Does hyoid bone resection according to Sistrunk influence normal craniofacial growth? A cephalometric study

PURPOSE: To retrospectively evaluate the influence of hyoid bone resection according to Sistrunk in early age due to a thyroglossal duct cyst on craniofacial growth. MATERIALS AND METHODS: We retrospectively examined 10 patients (2 females and 8 males) having had hyoid bone resection according to Sistrunk due to thyroglossal duct cysts by lateral cephalograms taken before orthodontic treatment (mean, 17.1 years; range, 8.6-31.9 years). Surgery was carried out at a mean age of 4.4 years (range, 0.37-9.8 years). All lateral cephalograms were evaluated and traced by hand. Descriptive statistics were calculated, and data from each patient were compared individually with corresponding standard values (age and gender) from Bathia and Leighton. RESULTS: With regard to sagittal parameters, the SNB angles were by trend too small and the ANB angles were too large. However, the ratio of mandibular to maxillary length showed that the patients had a mandible that was too large or maxilla that was too small. With regard to vertical parameters, large deviations from normal values in both directions (hyperdivergent to hypodivergent pattern) could be detected when we analyzed NSL/ML', NL/ML', and NSL/NL. With regard to dental parameters, the majority of the patients had retroclined upper (IsL/NL, IsL/N-A) and lower (IiL/ML, IiL/N-B) incisors. CONCLUSIONS: Several vertical and horizontal skeletal and dental cephalometric parameters were shown to be different by trend when compared with control values. A possible negative impact on craniofacial growth potential and direction as a result of hyoid resection in early age according to Sistrunk cannot be excluded.

Does perioperative glucocorticosteroid treatment correlate with disturbance in surgical wound healing after treatment of facial fractures? A retrospective study

PURPOSE: To clarify whether perioperative glucocorticosteroid treatment used in association with repair of facial fractures predisposes to disturbance in surgical wound healing (DSWH). PATIENTS AND METHODS: Retrospective review of records of patients who had undergone open reduction, with or without ostheosynthesis, or had received reconstruction of orbital wall fractures during the 2-year period from 2003 to 2004. RESULTS: Steroids were administered to 100 patients (35.7%) out of a total of 280. Dexamethasone was most often used, with the most common regimen being dexamethasone 10 mg every 8 hours over 16 hours, with a total dose of 30 mg. The overall DSWH rate was 3.9%. The DSWH rate for patients who had received perioperative steroids was 6.0%, and the corresponding rate for patients who did not receive steroids was 2.8%. The difference was not statistically significant. An intraoral surgical approach remained the only significant predictor to DSWH. CONCLUSIONS: With regard to DSWH, patients undergoing operative treatment of facial fractures can safely be administered doses of 30 mg or less of perioperative glucocorticosteroids equivalent to dexamethasone.

Dental injuries in association with facial fractures

PURPOSE: The aim of the study was to investigate the association between dental injuries and facial fractures. MATERIALS AND METHODS: We performed a prospective study of 273 patients examined at a level 1 trauma center in Switzerland from September 2005 until August 2006 who had facial fractures. Medical history and clinical and radiologic examination findings were recorded to evaluate demographics, etiology, presentation, and type of facial fracture, as well as its relationship to dental injury site and type. RESULTS: In 273 patients with dentition, we recorded 339 different facial fractures. Of these patients, 130 (47.5%) sustained a fracture in the non-tooth-bearing region, 44 (16%) had a fractured maxilla, and 65 (24%) had a fractured mandible. Among 224 patients with dentition who had a facial fracture in only 1 compartment, 140 injured teeth were found in 50 patients. Of 122 patients with an injury limited to the non-tooth-bearing facial skeleton, 12 sustained dental trauma (10%). In patients with fractures limited to the maxilla (n = 41), 6 patients had dental injuries (14.5%). In patients with fractures to the mandible (n = 61), 24 sustained dental injuries (39%). When we compared the type of tooth lesion and the location, simple crown fractures prevailed in both jaws. Patients with a fracture of the mandible were most likely to have a dental injury (39.3%). The highest incidence of dental lesions was found in the maxilla in combination with fractures of the lower jaw (39%). This incidence was even higher than the incidence of dental lesions in the lower jaw in combination with fractures of the mandible (24%). CONCLUSIONS: Knowledge of the association of dental injuries and maxillofacial fractures is a basic tool for their prevention. Our study showed that in cases of trauma with mandibular fracture, the teeth in the upper jaw might be at higher risk than the teeth in the lower jaw. Further larger-scale studies on this topic could clarify this finding and may provide suggestions for the amelioration of safety devices (such as modified bicycle helmets).

