Microstructure evolution of a 10Cr heat-resistant steel during high temperature creep

The microstructure evolution of a 10Cr ferritic/martensitic heat-resistant steel during creep at 600°C was investigated in this work. Creep tests demonstrated that the 10Cr steel had higher creep strength than conventional ASME-P92 steel at 600°C. The microstructure after creep was studied by transmission electron microscopy, scanning electron microscopy and electron probe microanalysis. It was revealed that the martensitic laths were coarsened with time and eventually developed into subgrains after 8354 h. Laves phase was observed to grow and cluster along the prior austenite grain boundaries during creep and caused the fluctuation of solution and precipitation strengthening effects, which was responsible for the two slope changes on the creep rupture strength vs rupture time curve. It was also revealed that the microstructure evolution could be accelerated by stress, which resulted in the lower hardness in the deformed part of the creep specimen, compared with the aging part.

Effect of geosynthetic reinforcement creep on the long term performance of an embankment

Geo-synthetic reinforcements are often used to enhance the stability of geotechnical structures such as embankments. These geosynthetic polymers often show significant creep deformational behaviour. In the short-term performance of a geotechnical structure, it may not play a significant role. However, while dealing with the long term behaviour, it is necessary to investigate its effect. In this paper two plane strain fully coupled finite element analysis have been conducted; one with and the other without taking into account of the creep behaviour of geosynthetics. A well documented field case of Leneghans embankment (Geogrid improved wide embankment constructed near Sydney, Australia in 1990s) have been used for this purpose. It is evident from the analyses that though the geosynthetic reinforcements may play a vital role in the performance/stability of an embankment in the early days (during and after construction), its contribution may become insignificant with time and the creep of geo-synthetic may not play a significant role in the long term stability. © 2012 American Society of Civil Engineers.

A unified view on the effect of fibers and loading on sfrc creep through linear projection to latent structures

Creep of Steel Fiber Reinforced Concrete (SFRC) under flexural loads in the cracked state and to what extent different factors determine creep behaviour are quite understudied topics within the general field of SFRC mechanical properties. A series of prismatic specimens have been produced and subjected to sustained flexural loads. The effect of a number of variables (fiber length and slenderness, fiber content, and concrete compressive strength) has been studied in a comprehensive fashion. Twelve response variables (creep parameters measured at different times) have been retained as descriptive of flexural creep behaviour. Multivariate techniques have been used: the experimental results have been projected to their latent structure by means of Principal Components Analysis (PCA), so that all the information has been reduced to a set of three latent variables. They have been related to the variables considered and statistical significance of their effects on creep behaviour has been assessed. The result is a unified view on the effects of the different variables considered upon creep behaviour: fiber content and fiber slenderness have been detected to clearly modify the effect that load ratio has on flexural creep behaviour.