Residue decay of insecticides applied with mineral oil on clementine fruits

Three insecticides (chlorpyrifos methyl, dimethoate and fenthion) were applied on clementine fruits with and without mineral oil to assess the effect of mineral oil on pesticide residues. In both experiments the residues on the fruits after the last treatment and at harvest time were not significantly different.

Fruit quality in the peach and nectarine with application of hydrogenated cyanamide and mineral oil

This work evaluated the quality of the fruit in peach and nectarine cultivars with and without the application of hydrogenated cyanamide and mineral oil, for two production cycles (2009 and 2010). The experiment was carried out at the School of Agricultural Science of the São Paulo State University (UNESP), at Botucatu in the Brazilian state of São Paulo, located at latitude 22º51'55 S and longitude 48º26'22 E, at an altitude of 810 m. The predominant climate type is warm temperate (mesothermal) with rains in the summer and dry in the winter. The following were evaluated: soluble solids, titratable acidity, pH, ratio, firmness, vitamin C and pulp yield. The use of hydrogenated cyanamide and mineral oil had no effect on the quality attributes of the fruit, except for pH, where those fruits under application of the products showed higher values. The cultivars all had a pulp yield greater than 90%, with 'Tourmaline' showing the highest yield (96 %). The levels of vitamin C varied according to the cultivars, where 'Marli' (16.9 mg 100 g-1) and 'Dourado-2' (16.5 mg 100 g-1), stood out for having the highest levels.

Lixiviação de sulfentrazone e amicarbazone em colunas de solo com adição de óleo mineral

O presente trabalho teve por objetivo avaliar a lixiviação dos herbicidas sulfentrazone e amicarbazone, com e sem óleo mineral, em área de plantio de cana-de-açúcar sobre um Latossolo Vermelho-Escuro, por meio de colunas de solo. Para avaliação da lixiviação, após acumuladas as precipitações de 35, 67 e 106 mm, tubos de PVC de 10 cm de diâmetro, seccionados longitudinalmente, foram enterrados até a profundidade de 35 cm, procurando-se manter a estrutura original do solo. Os tubos foram retirados, separados em suas metades e acondicionados em casa de vegetação, onde se semearam as plantas-teste sorgo (Sorghum bicolor) e corda-de-viola (Ipomoea nil) longitudinalmente ao longo do perfil de cada metade dos tubos. O delineamento experimental utilizado foi o de blocos ao acaso em esquema de parcelas subdivididas, com quatro repetições. As parcelas consistiram da aplicação dos dois herbicidas, adicionados ou não de adjuvante, e uma testemunha sem herbicida. Nas subparcelas estudaram-se as profundidades de percolação (0,0-2,5; 2,5-5,0; 5,0-10; 10-15; 15-20; 20-25; 25-30; e 30-35 cm). Aos 20 dias após a semeadura, determinou-se a matéria seca das plântulas. Observou-se que o sulfentrazone lixiviou até 10 cm de profundidade, mesmo com 106 mm de precipitação, sem efeito diferenciado do óleo. Os efeitos foram mais pronunciados para o sorgo. O amicarbazone não interferiu na matéria seca das plântulas de sorgo. Quanto à corda-de-viola, o herbicida sob precipitação de 35 mm reduziu o desenvolvimento das plântulas, independentemente da profundidade e sem efeito diferenciado do óleo; com 67 mm de precipitação, o herbicida lixiviou pelo solo, e o óleo mineral o manteve na camada mais superficial. Com 106 mm, o herbicida foi totalmente lixiviado e não se constatou efeito do óleo.

