Comparative analysis of the fit of 3-unit implant-supported frameworks cast in nickel-chromium and cobalt-chromium alloys and commercially pure titanium after casting, laser welding, and simulated porcelain firings

This study compared the vertical misfit of 3-unit implant-supported nickel-chromium (Ni-Cr) and cobalt-chromium (Co-Cr) alloy and commercially pure titanium (cpTi) frameworks after casting as 1 piece, after sectioning and laser welding, and after simulated porcelain firings. The results on the tightened side showed no statistically significant differences. On the opposite side, statistically significant differences were found for Co-Cr alloy (118.64 mu m [SD: 91.48] to 39.90 mu m [SD: 27.13]) and cpTi (118.56 mu m [51.35] to 27.87 mu m [12.71]) when comparing 1-piece to laser-welded frameworks. With both sides tightened, only Co-Cr alloy showed statistically significant differences after laser welding. Ni-Cr alloy showed the lowest misfit values, though the differences were not statistically significantly different. Simulated porcelain firings revealed no significant differences.

The oscillatory bioelectrical signal from plants explained by a simulated electrical model and tested using Lempel-Ziv complexity

This paper demonstrates the oscillatory characteristics of electrical signals acquired from two ornamental plant types (Epipremnum pinnatum and Philodendron scandens - Family Araceae), using a noninvasive acquisition system. The electrical signal was recorded using Ag/AgCl superficial electrodes inside a Faraday cage. The presence of the oscillatory electric generator was shown using a classical power spectral density. The Lempel and Ziv complexity measurement showed that the plant signal was not noise despite its nonlinear behavior. The oscillatory characteristics of the signal were explained using a simulated electrical model that establishes that for a frequency range from 5 to 15 Hz, the oscillatory characteristic is higher than for other frequency ranges. All results show that non-invasive electrical plant signals can be acquired with improvement of signal-to-noise ratio using a Faraday cage, and a simple electrical model is able to explain the electrical signal being generated. (C) 2010 Elsevier B.V. All rights reserved.

South Atlantic Ocean cyclogenesis climatology simulated by regional climate model (RegCM3)

A detailed climatology of the cyclogenesis over the Southern Atlantic Ocean (SAO) from 1990 to 1999 and how it is simulated by the RegCM3 (Regional Climate Model) is presented here. The simulation used as initial and boundary conditions the National Centers for Environmental Prediction-Department of Energy (NCEP/DOE) reanalysis. The cyclones were identified with an automatic scheme that searches for cyclonic relative vorticity (zeta(10)) obtained from a 10-m height wind field. All the systems with zeta(10) a parts per thousand currency sign -1.5 x 10(-5) s(-1) and lifetime equal or larger than 24 h were considered in the climatology. Over SAO, in 10 years were detected 2,760 and 2,787 cyclogeneses in the simulation and NCEP, respectively, with an annual mean of 276.0 +/- A 11.2 and 278.7 +/- A 11.1. This result suggests that the RegCM3 has a good skill to simulate the cyclogenesis climatology. However, the larger model underestimations (-9.8%) are found for the initially stronger systems (zeta(10) a parts per thousand currency sign -2.5 x 10(-5) s(-1)). It was noted that over the SAO the annual cycle of the cyclogenesis depends of its initial intensity. Considering the systems initiate with zeta(10) a parts per thousand currency sign -1.5 x 10(-5) s(-1), the annual cycle is not well defined and the higher frequency occurs in the autumn (summer) in the NCEP (RegCM3). The stronger systems (zeta(10) a parts per thousand currency sign -2.5 x 10(-5) s(-1)) have a well-characterized high frequency of cyclogenesis during the winter in both NCEP and RegCM3. This work confirms the existence of three cyclogenetic regions in the west sector of the SAO, near the South America east coast and shows that RegCM3 is able to reproduce the main features of these cyclogenetic areas.

An assessment of the latent and sensible heat flux on the simulated regional climate over Southwestern South Atlantic Ocean

A Regional Climate Model (RegCM3) 10-year (1990-1999) simulation over southwestern South Atlantic Ocean (SAO) is evaluated to assess the mean climatology and the simulation errors of turbulent fluxes over the sea. Moreover, the relationship between these fluxes and the rainfall over some cyclogenetic areas is also analyzed. The RegCM3 results are validated using some reanalyses datasets (ERA40, R2, GPCP and WHOI). The summer and winter spatial patterns of latent and sensible heat fluxes simulated by the RegCM3 are in agreement with the reanalyses (WHOI, R2 and ERA40). They show large latent heat fluxes exchange in the subtropical SAO and at higher latitudes in the warm waters of Brazil Current. In particular, the magnitude of RegCM3 latent heat fluxes is similar to the WHOI, which is probably related to two factors: (a) small specific humidity bias, and (b) the RegCM3 flux algorithm. In contrast, the RegCM3 presents large overestimation of sensible heat flux, though it simulates well their spatial pattern. This simulation error is associated with the RegCM3 underestimation of the 2-m air temperature. In southwestern SAO, in three known cyclogenetic areas, the reanalyses and the RegCM3 show the existence of different physical mechanisms that control the annual cycles of latent/sensible heating and rainfall. It is shown that over the eastern coast of Uruguay (35A degrees-43A degrees S) and the southeastern coast of Argentina (44A degrees-52A degrees S) the sea-air moisture and heat exchange play an important role to control the annual cycle of precipitation. This does not happen on the south/southeastern coast of Brazil.

