Pilot study of the short-term physico-chemical stability of atenolol tablets stored in a multi-compartment compliance aid

Study objectives: There is a possibility that lower air, moisture and light protection could impact on physico-chemical stability of medicines inside multi-compartment compliance aids (MCCAs), although this has not yet been proved. The objectives of the study were to examine the physico-chemical stability of atenolol tablets stored in a compliance aid at room temperature, and at elevated temperature and humidity to simulate practice conditions. Methods: Atenolol 100 mg tablets in 28-chamber, plastic compliance aids with transparent lids were stored for four weeks at room temperature and at 40°C with 75% relative humidity. Tablets were also stored at room temperature in original packaging and Petri dishes. Physical tests were conducted to standards as laid down in the British Pharmacopoeia 2005, and dissolution to those of the United States Pharmacopoeia volume 24. Chemical stability was assessed by a validated high-performance liquid chromatography (HPLC) method. Results: Tablets at room temperature in original packaging, in compliance aids and Petri dishes remained the same in appearance and passed physico-chemical tests. Tablets exposed to 40°C with 75% relative humidity in compliance aids passed tests for uniformity of weight, friability and chemical stability but became pale and moist, softer (82 newtons ± 4; p< 0.0001) than tablets in the original packaging (118 newtons ± 6), more friable (0.14% loss of mass) compared with other tablets (0.005%), and failed the tests for disintegration (>15 minutes) and dissolution (only 15% atenolol released at 30 minutes). Conclusion: Although chemical stability was unaffected, storage in compliance aids at 40°C with 75% relative humidity softened atenolol tablets, prolonged disintegration time and hindered dissolution which could significantly reduce bioavailability. This formulation could be suitable for storage in compliance aids at 25°C, but not in hotter, humid weather.

New insights into the compressibility and high-pressure stability of Ni(CN)2: a combined study of neutron diffraction, Raman spectroscopy, and inelastic neutron scattering

Nickel cyanide is a layered material showing markedly anisotropic behaviour. High-pressure neutron diffraction measurements show that at pressures up to 20.1 kbar, compressibility is much higher in the direction perpendicular to the layers, c, than in the plane of the strongly chemically bonded metal-cyanide sheets. Detailed examination of the behaviour of the tetragonal lattice parameters, a and c, as a function of pressure reveal regions in which large changes in slope occur, for example, in c(P) at 1 kbar. The experimental pressure dependence of the volume data is fitted to a bulk modulus, B0, of 1050 (20) kbar over the pressure range 0–1 kbar, and to 124 (2) kbar over the range 1–20.1 kbar. Raman spectroscopy measurements yield additional information on how the structure and bonding in the Ni(CN)2 layers change with pressure and show that a phase change occurs at about 1 kbar. The new high-pressure phase, (Phase PII), has ordered cyanide groups with sheets of D4h symmetry containing Ni(CN)4 and Ni(NC)4 groups. The Raman spectrum of phase PII closely resembles that of the related layered compound, Cu1/2Ni1/2(CN)2, which has previously been shown to contain ordered C≡N groups. The phase change, PI to PII, is also observed in inelastic neutron scattering studies which show significant changes occurring in the phonon spectra as the pressure is raised from 0.3 to 1.5 kbar. These changes reflect the large reduction in the interlayer spacing which occurs as Phase PI transforms to Phase PII and the consequent increase in difficulty for out-of-plane atomic motions. Unlike other cyanide materials e.g. Zn(CN)2 and Ag3Co(CN)6, which show an amorphization and/or a decomposition at much lower pressures (~100 kbar), Ni(CN)2 can be recovered after pressurising to 200 kbar, albeit in a more ordered form.

A longitudinal study of sero-conversion to tick-borne pathogens in smallholder dairy youngstock in Tanzania

A longitudinal study of sero-conversion of youngstock to the tick-borne pathogens Theileria parva, T mutans, Anaplasma marginale, Babesia bigemina and B. bovis was conducted over two years on smallholder dairy farms in Tanga region, Tanzania. There was evidence of maternal antibodies to all tick-borne pathogens in animals less than 18 weeks of age. Seroprevalence increased as expected with age in animals older than this but seroprevalence profiles underestimated the force of infection due to waning antibody levels between samplings. By the end of the 2-year study, less than 50% of study animals had seroconverted to each of the tick-borne pathogens investigated, consistent with the low levels of tick attachment observed on the study animals. Some associations between seroconversion to tick-borne pathogens, and counts of their known tick vectors on the animals, were identified as expected. However, some were not, suggesting that counts of some tick species may act as an index of rates of attachment of other vector species. Variation in acaricide treatment frequencies was not associated with variations in tick-borne pathogen seroprevalence suggesting that acaricides may be used more frequently than necessary on many farms. Most animals were zero-grazed, a management system associated with a significantly lower likelihood that animals seroconverted to any tick-borne pathogen exceptA. marginale. Seroprevalence varied locally with farm location (particularly for Babesia spp.) but was not well predicted by indices of ecological conditions. Our findings suggest that attempts to achieve a state of 'endemic stability' for tick-bome pathogens may be unreasonable on the smallholder dairy farms studied but reductions in the frequency of use of acaricides may be possible following prospective studies of effects on mortality and morbidity due to tick-bome pathogens. (c) 2005 Elsevier B.V. All rights reserved.

