Rugulotrosins A and B: Two new antibacterial metabolites from an Australian isolate of a penicillium sp.

Two new antibacterial agents, rugulotrosin A (1) and B (2), were obtained from cultures of a Penicillium sp. isolated from soil samples acquired near Sussex Inlet, New South Wales, Australia. Rugulotrosin A (1) is a chiral symmetric dimer, and its relative stereostructure was determined by spectroscopic and X-ray crystallographic analysis. Rugulotrosin B (2) is a chiral asymmetric dimer isomeric with 1. Its structure was determined by spectroscopic analysis with comparison to the co-metabolite 1 and previously reported fungal metabolites. Both rugulotrosins A and B displayed significant antibacterial activity against Bacillus subtilis, while rugulotrosin A was also strongly active against Enterococcus faecalis and B. cereus.

Fluctuations and single molecules

The fluorescence of single molecules coupled to a thermal bath is studied both experimentally and theoretically. The effect of different fluctuations on the coherence properties of resonance fluorescence is considered first. Coherence is measured in an interference experiment where a single molecule is used as a light source. A standard approach based on the optical Bloch equations apparently provides quite an accurate description of the interference experiment. Systems with long correlation times (where spectra are time dependent on any timescale) are considered next. It is shown that intensity-time-frequency correlation spectroscopy, which provides both high signal-to-noise ratio and high time resolution, is very suitable for such a case. The Bloch equations are further tested in an experiment where the shape of an excitation spectral line of a single molecule is accurately measured over six orders of magnitude of the exciting laser power. Significant deviations from the predictions of the Bloch equations are found. The role of critical parameters-the correlation time of the bath, the Rabi oscillation period, and the coupling constant between the bath and the molecule-is discussed. The paper also includes a short general introduction to the methodology of single-molecule studies.

Service performance of engineering materials

Corrosion research by Atrens and co-workers has made significant contributions to the understanding of the service performance of engineering materials. This includes: (1) elucidated corrosion mechanisms of Mg alloys, stainless steels and Cu alloys, (2) developed an improved understanding of passivity in stainless steels and binary alloys such as Fe-Cr, Ni-Cr, Co-Cr, Fe-Ti, and Fe-Si, (3) developed an improved understanding of the melt spinning of Cu alloys, and (4) elucidated mechanisms of environment assisted fracture (EAF) of steels and Zr alloys. This paper summarises contributions in the following: (1) intergranular stress corrosion cracking of pipeline steels, (2) atmospheric corrosion and patination of Cu, (3) corrosion of Mg alloys, and (4) transgranular stress corrosion cracking of rock bolts.

Characterization of activated carbon fibers using argon adsorption

In this paper, we present results of the internal structure (pore size and pore wall thickness distributions) of a series of activated carbon fibers with different degrees of burn-off, determined from interpretation of argon adsorption data at 87 K using infinite and finite wall thickness models. The latter approach has recently been developed in our laboratory. The results show that while the low bun-off samples have nearly uniform pore size (

Structural and stereochemical revision of isocyanide and isothiocyanate amphilectenes from the Caribbean marine sponge Cribochalina sp.

The absolute stereochemistry of amphilectene metabolites from Cribochalina sp. has been revised by a detailed NMR spectroscopic study of the Mosher ester derivatives of a related alcohol. The relative stereochemistry of the previously described amphilectenes has been reinvestigated and reassigned on the basis of the X-ray structural analysis carried out on one of them. The structure of a new amphilectene metabolite, which is an isothiocyanato analogue is also presented. (c) 2005 Elsevier Ltd. All rights reserved.

The combined SPE : ToxY-PAM phytotoxicity assay; application and appraisal of a novel biomonitoring tool for the aquatic environment

Mounting concerns regarding the environmental impact of herbicides has meant a growing requirement for accurate, timely information regarding herbicide residue contamination of, in particular, aquatic systems. Conventional methods of detection remain limited in terms of practicality due to high costs of operation and the specialised information that analysis provides. A new phytotoxicity bioassay was trialled for the detection of herbicide residues in filter-purified (Milli-Q) as well as natural waters. The performance of the system, which combines solid-phase extraction (SPE) with the ToxY-PAM dual-channel yield analyser (Heinz Walz GmbH), was tested alongside the traditional method of liquid chromatography-mass spectrometry (LC-MS). The assay methodology was found to be highly sensitive (LOD 0.1 ng L-1 diuron) with good reproducibility. The study showed that the assay protocol is time effective and can be employed for the aquatic screening of herbicide residues in purified as well as natural waters.

Why H Atom Prefers the On-Top Site and Alkali Metals Favor the Middle Hollow Site on the Basal Plane of Graphite

In this work, the different adsorption properties of H and alkali metal atoms on the basal plane of graphite are studied and compared using a density functional method on the same model chemistry level. The results show that H prefers the on-top site while alkali metals favor the middle hollow site of graphite basal plane due to the unique electronic structures of H, alkali metals, and graphite. H has a higher electronegativity than carbon, preferring to form a covalent bond with C atoms, whereas alkaline metals have lower electronegativity, tending to adsorb on the highest electrostatic potential sites. During adsorption, there are more charges transferred from alkali metal to graphite than from H to graphite.