Produção e sazonalidade de pessegueiro e nectarineira sob florescimento espontâneo e com cianamida hidrogenada e óleo mineral

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Pressure drop correlation for oil-refrigerant R134a mixture flashing flow in a small diameter tube

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Measurement of fats, oil and grease by spectro-photometry and its application on different sites at São Paulo State, Brazil

This investigation was carried out within the Parana sedimentary basin, Brazil, involved the sampling of effluents and groundwater from monitoring stations situated at different sites at São Paulo State, and was realized with the purpose of evaluating the presence of fats, oil and grease (FOG) in different matrices. Several tests were realized with very distinct materials (cooking oil, butter, margarine, pig fat, vacuum pump oil) in order to properly calibrate the spectrophotometric system. Each matrix was dissolved with 1,1,1-trichloroethane and from the stock solutions it was prepared working standards from different dilutions. The data obtained were plotted on absorbance vs. concentration graph that yielded a successful calibration curve when a mineral oil for vacuum pump was utilized in the experiments at a wavelength corresponding to 410 mn. The results obtained for the analyzed samples were compared with the limiting value established by the São Paulo State legislation on the prevention and pollution control of the environment that was established in 8(th) September 1976 by Rule No. 8468.

Selective factors involved in oil flotation isolation of black yeasts from the environment

The oil flotation isolation technique has been successfully applied to recover chaetothyrialean black yeasts and relatives from the environment. The selective mechanisms playing a role in isolation are unknown. The fungi concerned are supposed to occupy specialized microniches in nature, taking advantage of (1) oligotrophism. Mineral oil as a main selective agent may be based on (2) hydrophobicity or on (3) assimilation. All three hypotheses are tested in this paper. Results show that cell wall hydrophobicity is unlikely to be a selective factor. Incubation under poor nutrient conditions provides competitive advantage for black yeasts, especially for Exophiala strains, which are subsequently enriched by mineral oil which enhances growth in this group of fungi. Incubation under mineral media and mineral oil can be used as selective factor.

Monitoramento da degradação térmica de óleo mineral isolante de transformador utilizando espectroscopia de absorção e fluorescência UV-Vis

Pós-graduação em Engenharia Elétrica - FEIS

Remoção pela chuva de diferentes formulações de flutriafol aplicada em soja, com e sem a adição de óleo mineral na calda

Pós-graduação em Agronomia (Energia na Agricultura) - FCA

Localização de descargas parciais em transformadores de potência imersos em óleo mineral por meio de cápsulas piezelétricas de baixo custo e sistemas inteligentes

Coordenação de Aperfeiçoamento de Pessoal de Nível Superior (CAPES)

Effect of oil overlay on inhibition potential of roscovitine in sheep cumulus-oocyte complexes

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)

Remoção pela chuva de diferentes formulações de flutriafol aplicada em soja, com e sem a adição de óleo mineral na calda

The present study had as objectives to verify the effect of rainfastness of different flutriafol formulations, in laboratory conditions, applied on soybean plants with and without the oil adjuvant in the spray solution, as well as to verify the influence of the oil on the droplet spectrum. The experiment considered ten spray solutions related to five treatments containing flutriafol (four formulations of flutriafol and a flutriafol mixture with tebuconazole), all applied with and without mineral oil. Particles size analysis were based on the determination of the droplet spectrum, medium volumetric diameter and the amount of droplets below 100 μm. All the solutions were sprayed with Teejet XR 11001 (fine droplets). Droplet spectrum was determined in a direct way by diffraction of laser (Malvern Mastersizer S®, version 2.15). Confidence interval at 90% degree was used to compare the mean data. The results showed that the addition of mineral oil in the solutions provided tendencies of larger medium volumetric diameter, smaller amount of droplets below than 100 µm and better uniformity of the droplet spectrum. All of the solutions with the addition of mineral oil presented larger adhesion and/or absorption of the fungicide on the plants in comparison with the solutions without oil. The increase of the time between the application and the rain, caused reduction of the fungicide removal, independently of the rain intensity. The increase of the amount of rain didn't change the relative behavior among the solutions; however, this larger amount of rain caused larger fungicide removal along the time. It was observed significant removal of flutriafol by the rain up to 48 hours after the spray application.

Poly(Lactide-co-Glycolide) Nanocapsules Containing Benzocaine: Influence of the Composition of the Oily Nucleus on Physico-Chemical Properties and Anesthetic Activity

Fundação de Amparo à Pesquisa do Estado de São Paulo (FAPESP)