A case study of sea breeze blocking regulated by sea surface temperature along the English south coast

The sensitivity of sea breeze structure to sea surface temperature (SST) and coastal orography is investigated in convection-permitting Met Office Unified Model simulations of a case study along the south coast of England. Changes in SST of 1 K are shown to significantly modify the structure of the sea breeze immediately offshore. On the day of the case study, the sea breeze was partially blocked by coastal orography, particularly within Lyme Bay. The extent to which the flow is blocked depends strongly on the static stability of the marine boundary layer. In experiments with colder SST, the marine boundary layer is more stable, and the degree of blocking is more pronounced. Although a colder SST would also imply a larger land–sea temperature contrast and hence a stronger onshore wind – an effect which alone would discourage blocking – the increased static stability exerts a dominant control over whether blocking takes place. The implications of prescribing fixed SST from climatology in numerical weather prediction model forecasts of the sea breeze are discussed.

Lattice dynamics study of microstructures of electrorheological fluids

The lattice dynamics method is used to study the stability of the chain structures formed in electrorheological (ER) fluids. The appearance of the soft modes in the phonon dispersion of the structures indicates that the chains tend to distort and aggregate into thicker columns due to the electrostatic attractive forces and thermal generated forces between them. The results show that the stability of the chains relies on their width and the separation between them. The complete chain structures are more stable than the chains with defects. The results can be used to elucidate the densification phenomenon of the chains in the structuring process of ER fluids in the quiescent state.

Exploring farmer preferences for contagious bovine pleuropneumonia vaccination: a case study of Narok District, Kenya

Contagious bovine pleuropneumonia (CBPP) is an economically important disease in most of sub-Saharan Africa. A conjoint analysis and ordered probit regression models were used to measure the preferences of farmers for CBPP vaccine and vaccination attributes. This was with regard to inclusion or not of an indicator in the vaccine, vaccine safety, vaccine stability as well as frequency of vaccination, vaccine administration and the nature of vaccination. The analysis was carried out in 190 households in Narok District of Kenya between October and December 2006 using structured questionnaires, 16 attribute profiles and a five-point Likert scale. The factors affecting attribute valuation were shown through a two-way location interaction model. The study also demonstrated the relative importance (RI) of attributes and the compensation value of attribute levels. The attribute coefficient estimates showed that farmers prefer a vaccine that has an indicator, is 100% safe and is administered by the government (p<0.0001). The preferences for the vaccine attributes were consistent with expectations. Preferences for stability, frequency of vaccination and nature of vaccination differed amongst farmers (p>0.05). While inclusion of an indicator in the vaccine was the most important attribute (RI=43.6%), price was the least important (RI=0.5%). Of the 22 household factors considered, 15 affected attribute valuation. The compensation values for a change from non inclusion to inclusion of an indicator, 95-100% safety, 2h to greater than 2h stability and from compulsory to elective vaccination were positive while those for a change from annual to biannual vaccination and from government to private administration were negative. The study concluded that the farmers in Narok District had preferences for specific vaccine and vaccination attributes. These preferences were conditioned by various household characteristics and disease risk factors. On average the farmers would need to be compensated or persuaded to accept biannual and private vaccination against CBPP. There is need for consideration of farmer preferences for vaccine attribute levels during vaccine formulations and farmer preferences for vaccination attribute levels when designing delivery of vaccines.

Considerations on the use of the p-nitrophenyl phosphomonoesterase assay in the study of the phosphorus nutrition of soil borne fungi

The p-nitrophenyl phosphomonoesterase assay (p NPPase) is commonly used to measure cell-wall-associated and extracellular phosphatase activity of soil fungi. p NPPases are usually assayed in the context of fungal nutrition, where inorganic P supply might be enhanced by the mineralisation of monoester organic P sources in the soil. The importance of the assay to the P nutrition of soil fungi is considered based on the evidence currently available including the consistency of methodological approach. The nature of organic P in the soil and the relevance of the assay to some specific soil substrates is discussed, particularly the chemistry and bioavailability of myo-inositol hexakisphosphate and the lower inositol phosphates. The evidence for the long-term stability of p NPPases in the soil is examined in the light of the persistence of p NPPase in soils. The role of persistent extracellular fungal p NPPases in the soil P cycle is discussed. Conclusions from p NPPase based studies must be based upon an appreciation of the constraints of the assay and the complex chemistry of organic P and p NPPase in the soil.