Environmental contamination of arsenic and its toxicological impact on humans

Inorganic arsenic compounds are known carcinogens. The human epidemiologic evidence of arsenic-induced skin, lung, and bladder cancers is strong. However, the evidence of arsenic carcinogenicity in animals is very limited. Lack of a suitable animal model until recent years has inhibited studies of the mechanism of arsenic carcinogenesis. The toxicity and bioavailability of arsenic depend on its solubility and chemical forms. Therefore, it is critical to be able to measure arsenic speciation accurately and reliably. However, speciation of arsenic in more complex matrices remains a real challenge. There are tens of millions of people who are being exposed to excessive levels of arsenic in the drinking water alone. The source of contamination is mainly of natural origin and the mass poisoning is occurring worldwide, particularly in developing countries. Chronic arsenicosis resulting in cancer and non-cancer diseases will impact significantly on the public health systems in their respective countries. Effective watershed management and remediation technologies in addition to medical treatment are urgently needed in order to avoid what has been regarded as the largest calamity of chemical poisoning in the world.

Aquatic passive sampling of herbicides on naked particle loaded membranes: Accelerated measurement and empirical estimation of kinetic parameters

Water-sampler equilibrium partitioning coefficients and aqueous boundary layer mass transfer coefficients for atrazine, diuron, hexazionone and fluometuron onto C18 and SDB-RPS Empore disk-based aquatic passive samplers have been determined experimentally under a laminar flow regime (Re = 5400). The method involved accelerating the time to equilibrium of the samplers by exposing them to three water concentrations, decreasing stepwise to 50% and then 25% of the original concentration. Assuming first-order Fickian kinetics across a rate-limiting aqueous boundary layer, both parameters are determined computationally by unconstrained nonlinear optimization. In addition, a method of estimation of mass transfer coefficients-therefore sampling rates-using the dimensionless Sherwood correlation developed for laminar flow over a flat plate is applied. For each of the herbicides, this correlation is validated to within 40% of the experimental data. The study demonstrates that for trace concentrations (sub 0.1 mu g/L) and these flow conditions, a naked Empore disk performs well as an integrative sampler over short deployments (up to 7 days) for the range of polar herbicides investigated. The SDB-RPS disk allows a longer integrative period than the C18 disk due to its higher sorbent mass and/or its more polar sorbent chemistry. This work also suggests that for certain passive sampler designs, empirical estimation of sampling rates may be possible using correlations that have been available in the chemical engineering literature for some time.

Atom probe field ion microscope measurements of carbon segregation at an a:a grain boundary and service failures by intergranular stress corrosion cracking

This work reports on a critical measurement to understand the intergranular stress corrosion cracking (IGSCC) of pipeline steels: the atom probe field ion microscope (APFIM) measurement of the carbon concentration at a grain boundary (GB). The APFIM measurement was related to the microstructure and to IGSCC observations. The APFIM indicated that the GB carbon concentration of X70 was similar to 10 at% or less, which correlated with a high resistance to IGSCC for X70. (C) 2005 Elsevier Ltd. All rights reserved.

South Pacific law materials bibliography

The South Pacific is an area of emerging importance to lawyers in North America and throughout the world. Dr. Care's bibliography provides a comprehensive introduction to the legal materials of Melanesia, Micronesia, and Polynesia.

A Comparison of Methodologies from Two Longitudinal Community-Based Randomized Controlled Trials of Similar Interventions in Palliative Care: What Worked and What Did Not

Background: Methodological challenges such as recruitment problems and participant burden make clinical trials in palliative care difficult. In 2001-2004, two community-based randomized controlled trials (RCTs) of case conferences in palliative care settings were independently conducted in Australia-the Queensland Case Conferences trial (QCC) and the Palliative Care Trial (PCT). Design: A structured comparative study of the QCC and PCT was conducted, organized by known practical and organizational barriers to clinical trials in palliative care. Results: Differences in funding dictated study designs and recruitment success; PCT had 6 times the budget of QCC. Sample size attainment. Only PCT achieved the sample size goal. QCC focused on reducing attrition through gatekeeping while PCT maximized participation through detailed recruitment strategies and planned for significant attrition. Testing sustainable interventions. QCC achieved a higher percentage of planned case conferences; the QCC strategy required minimal extra work for clinicians while PCT superimposed conferences on normal work schedules. Minimizing participant burden. Differing strategies of data collection were implemented to reduce participant burden. QCC had short survey instruments. PCT incorporated all data collection into normal clinical nursing encounters. Other. Both studies had acceptable withdrawal rates. Intention-to-treat analyses are planned. Both studies included substudies to validate new outcome measures. Conclusions: Health service interventions in palliative care can be studied using RCTs. Detailed comparative information of strategies, successes and challenges can inform the design of future trials. Key lessons include adequate funding, recruitment focus, sustainable interventions, and mechanisms to minimize participant burden.

Perceptual speed does not cause intelligence, and intelligence does not cause perceptual speed

There is ongoing debate whether the efficiency of local cognitive processes leads to global cognitive ability or whether global ability feeds the efficiency of basic processes. A prominent example is the well-replicated association between inspection time (IT), a measure of perceptual discrimination speed, and intelligence (IQ), where it is not known whether increased speed is a cause or consequence of high IQ. We investigated the direction of causation between IT and IQ in 2012 genetically related subjects from Australia and The Netherlands. Models in which the reliable variance of each observed variable was specified as a latent trait showed IT correlations of -0.44 and -0.33 with respective Performance and Verbal IQ; heritabilities were 57% (IT), 83% (PIQ) and 77% (VIQ). Directional causation models provided poor fits to the data, with covariation best explained by pleiotropic genes (influencing variation in both IT and IQ). This finding of a common genetic factor provides a better target for identifying genes involved in cognition than genes which are unique to specific traits.