(Table T1) Geochemical composition of tochilinite and related minerals of ODP Hole 173-1068A

Tochilinite (approximately FeS(Mg,Fe)(OH)2) is locally abundant in Hole 1068A serpentinites from Cores 173-1068A-21R and 22R. It occurs in veins, as fillings in void space, and in intergrowths with serpentine and andradite. An apparently related mineral, but with Ca and Al largely replacing Mg, occurs in association with, and possibly as a replacement of, pyrrhotite in serpentinite breccias from the bottom of Core 173-1068A-20R. The transition from Mg-Fe-rich brucite tochilinites to Ca- and S-rich carbonate tochilinites is consistent with increasing sulfur and oxygen activity upsection. Tochilinite has been reported at other sites on the Iberia Abyssal Plain and is abundant to the point of being a rock-forming mineral in several samples from Site 1068. Rather than being a mineralogical curiosity, tochilinite appears to be common and a major sink for sulfur in the upper serpentinites of the Iberia Abyssal Plain.

Chemistry of sediment profile GeoB4906

Mineralization of organic matter and the subsequent dissolution of calcite were simulated for surface sediments of the upper continental slope off Gabon by using microsensors to measure O2, pH, pCO2 and Ca2+ (in situ), pore-water concentration profiles of NO3-, NH4+, Fe2+, and Mn2+ and SO42- (ex situ), as well as sulfate reduction rates derived from incubation experiments. The transport and reaction model CoTReM was used to simulate the degradation of organic matter by O2, [NO3]-, Fe(OH)3 and [SO4]2-, reoxidation reactions involving Fe2+ and Mn2+, and precipitation of FeS. Model application revealed an overall rate of organic matter mineralization amounting to 50 µmol C cm**-2 yr**-1, of which 77% were due to O2, 17% to [NO3]- and 3% to Fe(OH)3 and 3% to [SO4]2-. The best fit for the pH profile was achieved by adapting three different dissolution rate constants of calcite ranging between 0.01 and 0.5% d-1 and accounting for different calcite phases in the sediment. A reaction order of 4.5 was assumed in the kinetic rate law. A CaCO3 flux to the sediment was estimated to occur at a rate of 42 g m**-2 yr**-1 in the area of equatorial upwelling. The model predicts a redissolution flux of calcite amounting to 36 g m**-2 yr**-1, thus indicating that ~90% of the calcite flux to the sediment is redissolved.

Geochemical parameters of sediments and water of the Black Sea, data of Cruise 8 of R/V Vityaz-2

The book presents results of comprehensive geological investigations carried out during Cruise 8 of R/V "Vityaz-2" to the western part of the Black Sea in 1984. Systematic studies in the Black Sea during about hundred years have not weakened interest in the sea. Lithological and geochemical studies of sediments in estuarine areas of the Danube and the Kyzyl-Irmak rivers, as well as in adjacent parts of the deep sea and some other areas were the main aims of the cruise. Data on morphological structures of river fans, lithologic and chemical compositions of sediments in the fans and their areal distribution, forms of occurrence of chemical elements, role of organic matter and gases in sedimentation and diagenesis are given and discussed in the book.

Pore water and sediment geochemistry of the Bothian Sea

Methane is a powerful greenhouse gas and its biological conversion in marine sediments, largely controlled by anaerobic oxidation of methane (AOM), is a crucial part of the global carbon cycle. However, little is known about the role of iron oxides as an oxidant for AOM. Here we provide the first field evidence for iron-dependent AOM in brackish coastal surface sediments and show that methane produced in Bothnian Sea sediments is oxidized in distinct zones of iron- and sulfate-dependent AOM. At our study site, anthropogenic eutrophication over recent decades has led to an upward migration of the sulfate/methane transition zone in the sediment. Abundant iron oxides and high dissolved ferrous iron indicate iron reduction in the methanogenic sediments below the newly established sulfate/methane transition. Laboratory incubation studies of these sediments strongly suggest that the in situ microbial community is capable of linking methane oxidation to iron oxide reduction. Eutrophication of coastal environments may therefore create geochemical conditions favorable for iron-mediated AOM and thus increase the relevance of iron-dependent methane oxidation in the future. Besides its role in mitigating methane emissions, iron-dependent AOM strongly impacts sedimentary iron cycling and related biogeochemical processes through the reduction of large quantities of iron oxides.

