Modelling and simulation of a photovoltaic fuel cell hybrid system

A stand-alone power system is an autonomous system that supplies electricity to the user load without being connected to the electric grid. This kind of decentralized system is frequently located in remote and inaccessible areas. It is essential for about one third of the world population which are living in developed or isolated regions and have no access to an electricity utility grid. The most people live in remote and rural areas, with low population density, lacking even the basic infrastructure. The utility grid extension to these locations is not a cost effective option and sometimes technically not feasible. The purpose of this thesis is the modelling and simulation of a stand-alone hybrid power system, referred to as “hydrogen Photovoltaic-Fuel Cell (PVFC) hybrid system”. It couples a photovoltaic generator (PV), an alkaline water electrolyser, a storage gas tank, a proton exchange membrane fuel cell (PEMFC), and power conditioning units (PCU) to give different system topologies. The system is intended to be an environmentally friendly solution since it tries maximising the use of a renewable energy source. Electricity is produced by a PV generator to meet the requirements of a user load. Whenever there is enough solar radiation, the user load can be powered totally by the PV electricity. During periods of low solar radiation, auxiliary electricity is required. An alkaline high pressure water electrolyser is powered by the excess energy from the PV generator to produce hydrogen and oxygen at a pressure of maximum 30bar. Gases are stored without compression for short- (hourly or daily) and long- (seasonal) term. A proton exchange membrane (PEM) fuel cell is used to keep the system’s reliability at the same level as for the conventional system while decreasing the environmental impact of the whole system. The PEM fuel cell consumes gases which are produced by an electrolyser to meet the user load demand when the PV generator energy is deficient, so that it works as an auxiliary generator. Power conditioning units are appropriate for the conversion and dispatch the energy between the components of the system. No batteries are used in this system since they represent the weakest when used in PV systems due to their need for sophisticated control and their short lifetime. The model library, ISET Alternative Power Library (ISET-APL), is designed by the Institute of Solar Energy supply Technology (ISET) and used for the simulation of the hybrid system. The physical, analytical and/or empirical equations of each component are programmed and implemented separately in this library for the simulation software program Simplorer by C++ language. The model parameters are derived from manufacturer’s performance data sheets or measurements obtained from literature. The identification and validation of the major hydrogen PVFC hybrid system component models are evaluated according to the measured data of the components, from the manufacturer’s data sheet or from actual system operation. Then, the overall system is simulated, at intervals of one hour each, by using solar radiation as the primary energy input and hydrogen as energy storage for one year operation. A comparison between different topologies, such as DC or AC coupled systems, is carried out on the basis of energy point of view at two locations with different geographical latitudes, in Kassel/Germany (Europe) and in Cairo/Egypt (North Africa). The main conclusion in this work is that the simulation method of the system study under different conditions could successfully be used to give good visualization and comparison between those topologies for the overall performance of the system. The operational performance of the system is not only depending on component efficiency but also on system design and consumption behaviour. The worst case of this system is the low efficiency of the storage subsystem made of the electrolyser, the gas storage tank, and the fuel cell as it is around 25-34% at Cairo and 29-37% at Kassel. Therefore, the research for this system should be concentrated in the subsystem components development especially the fuel cell.

Functional genomics of the Drosophila melanogaster X chromosome and the role of DWnt5 during development

The collection of X chromosome insertions (PX) lethal lines, which was isolated from a screen for essential genes on the X chromosome, was characterized by means of cloning the insertion sites, mapping the sites within genomic DNA and determination of the associated reporter gene expresssion patterns. The established STS flanking the P element insertion sites were submitted to EMBL nucleotide databases and their in situ data together with the enhancer trap expression patterns have been deposited in the FlyView database. The characterized lines are now available to be used by the scientific community for a detailed analysis of the newly established lethal gene functions. One of the isolated genes on the X chromosome was the Drosophila gene Wnt5 (DWnt5). From two independent screens, one lethal and three homozygous viable alleles were recovered, allowing the identification of two distinct functions for DWnt5 in the fly. Observations on the developing nervous system of mutant embryos suggest that DWnt5 activity affects axon projection pattern. Elevated levels of DWNT5 activity in the midline cells of the central nervous system causes improper establishment and maintenance of the axonal pathways. Our analysis of the expression and mutant phenotype indicates that DWnt5 function in a process needed for proper organization of the nervous system. A second and novel function of DWnt5 is the control of the body size by regulation of the cell number rather than affecting the size of cells. Moreover, experimentally increased DWnt5 levels in a post-mitotic region of the eye imaginal disc causes abnormal cell cycle progression, resulting in additional ommatidia in the adult eye when compared to wild type. The increased cell number and the effects on the cell cycle after exposure to high DWNT5 levels is the result of a failure to downregulate cyclin B and therefore the unsuccessful establishment of a G1 arrest.