PMMA-co-EHA cements for osteoprotheses

The main purpose of this thesis was to produce new formulations of PMMA-co- EHA and study its feasibility as being an alternative to traditional PMMA bone cements. Thus, were originally produced several co-polymers of PMMA-co-EHA and its mechanical properties and in vitro behaviour were evaluated. The copolymers were obtained by radical polymerization and several formulations were produced by partial replacement of MMA (up to about 50%) for EHA. Overall, the results suggest that the partial replacement of MMA by EHA decreased the modulus of the materials and, consequently, increased its flexibility. Then, PMMA commercial beads were added to PMMA-co-EHA formulations (to get bone cement) and the general properties of the resulting bone cements were evaluated. In general, the results revealed that the partial replacement of MMA by EHA led to beneficial changes in curing parameters (there was a reduction of the peak temperature and an increase of curing/setting time), in the in vitro behaviour (the water capacity increased) and in the mechanical properties (the bending strength increased) of new cements. The in vitro cellular response of new formulations of PMMA-co-EHA was compared with that of traditional PMMA bone cement. To this end, we tested the cell adhesion and proliferation of osteoblast-like MG63 cells and human cells from bone marrow. The results revealed that both types of cells were able to attach and proliferate in both formulations. The only exception was observed for the formulation prepared with the highest percentage of EHA, where a few cells that adhere failed to proliferate. Moreover, it was found that increasing the amount of EHA in cement led to an increasing inhibition of cell growth, especially during the first week of culture. This was related to increased water uptake capacity by the new formulations and consequent release of some of its toxic components. Finally, PMMA commercial beads were partially replaced by HA particles and the influence of this substitution on the curing parameters, the mechanical properties and in vitro behaviour of the resulting composites was also evaluated. Incorporation of HA into the bone cements induced a number of significant changes in its final properties: 1) decrease the peak temperature; 2) increase of curing time, 3) increasing the value of elastic modulus accompanied by decrease of the strength/tension. This last finding was related to poor interfacial adhesion between the various components of the bone cements and a heterogeneous distribution (possible agglomeration) of HA particles.

Avaliação ecológica do efeito combinado de contaminantes ambientais

The assessment of ecological status of lotic freshwater bodies, based on stringent criteria of classification, has been defined by the Water Framework Directive (WFD), as a result of the implementation and optimization of methodologies that integrate physico-chemical, biological, and hydromorphological parameters. It is recognized that the application of this methodology is not easy, because it requires deep technical and scientific knowledge; it is time consuming in its application involving high financial costs. Thus, the main objective of this study was the development of cheaper and faster complementary methodologies that may contribute to the technical application of the classification criteria defined by the WFD, achieving the same final results of evaluation. In order to achieve this main goal, the river Mau, a small mountain river subjected to different stressors (eg, metals, pesticides), was established as the main sampling area. This thesis reviewed the historical development of various biotic indexes and its application in assessing water quality, especially highlighting the new paradigm defined by the WFD, and the corresponding actions developed for optimization and intercalibration of methodologies, evaluating the final state of water bodies. The ecological spatiotemporal characterization of the river Mau focused on the application of the WFD methodology, using at this stage only macroinvertebrates collected during four seasons. Results were compared with historical data of the last three years and they demonstrated that the river is in good condition. However, the ecological quality decreased at certain locations indicating that organisms were subjected to some type of disturbance. As the ecological quality can be conditioned by pulses of contamination from the sediments, in environmental adverse conditions, assays were performed with elutriates, obtained from sediments collected near the mining complex Braçal-Palhal. Results showed that this method was effective achieving the state of contamination, which may be important in prioritizing/scoring of critical areas within river ecosystems potentially impacted, using the WFD methodology. However, this methodology requires the collection of sediment which can promote the modification and / or loss of contaminants. To solve this potential problem, we developed a new methodology to obtain similar results. For this, we used a benthic microalga, belonging to the Portuguese flora, sensitive to organic pollution and metals. This methodology was optimized for application in situ, by immobilization of diatom in calcium alginate beads. The results showedthat their sensitivity and normal growth rate are similar to data obtained when used free cells of diatom. This new methodology allowed the achievement of a very quick response on the degree of contamination of a site, providing a complementary methodology to WFD.