Reporting completeness of abstracts of systematic reviews published in leading dental specialty journals

The aim of this study was to investigate the reporting completeness of systematic review (SR) abstracts in leading dental specialty journals. Electronic and supplementary hand searching were undertaken to identify SRs published in seven dental specialty journals and in the Cochrane Database of Systematic Reviews. Abstract reporting completeness was evaluated using a checklist derived from the Preferred Reporting Items for Systematic Reviews and Meta-Analyses (prisma) guidelines. Descriptive statistics followed by univariate and multivariate analyses were conducted. Two-hundred and eighteen SR abstracts were identified. Reporting of interventions (94%), objectives (96%), data sources (81%), eligibility criteria (77%), and conclusions (97%) was adequate in the majority of reviews. However, inadequate reporting of participants (18%), results (42%), effect size (14%), level of significance (60%), and trial registration (100%) was commonplace. The mean overall reporting score was 79.1% (95% CI, 77.6-80.6). Only journal of publication was a significant predictor of overall reporting, with inferior results for all journals relative to Cochrane reviews, with scores ranging from -4.3% (95% CI, -8.74 to 0.08) to -35.6% (95% CI, -42.0 to -24.3) for the International Journal of Prosthodontics and the British Journal of Oral and Maxillofacial Surgery, respectively. Improved reporting of dental SR abstracts is needed and should be encouraged, as these abstracts may underpin influential clinical decisions.

SADMFR guidelines for the use of Cone-Beam Computed Tomography/ Digital Volume Tomography

Cone-Beam Computed Tomography (CBCT) has been introduced in 1998. This radiological imaging procedure has been provided for dentistry and is comparable to computed tomography (CT) in medicine. It is expected that CBCT will have the same success in dental diagnostic imaging as computed tomography had in medicine. Just as CT is responsible for a significant rise in radiation dose to the population from medical X-ray diagnostics, CBCT studies will be accompanied by a significant increase of the dose to our patients by dentistry. Because of the growing concern for an uncritical and consequently rapidly increasing use of CBCT the Swiss Society of Dentomaxillofacial Radiology convened a first consensus conference in 2011 to formulate indications for CBCT, which can be used as guidelines. In this meeting, oral and maxillofacial surgery, orthodontics and temporomandibular joint disorders and diseases were treated and the most important and most experienced users of DVT in these areas were asked to participate. In general, a highly restrictive use of CBCT is required. Justifying main criterion for CBCT application is that additional, therapy-relevant information is expected that should lead to a significant benefit in patient care. All users of CBCT should have completed a structured, high-level training, just like that offered by the Swiss Society of Dentomaxillofacial Radiology.

SADMFR Guidelines for the Use of Cone-Beam Computed Tomography/Digital Volume Tomography

In 2011, the first consensus conference on guidelines for the use of cone-beam computed tomography (CBCT) was convened by the Swiss Society of Dentomaxillofacial Radiology (SGDMFR). This conference covered topics of oral and maxillofacial surgery, temporomandibular joint dysfunctions and disorders, and orthodontics. In 2014, a second consensus conference was convened on guidelines for the use of CBCT in endodontics, periodontology, reconstructive dentistry and pediatric dentistry. The guidelines are intended for all dentists in order to facilitate the decision as to when the use of CBCT is justified. As a rule, the use of CBCT is considered restrictive, since radiation protection reasons do not allow its routine use. CBCT should therefore be reserved for complex cases where its application can be expected to provide further information that is relevant to the choice of therapy. In periodontology, sufficient information is usually available from clinical examination and periapical radiographs; in endodontics alternative methods can often be used instead of CBCT; and for implant patients undergoing reconstructive dentistry, CT is of interest for the workflow from implant planning to the superstructure. For pediatric dentistry no application of CBCT is seen for caries diagnosis.

Soft-Tissue Simulation for Cranio-Maxillofacial Surgery: Clinical Needs and Technical Aspects

Computerized soft-tissue simulation can provide unprecedented means for predicting facial outlook pre-operatively. Surgeons can virtually perform several surgical plans to have the best surgical results for their patients while considering corresponding soft-tissue outcome. It could be used as an interactive communication tool with their patients as well. There has been comprehensive amount of works for simulating soft-tissue for cranio-maxillofacial surgery. Although some of them have been realized as commercial products, none of them has been fully integrated into clinical practice due to the lack of accuracy and excessive amount of processing time. In this chapter, state-of-the-art and general workflow in facial soft-tissue simulation will be presented, along with an example of patient-specific facial soft-tissue simulation method.

