Hydration of the Bisulfate Ion: Atmospheric Implications

Using molecular dynamics configurational sampling combined with ab initio energy calculations, we determined the low energy isomers of the bisulfate hydrates. We calculated the CCSD(T) complete basis set (CBS) binding electronic and Gibbs free energies for 53 low energy isomers of HSO4–(H2O)n=1–6 and derived the thermodynamics of adding waters sequentially to the bisulfate ion and its hydrates. Comparing the HSO4–/H2O system to the neutral H2SO4/H2O cluster, water binds more strongly to the anion than it does to the neutral molecules. The difference in the binding thermodynamics of HSO4–/H2O and H2SO4/H2O systems decreases with increasing number of waters. The thermodynamics for the formation of HSO4–(H2O)n=1–5 is favorable at 298.15 K, and that of HSO4–(H2O)n=1–6 is favorable for T < 273.15 K. The HSO4– ion is almost always hydrated at temperatures and relative humidity values encountered in the troposphere. Because the bisulfate ion binds more strongly to sulfuric acid than it does to water, it is expected to play a role in ion-induced nucleation by forming a strong complex with sulfuric acid and water, thus facilitating the formation of a critical nucleus.

Yolk Androstenedione in Domestic Chicks (Gallus Gallus Domesticus): Uptake and Sex-Dependent Alteration of Growth and Behavior

In birds, causes and consequences of variation in maternally-derived steroids in egg yolk have been the subject of intense experimentation. Many studies have quantified or manipulated testosterone ("T") and one of its immediate precursors, androstenedione ("A4") - often lumping the two steroids as "androgens" and treating them as functionally equivalent. However, yolk A4 is deposited in substantially higher concentrations than T, binds only weakly to the androgen receptor, and is readily converted into either T or estrone by steroidogenic enzymes present during embryonic development. Thus it may not be appropriate to assume that A4 has the same effect as T. In addition, A4's metabolic fate is likely to differ between females and males. The goals of this study were to examine the sex-specific uptake and metabolism of yolk A4 and consequences of elevated levels of yolk A4 on development and behavior of domestic chicks. Eggs were injected with 2mu Ci of tritiated androstenedione; radioactivity was detected in all tissues of day 7 and day 16 embryos and found in both aqueous and organics phases of day 7 yolk, with no difference between sexes. A second set of eggs was injected with 125ng of A4. A4 increased growth of morphological traits (tarsus, beak) in females, but not males. A4 males had smaller combs than controls; there was no treatment effect in females. A4 reduced tonic immobility behavior in both sexes. The results of this study illustrate the importance of distinguishing both between androgens and between sexes when investigating avian endocrine maternal effects. Copyright 2013 Elsevier Inc. All rights reserved.

Purification and Preliminary Characterization of the TM0727 Protein from Thermotoga maritima

The TM0727 gene of Thermotoga maritima is responsible for encoding what has been reported to be a modulator of DNA gyrase (pmbA). Although the function of pmbA is still unknown, it is believedto be involved in cell division, carbon storage regulation, and the synthesis of the antibiotic peptide microcin B17. It is suggested that it serves together with tldD, a known zinc dependent protease, tomodulate DNA gyrase. TM0727 is believed to be a zinc dependent protease that binds zinc in the central active site of the molecule, located between two equivalent monomeric units. However, thecrystal structure determined by Wilson et al. (2005) did not contain zinc. It therefore remains to be seen if TM0727 requires zinc for activity, or regulation, and if the protein is indeed a protease. To begin studying this protein, the gene was expressed in BL21(DE3) pLysS cells and the induction time was optimized. Using affinity and ion exchange chromatography, the protein has been successfully purified. The purification procedure can be replicated to obtain sufficient protein for characterization. Purification results show that the protein loses stability after 24 hours and remains stable under an imidazole-free lysis workup. Preliminary characterization of TM0727 has focused on understanding the protein’s structuralproperties through tryptophan fluorescence anisotropy measurements. The four tryptophan residues located within the TM0727 dimer fluoresce at different maximum wavelengths and with differentintensities upon excitation with 295nm light. These emission properties are highly sensitive to the environment (solvent, surrounding residues) of each tryptophan residue. The low number oftryptophans allows for a specific monitoring of the protein’s structure as it denatures. As more denaturant is added to the protein, its tryptophan environments have clearly altered. This is indicative of unfolding and increased solvent exposure of the protein. This unfolding has been confirmed with the addition of a fluorescent quencher. Additionally, fluorescence anisotropy measurements have been carried out on the protein to gain a preliminary understanding of the rotational dynamics of the tryptophan residues. These experiments excite the tryptophan residues within the sample using a polarized light source. Polarized emission is then detected, the degree of which depends on the rotational dynamics and local environment of the tryptophan residues. The protein was denatured and the changes in emission were recorded to detect these structural changes. Results have shown a large change in quaternary structure, consistent with a dimer to monomer transition, occurs at 1.5M Guandidine HCl. There has also been an examination of the crystal structure for the location of a potential active site. The inner cavity of the protein was inspected visually to locate a potential location for a catalytic triad, specifically the amino acids found in the active sites of serine, cyteine, and aspartateproteases. It was found that a potential aspartic protease active site may be located between the Asparate286 and Aspartate287 residues. Further investigation is warranted to test this remotepossibility.

