Ti-rich melts. Oxides that concentrate along shear bands/zones may mark zones of melt coalescence/transport expelled from the cumulate sequence as a result of compaction or filter pressing. Bulk Hole 735B is of cumulate composition. The most primitive olivine, with Fo = 0.842, in Hole 735B suggests that the most primitive melt parental to Hole 735B lithologies must have Mg# 0.637, which is significantly less than Mg# = 0.714 of bulk Hole 735B. This suggests that a significant mass fraction of more evolved products is needed to balance the high Mg# of the bulk hole. Calculations show that 25%-45% of average Eastern Atlantis II Fracture Zone basalt is needed to combine with 55%-75% of bulk Hole 735B rocks to give a melt of Mg# 0.637, parental to the most primitive Hole 735B cumulate. On the other hand, the parental melt with Mg# 0.637 is far too evolved to be in equilibrium with residual mantle olivine of Fo > 0.89. Therefore, a significant mass fraction of more primitive cumulate (e.g., high Mg# dunite and troctolite) is yet to be sampled. This hidden cumulate could well be deep in the lower crust or simply in the mantle section. We favor the latter because of the thickened cold thermal boundary layer atop the mantle beneath slow-spreading ridges, where cooling and crystallization of ascending mantle melts is inevitable. These observations and data interpretation require reconsideration of the popular concept of primary mantle melts and relationships among the extent of mantle melting, melt production, and the composition and thickness of igneous crust.

Water balance measurements on Samoylov Island during campaign Lena2011

The summer water balance of a typical Siberian polygonal tundra catchment is investigated in order to identify the spatial and temporal dynamics of its main hydrological processes. The results show that, besides precipitation and evapotranspiration, lateral flow considerably influences the site-specific hydrological conditions. The prominent microtopography of the polygonal tundra strongly controls lateral flow and storage behaviour of the investigated catchment. Intact rims of low-centred polygons build hydrological barriers, which release storage water later in summer than polygons with degraded rims and troughs above degraded ice wedges. The barrier function of rims is strongly controlled by soil thaw, which opens new subsurface flow paths and increases subsurface hydrological connectivity. Therefore, soil thaw dynamics determine the magnitude and timing of subsurface outflow and the redistribution of storage within the catchment. Hydraulic conductivities in the elevated polygonal rims sharply decrease with the transition from organic to mineral layers. This interface causes a rapid shallow subsurface drainage of rainwater towards the depressed polygon centres and troughs. The re-release of storage water from the centres through deeper and less conductive layers helps maintain a high water table in the surface drainage network of troughs throughout the summer.

Mineral, chemical and isotopic compositions of altered rocks at ODP Sites 193-1188 and 193-1189

During ODP Leg 193, 4 sites were drilled in the active PACMANUS hydrothermal field on the crest of the felsic Pual Ridge to examine the vertical and lateral variations in mineralization and alteration patterns. We present new data on clay mineral assemblages, clay and whole rock chemistry and clay mineral strontium and oxygen isotopic compositions of altered rocks from a site of diffuse low-temperature venting (Snowcap, Site 1188) and a site of high-temperature venting (Roman Ruins, Site 1189) in order to investigate the water-rock reactions and associated elemental exchanges. The volcanic succession at Snowcap has been hydrothermally altered, producing five alteration zones: (1) chlorite+/-illite-cristobalite-plagioclase alteration apparently overprinted locally by pyrophyllite bleaching at temperatures of 260-310°C; (2) chlorite+/-mixed-layer clay alteration at temperatures of 230°C; (3) chlorite and illite alteration; (4) illite and chlorite+/-illite mixed-layer alteration at temperatures of 250-260°C; and (5) illite+/-chlorite alteration at 290-300°C. Felsic rocks recovered from two holes (1189A and 1189B) at Roman Ruins, although very close together, show differing alteration features. Hole 1189A is characterized by a uniform chlorite-illite alteration formed at ~250°C, overprinted by quartz veining at 350°C. In contrast, four alteration zones occur in Hole 1189B: (1) illite+/-chlorite alteration formed at ~300°C; (2) chlorite+/-illite alteration at 235°C; (3) chlorite+/-illite and mixed layer clay alteration; and (4) chlorite+/-illite alteration at 220°C. Mass balance calculations indicate that the chloritization, illitization and bleaching (silica-pyrophyllite assemblages) alteration stages are accompanied by different chemical changes relative to a calculated pristine precursor lava. The element Cr appears to have a general enrichment in the altered samples from PACMANUS. The clay concentrate data show that Cr and Cu are predominantly present in the pyrophyllites. Illite shows a significant enrichment for Cs and Cu relative to the bulk altered samples. Considerations of mineral stability allow us to place some constraints on fluid chemistry. Hydrothermal fluid pH for the chloritization and illitization was neutral to slightly acidic and relatively acidic for the pyrophyllite alteration. In general the fluids, especially from Roman Ruins and at intermediate depths below Snowcap, show only a small proportion of seawater mixing (<10%). Fluids in shallow and deep parts of the Snowcap holes, in contrast, show stronger seawater influence.

(Table T1) Mineral composition of oriented clay aggregates from ODP Leg 190 sites

Three sites were cored on the landward slope of the Nankai margin of southwest Japan during Leg 190 of the Ocean Drilling Program. Sites 1175 and 1176 are located in a trench-slope basin that was constructed during the early Pleistocene (~1 Ma) by frontal offscraping of coarse-grained trench-wedge deposits. Rapid uplift elevated the substrate above the calcite compensation depth and rerouted a transverse canyon-channel system that had delivered most of the trench sediment during the late Pliocene (1.06-1.95 Ma). The basin's depth is now ~3000 to 3020 m below sea level. Clay-sized detritus (<2 µm) did not change significantly in composition during the transition from trench-floor to slope-basin environment. Relative mineral abundances for the two slope-basin sites average 36-37 wt% illite, 25 wt% smectite, 22-24 wt% chlorite, and 15-16 wt% quartz. Site 1178 is located higher up the landward slope at a water depth of 1741 m, ~70 km from the present-day deformation front. There is a pronounced discontinuity ~200 m below seafloor between muddy slope-apron deposits (Quaternary-late Miocene) and sandier trench-wedge deposits (late Miocene; 6.8-9.63 Ma). Clay minerals change downsection from an illite-chlorite assemblage (similar to Sites 1175 and 1176) to one that contains substantial amounts of smectite (average = 45 wt% of the clay-sized fraction; maximum = 76 wt%). Mixing in the water column homogenizes fine-grained suspended sediment eroded from the Izu-Bonin volcanic arc, the Izu-Honshu collision zone, and the Outer Zone of Kyushu and Shikoku, but the spatial balance among those contributors has shifted through time. Closure of the Central America Seaway at ~3 Ma was particularly important because it triggered intensification of the Kuroshio Current. With stronger and deeper flow of surface water toward the northeast, the flux of smectite from the Izu-Bonin volcanic arc was dampened and more detrital illite and chlorite were transported into the Shikoku-Nankai system from the Outer Zone of Japan.