Automatic extraction of the mid-facial plane for cranio-maxillofacial surgery planning

Recently developed computer applications provide tools for planning cranio-maxillofacial interventions based on 3-dimensional (3D) virtual models of the patient's skull obtained from computed-tomography (CT) scans. Precise knowledge of the location of the mid-facial plane is important for the assessment of deformities and for planning reconstructive procedures. In this work, a new method is presented to automatically compute the mid-facial plane on the basis of a surface model of the facial skeleton obtained from CT. The method matches homologous surface areas selected by the user on the left and right facial side using an iterative closest point optimization. The symmetry plane which best approximates this matching transformation is then computed. This new automatic method was evaluated in an experimental study. The study included experienced and inexperienced clinicians defining the symmetry plane by a selection of landmarks. This manual definition was systematically compared with the definition resulting from the new automatic method: Quality of the symmetry planes was evaluated by their ability to match homologous areas of the face. Results show that the new automatic method is reliable and leads to significantly higher accuracy than the manual method when performed by inexperienced clinicians. In addition, the method performs equally well in difficult trauma situations, where key landmarks are unreliable or absent.

Predictors of swallowing outcome in patients treated with surgery and radiotherapy for advanced oral and oropharyngeal cancer

Retaining effective swallowing is a key element when optimising outcomes in the management of head and neck cancer. We report the functional swallowing outcomes for a cohort of 31 individuals with advanced oral and oropharyngeal cancer who underwent free or pedicled flap reconstruction of surgical defects. Swallowing was assessed pre and immediately post surgery and at four months post treatment. Swallowing assessments were related to site, size and volume of defect and composition of flap reconstruction. The effect of radiotherapy on swallowing was assessed among 17 of the 31 individuals who were submitted to radiotherapy after surgery. The proportion of patients on a total oral diet four months post treatment varied significantly by site of defect (Fishers exact test p=0.006), from 100% (7/7) of patients with a lateral defect to only 22% (2/9) of patients with a central defect. The proportion of patients on a total oral diet at the final assessment did not vary by flap reconstruction or radiotherapy.

A multidisciplinary approach to the functional and esthetic rehabilitation of amelogenesis imperfecta and open bite deformity: a case report

The treatment of amelogenesis imperfecta (AI) with an anterior open bite (AOB) is a challenge for the clinician and often requires a multidisciplinary team of specialists. Most often, patients suffering from these conditions are young and a good functional and esthetic long-term result must be aspired. This clinical report illustrates the orthodontic, maxillofacial, restorative, and prosthodontic rehabilitation of a 20-year-old woman with a hypoplastic form of AI and an AOB malocclusion, having received treatment for the last 6 years. It included adhesive resin composite restorations, orthodontical and maxillofacial surgery with a one-piece Le Fort I osteotomy, and a genioplasty. Subsequent prosthodontic therapy consisted of 28 all-ceramic crowns whereby a solid interdigitation, a canine guidance, and consistent and regular contacts between tooth crowns could be achieved to assure a good functional and esthetic oral situation. The tooth preparation techniques guaranteed minimally invasive treatment. The patient was affected very positively. CLINICAL SIGNIFICANCE: This article describes an interdisciplinary approach to the successful treatment of a patient with a hypoplastic form of amelogenesis imperfecta over a period of 6 years. It starts with a discussion of the conservative steps taken during adolescence and concludes with the final prosthetic rehabilitation with all-ceramic crowns after reaching adulthood.

Anatomically-Driven Soft-Tissue Simulation Strategy for Cranio-Maxillofacial Surgery Using Facial Muscle Template Model

We propose a computationally efficient and biomechanically relevant soft-tissue simulation method for cranio-maxillofacial (CMF) surgery. A template-based facial muscle reconstruction was introduced to minimize the efforts on preparing a patient-specific model. A transversely isotropic mass-tensor model (MTM) was adopted to realize the effect of directional property of facial muscles in reasonable computation time. Additionally, sliding contact around teeth and mucosa was considered for more realistic simulation. Retrospective validation study with postoperative scan of a real patient showed that there were considerable improvements in simulation accuracy by incorporating template-based facial muscle anatomy and sliding contact.

[Oral medicine: a specialty placed between medicine and dentistry]

Oral medicine is a dental specialty that bridges the traditional areas of health between dentistry and medicine. International descriptions reflect this and oral medicine is defined as "the dental speciality placed at the interface between medicine and dentistry and is concerned with the diagnosis and management of (non-dental) pathology affecting the oral and maxillofacial region." Oral medicine specialists provide clinical care to patients with a wide variety of orofacial conditions, including oral mucosal diseases, orofacial pain syndromes, salivary gland disorders, and oral manifestations of systemic diseases. There is a growing need to implement this specialty globally: due to the rapid progress in both medicine and dentistry, and to the growing percentage of senior citizens in many countries, the adequate diagnosis and treatment of oral diseases will become even more complex in the future. In this article, the authors' intention is to point out that oral medicine is neither a recognized specialty nor a distinct field of study in Germany, Austria, or Switzerland; thus, the need for postgraduate training in this field in countries where oral medicine is not a specialization is emphasized.