Comparing performance of instrumental drift correction by linear and quadratic adjusting in inductive electromagnetic data

Electromagnetic induction (EMI) method results are shown for vertical magnetic dipole (VMD) configuration by using the EM38 equipment. Performance in the location of metallic pipes and electrical cables is compared as a function of instrumental drift correction by linear and quadratic adjusting under controlled conditions. Metallic pipes and electrical cables are buried at the IAG/USP shallow geophysical test site in Sao Paulo City. Brazil. Results show that apparent electrical conductivity and magnetic susceptibility data were affected by ambient temperature variation. In order to obtain better contrast between background and metallic targets it was necessary to correct the drift. This correction was accomplished by using linear and quadratic relation between conductivity/susceptibility and temperature intending comparative studies. The correction of temperature drift by using a quadratic relation was effective, showing that all metallic targets were located as well deeper targets were also improved. (C) 2010 Elsevier B.V. All rights reserved.

Consequences of Simulated Loss of Open Cerrado Areas to Bird Functional Diversity

Over the past 35 years, more than two thirds of the Cerrado`s original expanse has been taken by agriculture. Even if some attempts have been made to conserve closed cerrado physiognomies, open cerrado physiognomies, richer in species and more fragile, have been systematically ignored. These open physiognomies are used by almost half of the Cerrado bird species, many of which being endemics. Using data from 11 surveys carried out in Cerrado landscapes, we asked what would happen to bird functional diversity if open cerrado species became extinct. Open cerrado birds would be able to keep on average 59% of the functional diversity. If they became extinct, on average 27% of the functional diversity would be lost. In this case, the remaining functional diversity would be lower than what would be expected by chance in five sites. Although many functions were shared by both open cerrado and forest species, there was some degree of complementarity between them, highlighted by the decrease in functional diversity when the former became extinct. Destruction of open cerrado physiognomies would lead to a habitat simplification, decrease in bird functional diversity, and, ultimately, to a considerable impact on community functioning. Thus, open cerrado physiognomies must receive much more conservation attention than they are currently receiving, because they maintain a high bird functional diversity that would otherwise be considerably diminished Were open cerrado species to become extinct.

Balanced polymorphism in bottlenecked populations: The case of the CCR5 5 ` cis-regulatory region in Amazonian Amerindians

The 5` cis-regulatory region of the CCR5 gene exhibits a strong signature of balancing selection in several human populations. Here we analyze the polymorphism of this region in Amerindians from Amazonia, who have a complex demographic history, including recent bottlenecks that are known to reduce genetic variability. Amerindians show high nucleotide diversity (pi = 0.27%) and significantly positive Tajima`s D, and carry haplotypes associated with weak and strong gene expression. To evaluate whether these signatures of balancing selection could be explained by demography, we perform neutrality tests based on empiric and simulated data. The observed Tajima`s D was higher than that of other world populations: higher than that found for 18 noncoding regions of South Amerindians, and higher than 99.6% of simulated genealogies, which assume nonequilibrium conditions. Moreover, comparing Amerindians and Asians, the Fst for CCR5 cis-regulatory region was unusually low, in relation to neutral markers. These findings indicate that, despite their complex demographic history, South Amerindians carry a detectable signature of selection on the CCR5 cis-regulatory region. (C) 2010 American Society for Histocompatibility and Immunogenetics. Published by Elsevier Inc. All rights reserved.

In situ impedance spectroscopy study of the electrochemical corrosion of Ti and Ti-6Al-4V in simulated body fluid at 25 degrees C and 37 degrees C

The corrosion resistance of Ti and Ti-6Al-4V was investigated through electrochemical impedance spectroscopy, EIS, potentiodynamic polarisation curves and UV-Vis spectrophotometry. The tests were done in Hank solution at 25 degrees C and 37 degrees C. The EIS measurements were done at the open circuit potential at specific immersion times. An increase of the resistance as a function of the immersion time was observed, for Ti (at 25 degrees C and 37 degrees C), and for Ti-6Al-4V (at 25 degrees C), which was interpreted as the formation and growth of a passive film on the metallic surfaces. (C) 2009 Elsevier Ltd. All rights reserved.