Wastewater reuse and treatment options for the dairy industry

Milk-processing plants generate significant quantities of wastewater with relatively high organic matter concentrations on a daily basis. In addition to environmental damage that can result from the discharge of these wastewaters into the natural waterways, the presence of products such as milk solids into wastewater streams represents a loss of valuable product for the plants. This paper presents a review of wastewater management practices employed by six milk-processing plants in Victoria, Australia. In all six plants investigated, milk powder represents a major product. During the milk powder production, water is evaporated, condensed and can be reused for various purposes with a significant impact on water usage. Other major products are anhydrous milk fat, cheese, butter, and UHT milk. The effectiveness of the practices was assessed through two main criteria: first through the water to milk intake ratio, and the waste volume coefficient. Both parameters characterise the plant efficiency in regard of water consumption and water reuse, Information on cleaning chemical usage and recovery was also assessed as part of the review. Significant discrepancies emerge between the plants first due to the products manufacturad and water reuse possibilities available in each plant. Second the type of treatment technologies used for condensate and cleaning solution influences the figures. One of the investigated plants is almost self-sufficient for water, emphasising the benefits gained from the use of technologies like membrane separations for condensate and cleaning solution treatment. In some cases, less cost-intensive technologies such as a clarifier are successful to improve cleaning agent recovery.

Sodium adsorption using activated alumina for application in the dairy industry

Basic activated alumina with negatively charged surface is considered as a potential adsorbent for a targeted molecule with positive polarity. Adsorption of sodium by basic activated alumina was investigated as a method for desalting dairy waste streams, in which sodium ion concentration averaged 600 mg/L. Sodium equilibrium and kinetic adsorption were investigated using basic activated alumina with synthetic brines. The results of equilibrium adsorption show that uptake of sodium by activated alumina is significantly higher when the pH is greater than 8 and increases as the pH of the brines increases until pH reaches around 10. The results of kinetic adsorption show that 90 hours were needed to reach equilibrium for sodium adsorption. Binding and diffusion processes are suggested to have taken place within the activated alumina.

Incorporating environmental impacts into productivity analysis: the case for nitrogen leaching in the Australian dairy industry

This paper examines how the adoption of a system's perspective to the use of both marketed and public resources can be incorporated into an analysis of productivity measurement.  A biophysical model is used to measure the environmental inputs which are combined with conventional marketed inputs to develop a Malmquist Productivity Index to determine social productivity growth over the perios under study.  The analysis is applied to data collected from selected farms in south west Victoria and includes a measure of leaching and run-off as a proxy measure of the impact the application of fertilizers has on ground and surface water.  Although the sample is small, the results show measured productivity growth differs when environmental factors are considered.

Input usage, output mix and industry deregulation: an analysis of the Australian dairy manufacturing industry

In this paper we estimate a Translog output distance function for a balanced panel of state level data for the Australian dairy processing sector. We estimate a fixed effects specification employing Bayesian methods, with and without the imposition of monotonicity and curvature restrictions. Our results indicate that Tasmania and Victoria are the most technically efficient states with New South Wales being the least efficient. The imposition of theoretical restrictions marginally affects the results especially with respect to estimates of technical change and industry deregulation. Importantly, our bias estimates show changes in both input use and output mix that result from deregulation. Specifically, we find that deregulation has positively biased the production of butter, cheese and powders.

The challenge for the dairy industry arising from the new health claims standard: an impetus for innovation

The publication of a Preliminary Final Assessment Report on 4 April 2007 heralded another step towards the introduction of a new Health Claims Standard to be inserted into the Australia New Zealand Food Standards Code. This Health Claims Standard, once approved by the Board of Food Standards Australia New Zealand and by the Australia New Zealand Food Regulation Ministerial Council, will permit the making of certain substantiated health claims. Prior to the introduction of the new Standard, health claims have not been permitted on food labels, with the exception of claims in relation to maternal folate consumption and its positive effect in reducing the risk of foetal neural tube defects. The new Health Claims Standard as outlined in the Preliminary Final Assessment Report is likely to have a significant impact on the dairy industry. This paper seeks to analyse that impact, including threats, opportunities and challenges that the Standard poses to the dairy industry and other food suppliers.

Efficiency measurement of Australian dairy farms: national and regional performance

In this paper we use Data Envelopment Analysis (DEA) to estimate technical efficiency for a sample of 1742 Australian dairy farms. Bearing in mind data limitations we find that average technical efficiency is 59 per cent, but there are significant regional differences. These results reflect differences in State level milk marketing arrangements in place before dairy deregulation in July 2000 providing an ex post explanation for the changing composition of dairy farms in Australia. We also examine two important technical aspects of DEA implementation. First, how changes in model input specification alter the relative performance of farms. Second, we employ a simple bootstrap procedure to show how changes in sample size affects estimates of technical efficiency. These results have simple but important implications for the use of DEA as an industry-benchmarking tool.

Scale efficiency in Australian dairy farms

Data Envelope Analysis, (DEA), a linear programming technique, provides a more consistent measure of efficiency than the commonly cited partial measures of farm efficiency. It yields a relative measure of efficiency and identifies inputs or outputs that are under utilized.

In this paper, DEA is used to assess the technical efficiency of a sample of dairy farms across all dairy regions in Australia. Regions vary in size and scale of operation and are examined to see the relationship between farm size and technical efficiency, and to see if there is justification in the move towards bigger dairy production units than currently exist, given their factor mix.

Environmental efficiency : meaning and measurement and application to Australian dairy farms

Technical efficiency has been widely studied in the literature, but in its pursuit, many of the inputs used can impact on the environment. Environmental effects can be modelled as undesirable output or, as has been the case in more recent studies, as conventional inputs. This paper examines the concept of environmental efficiency and how it can be used to evaluate the performance of Australian dairy farming, using nitrogen surplus, arising from excessive applications of fertilizer, as a detrimental input. Farming promotes the image of clean and green production and if this image is to be maintained, there is a need to ensure activities are environmentally friendly.

Dietary approaches for weight loss with increased intakes of fruit, vegetables and dairy products

Aim: To assess the effectiveness of specific advice for increasing fruit, vegetable and dairy intake in free-living men participating in a weight loss study.

Methods: Subjects were randomised to one of two 12-week weight loss diets, either the WELL with daily targets of four serves of fruit, four serves of vegetables and three serves of dairy or a low fat diet (LF) with general advice to increase fruit and vegetable intake. Three-day food group diaries and a food frequency questionnaire assessed intake.

Results: Fifty-four overweight/obese male adults completed the study (WELL, n = 27; LF, n = 27; body mass index (mean ± standard deviation), 30.4 ± 2.5 kg/m²; age, 47.7 ± 9.5 years). There was no difference in mean weight change between groups (WELL, −4.8 ± 3.3 kg; LF, −4.6 ± 3.1 kg). Subjects on the WELL diet had greater (mean difference ± standard error) fruit (0.7 ± 0.2 serves/day), vegetable (1.2 ± 0.2 serves/day) and dairy (1.1 ± 0.1 serves/day) intakes than the LF group (measured by the food group diaries) (all P < 0.01). The WELL group reached the daily target for fruit from week 1 (4.7 ± 1.4 serves/day), vegetables by week 6 (4.1 ± 1.5 serves/day) and for dairy by week 8 (3.0 ± 0.8 serves/day).

Conclusions: Providing specific dietary targets to men for weight loss appears to promote greater consumption of fruit, vegetable and dairy foods than providing general dietary advice. Meeting dietary targets appears to require different adjustment periods depending on the food type.