Ultrasensitive hydrogen sensor based on Pd0-loaded SnO2 electrospun nanofibers at room temperature

Pd0-loaded SnO2 nanofibers have been successfully synthesized with different loaded levels via electrospinning process, sintering technology, and in situ reduction. This simple strategy could be expected to extend for the fabrication of similar metal?oxide loaded nanofibers using different precursors. The morphological and structural characteristics of the resultant product were investigated by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction (XRD), and X-ray photoelectron spectra (XPS). To demonstrate the usage of such Pd0-loaded SnO2 nanomaterial, a chemical gas sensor has been fabricated and investigated for H2 detection. The sensing performances versus Pd0-loaded levels have been investigated in detail. An ultralow limit of detection (20 ppb), high response, fast response and recovery, and selectivity have been obtained on the basis of the sensors operating at room temperature. The combination of SnO2 crystal structure and catalytic activity of Pd0-loaded gives a very attractive sensing behavior for applications as real-time monitoring gas sensors.

Machinability and phase transformation study of nanobainite steels

There is an increasing demand for high strength materials with the development of technology and critical applications. Nano materials are newly developed materials with extremely high strength for this purpose. Nanobainite is a dual phase material containing alternate layers of bainitic ferrite in nano dimensions and retained austenite. Nanobainite is produced by isothermally holding austenitized steel at a temperature of 200°C or less, depending on the chemical composition, for 6 10 days until bainite forms and then cooling to room temperature using austempering. The experimental design consisted of face milling under 12 combinations of Depth of Cut (DOC)-1, 2 and 3mm; cutting speed-100 and 150m/min; constant feed-0.15mm/rev and coolant on/off. The machinability of the material is assessed by means of analysis, such as surface texture and microhardness. The assessment also involves microstructural comparisons before and after milling. Future work involves quantifying the microstructural phase before and after milling using XRD. The results obtained are used to assess the most favorable condition to cut this new variety of steel.