Synthesis Of Linoleate Analogs With Longer Alkyl Termini To Test For Proposed "Tail-First" Binding In SBLO-1

Lipoxygenases are nonheme-iron proteins that catalyze the oxygenation of polyunsaturated fatty acids to give conjugated diene hydroperoxides. For example, soybean lipoxygenase-1 (SBLO-1) converts linoleate into 13-(S)-hydroperoxy-9(Z),11(E)-octadecadienoate (13(S)-HPOD). Although the crystal structure of SBLO-1 has been determined, it is still unclear how the substrate binds at the active site. This absence of knowledge makes it difficult to understand the role of the enzyme during catalysis of the reaction. We hypothesize that SBLO-1 binds linoleate ¿tail-first¿, so that the methyl terminus is within a hydrophobic pocket deep within the enzyme. It is believed that the hydrophobic residue phenylalanine-557 at this site has stabilizing interactions with the terminal methyl group on linoleate. To test this hypothesis, we have developed a synthetic pathway that will yield linoleate analogs with longer fatty acid chains by 1 and 2 more carbons at the alkyl terminus. These substrates will be analyzed through kinetic assays done in combination with wild type SBLO-1 and mutants in which we have replaced phenylalanine-557 with valine.

Study Of The Binding Of Substrate By The Phe557Val Mutant Soybean Lipoxygenase-1

Lipoxygenases are a class of enzymes which consist of non-heme iron dioxygenases that are produced by fungi, plants, and mammals and catalyze the oxygenation of polyunsaturated fatty acid substrates to unsaturated fatty acid hydroperoxide products. The unsaturated fatty acid hydroperoxide products are stereo- and regiospecific. One such lipoxygenase, soybean lipoxygenase-1 (SBLO-1), catalyzes the conversion of linoleate to 13-hydroperoxy-9(Z),11(E)-octadecadienoate (13-HPOD) and a small amount of 9-hydroperoxy-10(E),12(Z)-octadecadienoate (9-HPOD). Although the structure of SBLO-1 is known and it is the most widely studied lipoxygenase, how it binds to substrate is still poorly understood. Two competing binding hypotheses that have been used to understand and explain the binding are the head first binding model and the tail first binding model. The head first binding model predicts linoleate binds with its polar carboxylate group in the binding pocket and the methyl terminus at the surface of the binding pocket. The tail first binding model predicts that linoleate binds with its methyl terminus end in the binding pocket and the polar carboxylate group at the surface of the binding pocket. Both binding models have been used in the explanation of previous work. In previous work the replacement of phenylalanine with valine has been performed to produce the phe557val mutant SBLO-1. The mutant SBLO-1 was then used in the enzymatic oxygenation of linoleate. With this mutant, the amount of 9-HPOD that is formed increases. This result has been interpreted using the head-first binding model in which the smaller valine residue allows linoleate to bind with the polar carboxylate group of linoleate interacting with arginine-707. The work presented in this thesis confirms the regiochemical results of the previous work and further tests the head-first binding model. If head-first binding occurs, the 9-HPOD is expected to have primarily S configuration. Utilizing chiral-phase HPLC, it was found that the 9-HPOD produced by the phe557val mutant SBLO-1 is primarily S, consistent with head-first binding. The head-first binding model was also tested using linoleyl dimethylamine (LDMA), which has been shown to be a good substrate for SBLO-1 at pH 7.0, where LDMA is thought to be positively charged. This model predicts that less of the 9-peroxide should be produced with this substrate. Through the use of gas chromatography/mass spectrometry, it was found that the conversion of LDMA by the phe557val mutant SBLO-1 resulted in the formation of a 46:54 mixture of the 13-peroxide:9-peroxide. The higher amount of 9-peroxide is the opposite of what is expected for the currently proposed model suggesting that the proposed model may not be entirely correct. The results thus far have been consistent with reverse binding but not with the proposed interaction of the polar end of the substrate with arginine-707.