Geochemical and biogeochemical parameters of bottom sediments from the area of the Spitsbergen (Svalbard) Archipelago

Quantitative characteristics for rates of diagenetic processes in the upper (0-30 cm) layer of sedimentary deposits in the area of the Spitsbergen (Svalbard) Archipelago (78°-80°N) were obtained by lithologo-geochemical, radioisotope (35S, 14C), and stable isotope (d34S, d13C) studies. It was proved that rates of diagenetic processes in polar deposits at 123-395 m depth affected by the East Spitsbergen ''warm'' current are mostly determined by bioproductivity and are commensurate with rates of processes in shelf deposits of temperate latitudes. High contents of migratory methane (up to 263 ml/dm**3) and isotopically-light organic carbon (Corg, d13C = -30 per mil PDB) were found in the 1 m layer of shelf deposits (at 123 m sea depth) with low bacterial in situ production of methane. It was shown that methane is not utilized in the deposits by the methanotrophic bacterial community and it may be supplied to the water mass and, probably, to the atmosphere.

Pollen records of profile Krumbach from southern Germany

Some years ago a fossil lake basin was found in the northeastern part of the former Rhine-pied- mont-glacier, situated between the endmoraine system ofthe elassical Riß- andWürm glacia- tions, respectively. The lacustrine sediments contain the pollenflora ofthe Eemian interglacial. They are intensively thrusted. These sediments are eovered by a loam-layer, rieh in elasts. The thickness of this loam-layer varies between at least 170 and 400 cm. It consists in its major part of loess-loam and solifluction material. Yet just on top of the lake sediments mentioned an in- tensively compressed loam, characterized by quarzgrains with all features of glacially pressed material, together with striated elasts is met with. It strongly resembles atil!. Ifthis is true, the stratigraphie division ofthe last glaciation strongly deviates from the hitherto accepted scheme, incorporating an early glacier advance, long before the elassical young-endmoraine systems of the Würm glaciation were formed.

Contents, partition, and isotopic composition of sulphur in sediments from ODP Sites 680 and 686

We have determined (1) the abundance and isotopic composition of pyrite, monosulphide, elemental sulphur, organically bound sulphur, and dissolved sulphide; (2) the partition of ferric and ferrous iron; (3) the organic carbon contents of sediments recovered at two sites drilled on the Peru Margin during Leg 112 of the Ocean Drilling Program. Sediments at both sites are characterised by high levels of organically bound sulphur (OBS). OBS comprises up to 50% of total sedimentary sulphur and up to 1% of bulk sediment. The weight ratio of S to C in organic matter varies from 0.03 to 0.15 (mean = 0.10). Such ratios are like those measured in lithologically similar, but more deeply buried petroleum source rocks of the Monterey and Sisquoc formations in California. The sulphur content of organic matter is not limited by the availability of porewater sulphide. Isotopic data suggest that sulphur is incorporated into organic matter within a metre of the sediment surface, at least partly by reaction with polysulphides. Most inorganic Sulphur occurs as pyrite. Pyrite formation occurred within surface sediments and was limited by the availability of reactive iron. But despite highly reducing sulphidic conditions, only 35-65% of the total iron was converted to sulphide; 10-30% of the total iron still occurs as Fe(III). In surface sediments, the isotopic composition of pyrite is similar to that of both iron monosulphide and dissolved sulphide. Either pyrite, like monosulphide, formed by direct reaction between dissolved sulphide and detrital iron, and/or the sulphur species responsible for converting FeS to FeS2 is isotopically similar to dissolved sulphide. Likely stoichiometries for the reaction between ferric iron and excess sulphide imply a maximum resulting FeS2:FeS ratio of 1:1. Where pyrite dominates the pool of iron sulphides, at least some pyrite must have formed by reaction between monosulphide and elemental sulphur and/or polysulphide. Elemental sulphur (S°) is most abundant in surface sediments and probably formed by oxidation of sulphide diffusing across the sediment-water interface. In surface sediments, S° is isotopically heavier than dissolved sulphide, FeS and FeS2 and is unlikely to have been involved in the conversion of FeS to FeS2. Polysulphides are thus implicated as the link between FeS and FeS2.